Question about 2006 Chevrolet Cobalt
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
i have a 2006 chevy uplander and i need to change the low beam headlamp how do i do it, also about a month after we had got the van the rear wiper stopped working i haven't checked the fuse yet, but is this a common problem for the uplander, and also the abs light stays on what should i do for that problem, and also when we drive it and then shut it off it does not want to turn on right away.
Posted on May 04, 2010
SOURCE: Rear Windshield Wiper Problems
Check the wiper motor connection if its touching anything and loose it will automatically ground out and check at connection make sure you put some gel and then snap it in/ Please rate my response thank you very much
Posted on Jan 31, 2009
SOURCE: chevy cavalier 1997 wiper motor
It could be a fuse problem. The fuse box is located on the left side of the dash. It can be found with the door open and looking at the end of the dash. There is a small cover that when removed has a chart of what all the fuses go too. If the fuses proves to be good, the motor can be found under the hood (sort of).
To get to the wiper motor you will need to remove the wiper arms and then you will need to remove the black vent cover to get at it. It is only held in by five black panel clips. Once you have removed the clips and removed the wiper arms and the washer lines, lift up the cover and slide it out. Note: it comes out much easier than it goes back in. With the cover off, the wiper motor will be visible on the drives side of the car. Remove three screws (10 mm) and th entire assembly comes out. flip it over to see and depress the clip that holds the wiring on. You should be able to take it out and put it back in about 30 minutes. Try to do it on a warm day so that when you are reassembling it, you do not tear up the rubber seal around the windshield. I got the entire unit from my local junk yard for 30 bucks.
One more thing to consider as a possible problem is the wiper joystick in the car.
Hopefully it is only your fuse.
Posted on Jan 25, 2009
Well sure enough all I had to do was replace the circuit board...wish I had done this a couple months ago...it was so easy to do and will now be much easier to drive with being able to see clearly again....
Posted on Jan 08, 2009
SOURCE: changing wiper motor in chev s10
It's not bad. They make a special tool to remove the motor from the arm assembly, but with a little determination I was able to remove it with out the tool. If your wipers aren't working try running power to the motor first to test it. I swapped it out and the problem ended up being a bad ground in the switch. I bypassed that for a little while by running a jumper wire from the engine block to motor. It also could be the pulse module they are known for going bad in GM vehicles.
Posted on Jan 21, 2009
Tips for a great answer:
Dec 06, 2015 | Evan Cars & Trucks
Apr 05, 2013 | 2005 Seat Altea 1.9
Nov 27, 2012 | Oldsmobile Intrigue Cars & Trucks
Oct 12, 2010 | 2001 Ford Windstar
Oct 04, 2010 | 2002 Toyota Avalon
Sep 26, 2010 | 2002 Buick Rendezvous
Mar 03, 2010 | 2002 Chevrolet TrailBlazer
Feb 06, 2010 | 2004 Nissan Murano
Jan 16, 2010 | 2000 Toyota Avalon
465 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: