Question about Cars & Trucks

1 Answer

How much from !00% of cooling antifreezing can be removed from circuit

Posted by on

Ad

1 Answer

About 70%

Posted on Dec 12, 2012

  • 3 more comments 
  • Valentin Popa Dec 12, 2012

    thank`s a lot,so 60%freezing and 40% water will compensate the 30%

  • Anonymous Dec 12, 2012

    You add to the system 50/50 or 60/40 using distilled water from the supermarket & the correct coolant for your car

  • Anonymous Dec 12, 2012

    Doesn't matter how much is left in the system when you drain it

  • Valentin Popa Dec 12, 2012

    I see,thanks again Peter,have a good day.

  • Anonymous Dec 12, 2012

    Welcome

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to install thermostat


Most all thermostats are located at the end of the top hose
from the radiator to the engine. Usually only two bolts hold the thermostat housing to the engine. Some antifreeze will
need to be drained to access the thermostat. Do this when the engine coolant is cool. A new thermostat and gasket will be required. Simply remove the hose from the housing
and the bolts out of the housing. remove the thermostat and old gasket. Making sure the mounting surface is clean
before reversing the procedure and refilling the 50/50 mix
of antifreeze. You can check the operation of the new thermostat by placing it in a pan of water that is gradually heated and watch the thermostat open at the desired temperature.

Feb 06, 2018 | Cars & Trucks

1 Answer

Heat stop working on 2010 GMC Terrain.I changed the Thermostat it worked for couple of days than it stop working than I saw it needed more antifreeze because it was low.


you have a air lock...Start the car with the radiator cap off. One of the easiest ways to bleed your car's radiator is to simply remove the radiator cap and then start your engine. Leave the vehicle running until it reaches its normal operating temperature. It may take between 15 or 20 minutes before your car generates enough heat to push out the air that has been trapped in your car's cooling system. You may find that you need to add additional coolant, as air pockets can artificially inflate coolant levels.
hope this helps

Jan 04, 2018 | GMC Cars & Trucks

1 Answer

00 mitsubishi have antifreeze smell inside while driveing


That would be a leaking heater core.It will need to be replaced.

Feb 13, 2013 | 2000 Mitsubishi Diamante

1 Answer

Heat is not hot at all, have flushed cooling system replaced thermostat replaced heater core and blower motor , but not as hot as it should be


check the density of the coolant. Might not have enough pure antifreeze in it. If you recently changed antifreeze, you should have replace with one gallon pure 100% antifreeze and filled remainder with 50/50 mixture. Did you burp the system after you changed all that stuff. Air in line will cause a vapor locj and will not heat well. !00% antifreeze is bad for your system. Last, you may have headgasket problems.

Jan 23, 2013 | Cars & Trucks

1 Answer

Engine Diagram 2007 kia sportage


With conventional cooling system, the upper radiator hose goes to thermostat housing on the engine. You drain antifreeze down, a little, remove radiator hose from thermostat housing, remove thermostat housing, the thermostat should be inside the housing.
Some antifreeze is poisonous, dispose of properly.
Install new thermostat, hook everything back up. Add proper amount of antifreeze to the proper mark. Keep an eye on antifreeze level for a while till your sure all air worked out of the system.

Nov 04, 2011 | 2007 Kia Sportage 4x4 V6

1 Answer

I have a 00 Chrysler 300m and something brown is leaking and it overheated any idea what it is?


It sounds like really dirty antifreeze, check that and if it's so flush the cooling system, refill with new coolant and change the thermostadt. Hope this helps-Jim

May 13, 2011 | Chrysler 300M Cars & Trucks

1 Answer

Over heating


Try checking your antifreeze levels. If you antifreeze tank is low try filling it to the "Fill" or "Full" level. If your antifreeze tank is empty, remove your radiator cap, (make sure the engine has cooled off. If you try to open it while it's hot, you could get sprayed with hot antifreeze) and fill the radiator slowly. Then refill your antifreeze tank. Remember to always mix the antifreeze with water (50/50 mix) for full protection.

Mar 05, 2011 | 1998 Pontiac Bonneville

1 Answer

Best way to change coolant in 2003 sierra


With engine cold, remove radiator cap. At bottom of radiator on left side (as you stand in fronof truck), there is a plastic drain plug that screws into the radiator. This plug does not look like a bottle cap, rather it looks like a large, raised tab. Turn counterclockwise to remove. Have a large pan under the truck at this location, or have the truck parked on the grass. Allow to drain completely. Dispose of the old antifreeze and do let children or pets drink it; it is deadly poison. If you want to do this right, replace the plug, refill the radiator with water only, replace the radiator cap, start engine and let run until opwerating temperature is reached (about 20 minutes), then turn engine off, let cool completely, and repeat the drain procedure. This will more thoroughly remove the old antifreeze from the system. Now refill the radiator with the proper mixture of new antifreeze and water, run engine to proper operating temperature. turn off engine and let cool completely. Add additional water and antifreeze into the coolant overflow bottle if necessary. After changing antifreeze, you may need to add more again after couple of days.

Feb 26, 2010 | 2003 GMC Sierra 1500

1 Answer

Expansion tank on 00 e46 328i


It is common to have issues with the tank its very simple to replace.Just remove the screws and or clips the hold it in place and loosen the hose clamps.We always fill the upper radiator hose with antifreeze before installation to insure proper level,and reduce the amount of air in the cooling system.

Dec 29, 2009 | 2000 BMW 3 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15190 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...