Question about 2004 Mazda 6

1 Answer

Is the fan control module available separately for a 2005 mazda 3

The garage says I have to buy the whole fan assembly. That works out to 1000 bucks with labour. It seems crazy when it is just the module that is defective. Can anyone help with another source?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 599 Answers

Try wrecking yard in your area for module only..labor will be same or slightly more

Posted on Jan 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need an engine coolant blower motor control module


Doesd the fan work when the aircon is turned on?If not then the fan needs to be changed as it comes as a whole assembly including the resistor.
All you have to do is jack the car up,place chasis stands, unplug the fan wires from the bottom,push the whole frame on which the fan is mounted on and it should just pop out.
There is a ceremic resistor on the fan assembly that tends to go brittle over a time.The whole assembly from ford was $120aud.(about 2mnths ago)

Jun 28, 2012 | 2006 Ford Focus

1 Answer

My 2002 Mazda Protege Lx will buck while traveling along, not too often. I suspect the Electronic Control Module for the Transmission or possible sensors for the module. Where is the module and sensors...


Look near the driver's area under the dash for a an OBD-II port and borrow a scan tool from Autozone (they do tool rentals, cheaper than buying one). Pulling the codes will give you an idea of what is going on, you can then work from there.

http://upload.wikimedia.org/wikipedia/commons/8/85/OBD_002.jpg

Aug 01, 2011 | 2002 Mazda Protege

3 Answers

I have oil leaking from gasket or O-ring on oil cooler. Mazda says you have to buy new oil cooler = $400+. Is there a gasket or O-ring replacement available. 2007 Mazda 5 Touring.


on line, auto zone has a o ring for oil cooler at a reasonable cost. if the cooler is contaminated or corroded it needs replaced. if you need one, go online for the best deal. for it cools the oil for the engine. let them know at auto zone, and they should be able to advise you. car dealerships are a big ripoff. a fan blows air on engine oil cooler for disipation off heat. this is important to regulate the tempurature of the oil. have a very good day !!

Jan 20, 2011 | 2006 Mazda 5

1 Answer

I need to change the lights on my mazda mx5 first reg july 2005 to left hand as i now live in france?


Buy a new pair of headlights from a French Motor Factor or from your nearest Mazda dealer and just swap them over. Then go to a garage to get the headlight beams correctly adjusted. Voila!

If you want specific instructions, then you'll need diagrams which are not available online for copyright reasons, but Haynes publish the correct manual which you can either buy new or get secondhand from online suppliers like ebay and Amazon.

Sep 06, 2010 | 2005 Mazda MX-5 Miata

1 Answer

Car - interior fan control working but only on full or 1 bar


switch is bad look in salvage yard for new used arts

Jan 17, 2010 | 2005 Mazda 3

2 Answers

Broken plastic rod retainer clip


the clip comes with a new handle and are not available separate.

Jul 28, 2009 | 2005 Chevrolet Silverado

1 Answer

Mazda 3 2005


Only way to know whats going on is to have the engine light checked with a OBD II diagnostic tool, there's a data link connector under the drivers side dash that it plugs into, you can buy one at most auto parts store's, or if you don't want to buy one some auto parts store's will check the engine light with a tester at no cost, for example auto zone, or you could take it back to the mechanic to see if he can diagnose the problem. The service engine light come's on when the pcm (powertrain control module) senses a problem. good luck !

Mar 31, 2009 | 2004 Mazda 3

1 Answer

2002 mazda millinia losing coolant out the overflow tank & overhe


Martin, You should replace your fan motor. One fan is for ac and one is for normal driving without ac. Your car is getting to hot. Hope this helps, these fans are available aftermarket as a whole assembly. Check out ebay I have seen them on there I have a wholesale company I buy them through.

Dec 18, 2008 | Mazda Millenia Cars & Trucks

1 Answer

Fan problems!!!


Is there a separate control module for the fan or is it inbuilt in the fan assembly itself? Check the power to the fan, if there is power there then consider trying a new fan if not check fuse before trying to locate fan control module.

Aug 03, 2008 | 2001 BMW 330

Not finding what you are looking for?
2004 Mazda 6 Logo

Related Topics:

459 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...