Question about 2000 Chrysler Cirrus

1 Answer

How to change speed sensor for cirrus 2000 - 2000 Chrysler Cirrus

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 82 Answers

There should be 2 on the drivers side of the transmission. An input speed sensor 4800878 $21.95 and an output speed sensor 4800879 $21.95. These are easy to replace. First locate the 2 which should have a wiring harness attached to them, Second unhook the wires, Third unscrew them out individually as to not get them confused because they are different in shape just barely. Fourth screw in the new ones,Fifth replace the wires and you should be done.

Posted on Jan 13, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 cirrus want change gears goes in drive and reverse inside on the dash where it tells you what gear you in all has squares around them speedometer doesn't work

Sounds like a speed sensor, I will look into that, but if the speedometer isn't working, its either cable, or electronic. Being a 2000, I'm guessing electronic. Chrysler have a lot of electronics on the transmission, as they are electronic themselves. I had an alternator go bad and my battery died, and the car wouldn't shift, it actually down shifted while driving. Have your battery and alternator checked first, then sensors. Like shift silinoid, speed sensor etc.

Apr 04, 2015 | 2000 Chrysler Cirrus

1 Answer

What does a shaft speed sencer do for a 2000 cirrus

According to, "Symptom: The car won't shift out of 1st gear. The 'Check Engine' light is on.

The speedometer doesn't work for this one. You're only able to go about 30 MPH without going above 4000 RPM.

Likely Cause #1: The Output Shaft Speed Sensor went bad.
Likely Solution #1: Replace the sensor (Part #4800879)."

The good news is that they are relatively cheap if you can install them yourself.

Apr 03, 2015 | 2000 Chrysler Cirrus

1 Answer

Codes 700,720,731 car will not shift up,but it will back up

Could be a as simple as a speed sensor, I would remove the pan and inspect. If no metal or obvious problem exists, I would replace the input speed sensor and/or the vehicle speed sensor

Oct 17, 2013 | 2000 Chrysler Cirrus

2 Answers

So i got a 2000 chrysler cirrus and today the speedo stop working followed by the check engine light coming on what should i look for

Take it to parts store and get trouble code. I think a sensor went out in the transmission. Doest sound bad but should hook up to diagnostic took soon to make sure

Oct 05, 2010 | 2000 Chrysler Cirrus

1 Answer

2000 chrysler cirrus wont shift

it is going into limp mode. You need to take it to a trans shop to have diagnostic

Jul 06, 2009 | 2000 Chrysler Cirrus

2 Answers

1999 chrysler cirrus not shifting out of 1st gear

Speedometer sensor is usually in the cars computer. Sounds like it's electrical though. Could be a sensor part of the alternator. Call Advanced or auto zone. Some places can test stuff like that for free.

Jun 18, 2009 | 1995 Chrysler Cirrus

2 Answers

How do I change the three speed sensors on the transmission

go to pep boys and by the book for your car! it will tell you everything and anything that you can possibley think of

May 14, 2009 | 1995 Chrysler Cirrus

1 Answer

Crankshaft position sensor dying every 400 miles

P0700 Transmission Control System Malfunction

P0725 Engine Speed input Circuit Malfunction fixing those will keep the cranksensor from repeatedly going out on you should solve the problem. if you feel this information was helpful please rate it

Apr 20, 2009 | 2000 Chrysler Cirrus

4 Answers

Transmission chrysler 2000 2.4 liter

Change the trans.fluid and at the same time check the lenkage.

Jul 26, 2008 | 2000 Chrysler Cirrus

Not finding what you are looking for?
2000 Chrysler Cirrus Logo

404 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides