Question about 1999 BMW 328 Series

1 Answer

Drivers side reverse light on while i drive.

Reverse light stays goes on as soon i put on the headlights.i dont know if i blew a fuse or what i need some help with this. also my rightside blinker stays on inside my car as soon as put the headlights on..what should i do?

Posted by on

  • 4 more comments 
  • davidg711 Jan 13, 2009

    ok so do u know what the problem is?

  • davidg711 Jan 13, 2009

    ya both lights go on..its just when i put the head lights on the drivers side reverse light stays on while i drivee..but only when i put the headlights on when i drive during the day it is ok the light is not oon

  • davidg711 Jan 13, 2009

    no no that is not the problem i know how to turn my fog lights on..my reverse light does not come off when i put the headlights on only. fog lights are in front of my car.

  • yadayada
    yadayada May 11, 2010

    u need a wiring diagram, suggest u buy a used factory manual on ebay motors.

  • yadayada
    yadayada May 11, 2010

    A few more quick questions, do both rev lights come on when u put the car in rev?

  • yadayada
    yadayada May 11, 2010

    blown fuses only turn thing's off not on.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

Your car has rear fog lights. The rear light that you see come on with your headlights is your rear fog light. The light in your dash is the rear fog light indicator. To turn off your rear fog lghts push your headlight switch in half way. To turn off your front fog lights push in all of the way.

Posted on Jan 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My headlight on the drivers side won't stay on. I put new bulbs in. Soon as I put protector cap back on , the light goes out. The bulb is tight & put in correctly.


you may have a broken wire to plug pin, replace light socket assembly, parts store should have replacement units all it takes is cutting out the old socket and bud splicing or soldering the new one in

Oct 03, 2014 | 2003 Saturn ION

1 Answer

Blew 20 amp fuse for tail lights and dash under hood while towing trailer replaced but still not working and head lights stay on


sounds likely to be a relay blown so is giving constant supply to headlights and affecting rest of lighting system not sure of location on this vehicle but a google search will tell you if you dont have workshop manual

Mar 25, 2014 | 2005 Ford F-150 SuperCab

1 Answer

1993 Dodge B250 Ram Van (Conversion) -- I have no rear running lights. The brake lights, turn signal lights and hazards all work fine. While driving through rain, I hit a big puddle. Some time later...


something in the wire setup has gottn wet and caused it to short out . i would recomend ordering a new wiring harness for the engine compartment. and when re connection everything use di eletcritc grease in them so they will not do it again.

Oct 07, 2013 | Cars & Trucks

1 Answer

Reverse light fuse is continually blowing 1999 mitsubishi galant


The speed sensor is probably the root of your problems. Likely the reverse switch wiring is routed through the harness for the sensor. That could also be the reason it goes into limp mode. Change the sensor and see if all problems are resolved. Good luck.

Jul 24, 2013 | 1999 Mitsubishi Galant

1 Answer

Drivers side headlight has no current


each head light has a seperate fuse should be mounted under hood in fuse n relay box

Apr 04, 2010 | 2006 Nissan Altima

2 Answers

Headlights dont work everything else dose


put your e- brake down when its pulled up even a little the lights go out to save the battery while the key is on during diagnostics

Aug 26, 2009 | 1997 Volkswagen Jetta

1 Answer

1996 ford probe passenger electric window no longer works.


you blew the fuse for your radio.you cannot put a hot wire to a ground that is why the fuse blew.you could have broken a wire connector for the door,windows etc.the headlight switch wire harness is probably melted this happens a lot on Ford products,the head light draw so much heat they melt the wire harness plug that goes on the back of the headlight switch.

Jul 25, 2009 | 1996 Ford Probe

1 Answer

2002 Highlander headlight keeps blowing fuse


In the Fuse Relay Box under the Hood there is a Headlight Relay. Replace this Relay along with a New Fuse and it should work. Let me Know. Please Rate my Response, I need all the Help That I can Get! Thanks!

Jan 28, 2009 | 2002 Toyota Highlander

1 Answer

Blowing fuse


hi take the fuse out replace with a temparary test light turn your headlights on if there is a short the light will light up so what you need to do now is disconnect the headlights one at a time until test light goes out when testlight goes out you know this is the faulty headlight if the test light stays on disconnect lightswitch connecter see if testlight goes out if so replace switch if it stays on find headlight relay remove it see if test light stays on if it does then there is a short in the wiring which is very rare yates210456

Sep 09, 2008 | 1992 Geo Metro

Not finding what you are looking for?
1999 BMW 328 Series Logo

397 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Fred Sops

Level 2 Expert

271 Answers

Al Clark

Level 2 Expert

290 Answers

Doberman

Level 2 Expert

246 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...