Question about 1998 Chevrolet Blazer

1 Answer

4wd does not work

I have a 98 blazer with push button 4wd i will push the 4 hi or lo and the light goes on lo and hi but it does not engage

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Check vaccum actuator located on passenger fender under hood or under battery tray

Posted on Jan 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2003. Why doesn't 4wd work?


How to Diagnose and Repair Chevy Blazer and ... - YouTube

? 7:13
https://www.youtube.com/watch?v=IP0jhBG0jv4
Jun 30, 2012 - Uploaded by Mark Jenkins
How to Diagnose and Repair Chevy Blazer and GMC Jimmy 4WD\ 4x4 Issues .... The transfer case either doesn't want to engage, or it gets stuck in 4 lo. ... my s10 4x4, I watch your videos and I start to work on my truck,I start ...

How To Install Replace 4WD Front Axle Vacuum Actuator ...

? 9:02
https://www.youtube.com/watch?v=stooGR4BcjE
Mar 2, 2012 - Uploaded by 1A Auto Parts
I have a 1996 chevy blazer ls...my 4 wheel drive stoppedworking. ... 4l and I hear the click underneath me, but that's it..itdoesn't engage, but the ... I have a 2003 gmc Sonoma and when I put it into 4 high it feels like it does

Nov 19, 2015 | Chevrolet Blazer Cars & Trucks

1 Answer

Stuck in 4 wheel lo, how do i get it back to 2 wheel hi ?


On these issue, there are few solved help links for troubleshooting the issue easily.-------

Click the link below: ---

No 4x4 light on dash?

http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html

-----------

4X4 Truck makes roaring noise in the front end?

http://schematicsdiagram.blogspot.com/2012/01/4x4-truck-makes-roaring-noise-in-front.html

-------------

Car will not go into 4WD high or 4WD low?


http://schematicsdiagram.blogspot.com/2011/12/car-will-not-go-into-4wd-high-or-4wd.html

--------------

No 4x4 light on dash?

http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html

------------

4 wheel drive system will not disengage?

http://technoanswers.blogspot.com/2012/01/4-wheel-drive-system-will-not-disengage.html

----------

4WD light is flashing and beeping? NO 4WD high?

http://schematicsdiagram.blogspot.in/2012/02/4wd-light-is-flashing-and-beeping-no.html

----------

2002 Jeep Wrangler: 4WD Idiot Light is ON?

http://technoanswers.blogspot.in/2012/06/2002-jeep-wrangler-4wd-idiot-light-is.html

----------

Traction control switch will not engage on 4WD High or Low

http://whoisbyme.blogspot.com/2012/10/traction-control-switch-will-not-engage.html

-----------

4WD light flashing and 4WD will engage after few minutes

http://repairhelpcenter.blogspot.com/2012/10/4wd-light-flashing-and-4wd-will-engage.html

------------

2008 Toyota Tundra: 4x4 Wheel Drive Light is Flashing?

http://technoanswers.blogspot.in/2012/05/2008-toyota-tundra-4x4-wheel-drive.html

----------

4x4 front differential will not engage the axle on ford?

http://technoanswers.blogspot.in/2012/02/4x4-front-differential-will-not-engage.html

-------

4x4 will not engage on Ford F150?

http://technoanswers.blogspot.in/2012/02/4x4-will-not-engage-on-ford-f150.html

-------------

Dodge Ram 4x4 light keeps flashing

4X4 LOW LIGHT IS FLASHING ON DASH

http://technoanswers.blogspot.in/2012/09/dodge-ram-4x4-light-keeps-flashing.html

----------

Ford 4x4 front wheels will not engage?

http://technoanswers.blogspot.in/2012/02/ford-4x4-front-wheels-will-not-engage.html

-------------

These details will help.

Thanks.

Dec 09, 2012 | 1999 Chevrolet Blazer

1 Answer

I recently purchased a 1999 Chevy Blazer 4WD LT with the 4WD AUTO 4 switch push button. We picked it up cheap. We now know why... 4WD dash switch is dead, changed it with a used one lights flash and n


Sounds like the encoder switch is bad ..it on the transfer case .it has a motor with wires going to it.when you press the button it sends a signal to that motor to switch into a certain gear..

Apr 21, 2012 | Cars & Trucks

2 Answers

I have a 1996 chevy blazer and dont know how to disengage from four wheel drive to two wheel drive?


As I recall the 96 blazer had electronic shifting for 2wd to 4wd. There should be a small panel on the drivers dash buttons for 2wd, 4wd lo and 4wd hi.

Simply press the desired button while stationary and if the system is functioning properly then it will shift and the light for the engaged type of drive will be lighted. Generally you would like to be in 2wd for this vehicle.

Mar 10, 2010 | 1996 Chevrolet Blazer

1 Answer

2003 blazer will not come out of 4 lo, auto will flash when pressed and then go out


Check the fuse to your 4wd at the fuse panel at the end of the dash drivers side. If the fuse is good, put the transmission in neutral and listen for the Transfer case encoder motor to work when you push the button on the dash for 4wd hi then to 2wd. If you do not hear it working, inspect the wire harness at the Encoder motor to make sure there not damaged in anyway due to corrosion or disconnected.
Here's some info on how the 4wd system operates on newer Blazers for all those searching for the cause of the flashing dash switch light and no engagement.

4WD System Operation on 98 up (2nd Generation) Blazers/Jimmies

The front drive shaft always turns on “shift on the fly” systems so the drive train is at the same speed in the front as the rear or the whole thing would break when engaging 4Hi or Autotrac when moving. InstaTrac (NV243 case or NP1) has 3 buttons. AutoTrac (NV246 case or NP8) has 4 buttons and clutch packs in the transfer case and is the only system for on pavement driving! Prior were the NV231 (87-93) lever and NP233 (94-97) electric motor. Your VIN # is the only sure way the dealer can get correct parts/listings!
1. Select mode on dash switch
2. Signal goes to the Transfer case control module (TCCM) or computer located in the cab on the passenger side behind the kick panel.
3. If you want 4 Lo the TCCM commands the encoder motor on the transfer case to switch a lower gear in (requires putting the shifter in Neutral and be stopped or only going 2-3mph). Note that if 4 Hi selected no action done in the transfer case. The transfer case is chain coupled and has the low and high gear. You can put all systems into Neutral by pushing the 2Hi and 4Lo button at the same time when the key is in the run position (or running but not off or acc).
4. The left front (drivers side) CV axle is always engaged to the front differential, but the right side is not coupled in 2wd. There is an actuator located under the battery tray that when commanded is vacuum actuated and pulls a cable from it to the right side CV axle coupler engaging that axle. A sensor is on that axle that tells the TCCM the axle position.
5. On 99up there is an additional vacuum switch on the firewall that switches the vacuum on and signals the TCCM also.
6. The dash light on the selector switch flashes while all this is occurring and will not switch out of 2wd unless all parts report correctly – same on the switch to any mode or back to 2wd.

So, there are a lot of possible failure areas with actuators/computer/motor/sensors/vac hoses and a special scanner is required to read the codes when the Service 4WD light comes on. But, a few things can easily be done before going to the dealer.
1. Check all vacuum hoses from the intake to the drivers side reservoir can, then to the extra switch (99up) and down to the under battery actuator. Small hose is 5/32 and larger is 7/32”.
2. See if the actuator pulls the front axle cable to engage it. If not and all hoses are good the diaphragm may be leaking on the actuator. If it engages but the light is still flashing remove the indicator switch on the front axle (only electrical plug in there) and manually push it in with the connector plugged in and see if the light stops, if so replace.
3. Listen to the encoder motor clunk when 4 Lo selected. If not working look at the wiring going to it for any cuts/breaks and repair if any found. Another indicator switch on top of this case. The fluid in the AutoTrac case should be the newer light blue Autotrak –II synthetic P/N 12378508 ($7 qt) not the red Dexron III.
4. If the light keeps flashing after this then disconnect the battery for 30 minutes for a TCCM reset, just make sure you turn off your radio first.
5. Still not working – take it to the dealer and stop at the bank on the way for $$$$!

12577412 is the part number for the Transfer Case Control Module (TCCM), or you can do the Salvage Yard for $15.00 if that's the part that has gone bad.

Jan 22, 2010 | 2003 Chevrolet Blazer

1 Answer

How to shift in and out of 4 wheel drive with a push button system on a 93 s10 blazer


this sytem is shift on the fly!! you can engage and disengage from 2wd to 4wd at speeds up to 45-50mph, 4wd lo you need to be a complete stop some cars need to be in neutral with parking brake on and some need to be in gear there all different, consult your owner manual for correct shifting pattern to 4wd lo range

Sep 26, 2009 | 1993 Chevrolet S-10 Blazer

3 Answers

My truck is stuck in 4 lo


pull atc 25 amp fuse in underhood fuse center and 10 amp 4wd fuse inside cars fuse box,your problem is in control box behind kick panel on pass. side ,corrosion build up,

Mar 06, 2009 | 2000 Chevrolet Blazer

1 Answer

98 K1500 suburban, can not engage 4wd, HI or Lo runs otherwise


your doing it right but your accuater is bad 59.00 auto zone easy install

Feb 23, 2009 | 1998 Chevrolet Suburban

1 Answer

4wd does not engage in hi, in 4wd low the light blinks, still no


Hi...
I own a 98 blazer. There's a module that has failed in the 4WD part of the truck . I had to have mine replaced at about 70,000 miles

Jan 12, 2009 | 1999 Chevrolet Blazer

4 Answers

My 98 chevy blazer won't shift into 4wd.


Had the same problem, disconnected the battery for about fifteen minutes, reconnected, 4 wheel drive hi and lo work like a charm now.

Dec 14, 2008 | 1998 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...