Question about 2006 Saturn Vue

1 Answer

1995 Nissan Quest, Oil pan damage, Car stuck idling....

I bottomed out on a curb I didn't see, oil was leaking, I was able to drive home, but now I want to drive the car to the shop and I can't! I filled it up with oil, still no luck... the engine turns over and starts just fine, but when I put it into gear to back out, it doesn't work, neither does drive....

I just don't know what to do, I don't need a permenant solution, I would just like to be able to drive my van to the shop!

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 599 Answers

Check for further damage to linkage to transmission and its cooler lines...if in doubt...hire a tow truck..the damage you may cause by driving may considerably increase your repair bill....good luck

Posted on Jan 13, 2009


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 88 Answers

SOURCE: gas fumes come into my nissan quest van

notorious fuel injector problems. should have a recall for you.

Posted on Dec 23, 2008

  • 362 Answers

SOURCE: changing water pump on 1994 nissan quest

There is no easy way, water pumps are hard to change on this vehicle. Before starting the job I would buy a repair manual with step by step instructions. To give you some idea on how long it may take, the labor time is 4.5 hours for an experienced tech.

Posted on Jan 28, 2009

  • 4369 Answers

SOURCE: Im looking for a sliding door handle for a 2000 nissan quest van.

ebay has them all the time also, go here for help on Quests

Posted on Jun 08, 2009

  • 1071 Answers

SOURCE: I have a Nissan Quest 1997 and don,t start I check

the distributor is bad

Posted on Jul 21, 2009

  • 2 Answers

SOURCE: 2004 Nissan Quest Mini van
i bought mine there

Posted on Jan 04, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I hit a curb i lost no oil but oil pressure gauge remains low car starting to tap car wont run long

You could have damaged the oil pump or the pickup screen in the oil pan.
Was the oil pan damaged ?

Sep 22, 2012 | Ford Crown Victoria Cars & Trucks

1 Answer

My 2001alero has been leaking oil. I was driving down the road and it didn't have any power. Ipushed the gas pedal to the floor and the car didn't Rev up at all and it acted like it wanted to shut...

Click this link below for oil leak and rev issues:-----
For oil leak problem,click the link below.This are direct hel links to troubleshoot the problem :-----
Common Causes of Car Oil Leaks?
Troubleshoot Car Oil leak?
leaking oil from oil pan?
Car Turns OFF due to low oil pressure warning light?
leaking oil from timing cover?
How to Check Differential Oil Leaks and Replace Oil
Car oil leak?

Car oil leaks from valve cover gasket?
Oil leaks from air filter ?
Rear oil seal leaking?
This will help.

Feb 13, 2012 | 2001 Oldsmobile Alero

1 Answer

Car jerks when you shift gears

If that oil is transmission fluid, you may be low on fluid. That would cause harsh shifts. Make sure your transmission is full.
Is it just reverse and drive that ****? Do second and third shift smooth? If so, you may have a too-high idle.
If idle is good, and your transmission didn't get low on fluid, then I would suggest you drain and refill the transmission, and install a new transmission filter while you have the bottom pan off. Usually, you can buy a filter and pan gasket as a kit.

Nov 17, 2011 | Mitsubishi Cars & Trucks

1 Answer

Oldsmobile aurora where is the oil sending unit.My daughter hit a curb with her car and now the the oil light is on and the on board computer say that she has low oil pressure .It is a 1999 V8 4.0 L ....

It should be on the left side of the engine(front of car) wiring runs under and around oil pan maybe wires are torn or pulled out of connector.oil sending unit is usually right in the same area of oil filter.

Nov 15, 2009 | 1995 Oldsmobile Aurora

1 Answer

I have a pretty severe leak from my oil pan. Is

Copied from "EHow" by By Zibahrose Step 1 Purchase the gasket kit and quarts of oil from the local auto parts store. The customer service rep at the store can help you purchase the correct amount of oil and the right gasket kit for your vehicle.
  • Step 2jack_thumb.jpg Safely jack up the vehicle and place jack stands to support the vehicle. Lower the jack to rest the car on the jack stands before working on the vehicle. .......OR drive the car onto a curb on one side only to give you some working room under the car.
  • Step 3 Make sure the leak is coming from the oil pan gasket. There are at other sources of oil ... The oil filter, the oil pan screws and the oil plug. You may want to snug each of these just a bit - then wipe the wet oil area - then run the engine a bit just to be sure!!
  • Step 4 Once you are certain that the oil pan gasket is the problem, drain the oil from the oil pan and store it in the container until it can be properly disposed of.
  • Step 5
  • Remove the oil pan from the bottom of the engine. Remove the old gasket. (Make sure it is disposed of properly.)
  • Step 6 Make sure the edge of the oil pan is clean. Check for any debris left by previous gaskets or gasket sealant. If there is any, use the wire brush to clean it off. You may use WD40 to clean the oil pan and the place where the gasket will go on the oil pan. Wipe it dry paper towels.
  • Step 7 Make sure replacement gasket is the same shape as the top of the oil pan. Some people use a sealant type of gasket when they cannot purchase a rubber or cork gasket. I recommend either cork or rubber because a sealant tends to be messy and does not always adhere or cure properly. Put some clear silicone on the engine. Place the gasket against the silicome and then carefully place the oil pan against the gasket. Loosely insert a few of the oil pan bolts and check to ensure that the gasket has not moved.
  • Step 8 Tighten the screws to the torque indicated in the Haynes manual.
  • Step 9 Lower the car by reversing the proceedure used to elevate it.
  • Step 10motoroilbtl_thumb.jpg Fill engine with oil according to the vehicle specifications. Do not over fill.
  • Step 11 Crank the vehicle and allow to idle. Check for leaks.
  • Oct 05, 2009 | 2001 Ford Taurus

    1 Answer

    1995 nissan quest minivan gxe v6 - noise under the hood

    low or no oil pressure... check the level of the oil .. add if necessary and have the oil pressure checked


    Jan 26, 2009 | 1995 Nissan Quest

    1 Answer

    I am seeing small puddles of oil under our 96 nissan quest?

    you can take it to any auto repair place.Like sears pep boys or a local repair shop. some times you can get away with a few turns on the bolts holding the pan up

    Jan 19, 2009 | 1993 Nissan Quest

    Not finding what you are looking for?
    2006 Saturn Vue Logo

    114 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Saturn Experts


    Level 3 Expert

    78267 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers

    Jeffrey Turcotte
    Jeffrey Turcotte

    Level 3 Expert

    8836 Answers

    Are you a Saturn Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides