Curb side window will not work

Go to ford owners.Com and register for free then download your owners manual and go to roadside emergencies and your fuse box diagrams and values are there and you can download it to your phone or computer and print it out when you need it ok

depends if it is an power window as it could be a bad fuse, relay, switch, connection, wire broken or the power window motor. each needs to be checked out. if its a manual window it could be the window regulator that is bad. so as you can see it can be both expensive and not expensive. won`t know until the problem is found.

the window motor is probley going out . you might check to see if the rubber that wipes the window is hard.

curbside bad switch., bad motor or broken regulator check for power to motor first.

The master switch connector does have circuits that have power on them. The Master switch is not directly connected to the window motors. The switch sends a signal to the Front Electronic Module and the module controls operation of the motor on the driver side. The passenger door window motor is controlled by a different module

You also have Circuit Breakers for your windows, Or your Master Switch ,You can Test the Driver Control Switch or the rear switches by removing the Switches and using the connector Plug and a Jump wire try jumping accross the wires,if they go up or down you could have a Bad Switch,if nothing moves more than likely your Window Motor is bad. BUT first CHECK your Circuit Breakers ,It could be Labeled as accessery Relay or circuit Breaker.

This sounds like a stuck switch,try to unplug the switch (drivers side window) first and it should cure your problem.Let me know if this does it,,if not i will help you solve this issue

HI there your problem is the motor . each window has it's sprat
motor . to be shore check the switch by remove it from console .
and with a test light
find the wires cumming out of the switch for driver side door window
see if you have power . you should have power on one wire all
the time with ignition switch in the on bastion .if you have power
as you operate the window switch .put the window is still not going
up or down you need window motor.

good luck re post if you need more help OK

Well this is the reason why tow truck drivers are supposed to open a vehicle from the passenger side. Because sometimes when you put a tool in the door you might snag a wire and pull it loose from the connection. If this happened on the drivers side it would make it a lot more difficult to get in and out of your vehicle.
Now if the company that did this is local take it back to them and they will take off the door panel and fix the issue. If this was done under a roadside assistance policy and you have difficulties with the tow company then just get hold of your roadside assistance company and handle it through customer assistance.
they hold the company's purse string and it will get taken care of.
Hope you find this helpful.
Hopefully this happened recently because nobody like to have someone come back a year after it happened asking for something to be fixed.

maybe its the bearings did you check them......?