Question about 1999 Ford Expedition

1 Answer

Wheel on 1999 Ford Expedition locking up in reverse

This is the rear drivers side wheel. The others are not effected. Can drive forward just fine.
Started to back out of driveway, vehicle lugged a bit (felt as if E Brake was on) continued to back out and it lock up suddenly. Pulled forward and attempted to back out again, wouldn't move at all in reverse. Checked fluids and fuses, all are fine. Any suggestions as to what could be causing this?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 740 Answers

Bad Differential or LR- brake caliper is locking up very bad. I am leaning more towards bad differential-(rear end) Take off differential cover and look inside gear may be broken. Contact if you need more help. thanks for using FIX YA

Posted on Jan 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2005 ram 1500 4x4.when i put it four wheel drive high it feels like its in low and back tire on driver side skids


There's something seriously wrong in the transfer case or controls. It seems the rear driveshaft is locked up, and the front wheels are driving. The driver's side rear tire is skidding because it's trying to turn backward - rear passenger rear tire is going forward and rear differential has no option but to turn the driver tire in reverse (driveshaft locked). DON'T TRY TO DRIVE IT. Get it checked out and fixed.

Oct 25, 2016 | Cars & Trucks

1 Answer

How do i find the location neutral switch on a 1999 Ford expedition eddie bauer 5.5 liter 2 wheel drive


It's on the side of the transmission under the drivers door. The shift cable runs to the control arm it is under.

Aug 28, 2014 | 1999 Ford Expedition

2 Answers

1999 FORD EXPERDITION TRANSMISSION WON'T MOVE FORWARD BUT MY REVERSE WORKS FINE WHAT I NEED TO DO


You can try shifting into manual 1 to get moving then once you get going shift the lever up into Drive. This should work, then drive it to a shop to have your ****** looked at.

Feb 08, 2012 | 1999 Ford Expedition

1 Answer

99 expedition 4x4 drives in reverse fine. but forward only at 3000 rpms it moves slowly


Make sure your fluid level is good..If so your transmission filter may need changing

Sep 05, 2011 | 1999 Ford Expedition

1 Answer

Last week my drive shaft broke on my99 expedition 5.4 with4x4 so I replaced it then my rear end started lockin up so I replaced it now my reear wheels roll then lock up,roll then lock up, any ideas?


u need to raise the wheels off the ground an disconnect the drive shaft an spin the wheels by hand u may have a bad posi unit. the stress of breaking the shaft may have caused this

Jul 12, 2011 | 1999 Ford Expedition

1 Answer

1999 olds 88 rear wheel locked


Sounds more like brakes, Possible springs or wheel cylinder.

Jan 30, 2010 | 1999 Oldsmobile 88

1 Answer

Having problem replacing the driver side head light bulb.


Look for stainless steel clips above the lamp assembly in the support frame around the radiator and grill. Lift these clips straight up to allow the lamp to tilt forward letting you reach behind it to un-clip the pigtail and turn the retainer ring counter clockwise. Pull the bulb straight out the rear of the lamp assembly, keep bare fingers and dirt off the new bulb glass and reverse the order of dis-assembly.

Jul 02, 2009 | 1999 Ford Expedition

1 Answer

1999 Ford Taurus will not shift out of 1st - I do have reverse


Unplug your speed sensor. (located on top on transmission on left hand side can be reached from right side) If the problem is the same replace the sensor this should fix your problem.

May 14, 2009 | 1999 Ford Taurus

2 Answers

Rear drivers wheel locks up in drive is o.k. in reverse


If no oil on the driver side, you have a locked up parking brake pivot. Follow the park brake cable to the inside plate of the rear wheels. on the outside, where the cable connects, look to see the position of the visible mechanism connected to the cable. It probably will not match the side that is not locked up. This is a very common problem; you need to replace the park brake pivot. Additionally, you are going to need to remove the other side axle shaft and get the leaking oil seal replaced. Replace the brake shoes if they have oil on them.

Dec 29, 2008 | 1997 Toyota 4Runner

Not finding what you are looking for?
1999 Ford Expedition Logo

330 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...