Question about 1998 Jeep Cherokee

Open Question

Windshield washer pump 1998 Jeep Cherokee - 1998 Jeep Cherokee

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
brainyass
  • 242 Answers

SOURCE: 97 Jeep Cherokee Sport Windshield Washer Pump Replacement

Remove the windshield wipers. Pull away from windshield until and use a screwdriver to pry clip on bottom of wiper arm and remove entire arm from mount. Now remove shroud that is under wiper arms you just replaced. After you move the shroud, you should be able to get at the pump.

Posted on Oct 27, 2008

Ad
picatudo
  • 239 Answers

SOURCE: 1999 windshield washer pump relay

there is no relay is the same fuse for the wipers

Posted on Jan 14, 2009

1fastbob
  • 301 Answers

SOURCE: 2001 jeep cherokee windshield washer pump not

Can you hear the washer pump run when it is activated? If so check for a split small hose at the washer reservoir. You may need to repalce the pump. It is in the bottom for the washer fluid reservoir.

Posted on Sep 24, 2009

Mike258
  • 1498 Answers

SOURCE: 1998 Jeep Cheroke(4 door): front windshield washer

Hi Ins,

No need to take apart the reservoir just yet. You'll see two pumps attached to the reservoir, one front, one rear.

Just switch the plugs. Then try the rear washer switch, it should spray up front. That will tell you if the pump is bad or not.

The fuses for the wipers and the pumps are under the drivers dash, left kick panel.

Best regards,
Mike

Posted on Dec 19, 2009

  • 1757 Answers

SOURCE: need firing order for 1998 Jeep Cherokee gand

For the 1998 Jeep Grand Cherokee Laredo:
I do not know if you have the 4.0L In-Line 6-Cylinder, the 5.2L V8, or the 5.9L V8; however I have included ALL below:

For the 4.0L In-Line 6-Cylinder:
Firing Order:
1-5-3-6-2-4
Cylinders:
(back)
...6
...5
...4
...3
...2
...1
(front)

Distributor:
....(back)
.....5....3..(+)-screw
1.............6
(+).4....2

For the 5.2L V8: AND 5.9L V8:
Firing Order:
1-8-4-3-6-5-7-2
Cylinders:
.......(back).......
|..8..|.........|..7..|
|..6..|.........|..5..|
|..4..|.........|..3..|
|..2..|.........|..1..|
.......(front)
Distributor:
.....(back)
.......3
..4.........6

8.............5
..1.........7
.......2
......(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

Posted on May 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Windshield washer pump not working. I want to know where it is located and how to replace it.


The washer pump is located directly on the washer solvent resevoir, to remove it just disconnect the washer solvent hose and pump electrical connector, then just pull motor outward. it is just a snap type fit to the resevoir.

Jan 19, 2011 | 1998 Jeep Cherokee

1 Answer

1999 jeep cherokee sport windshield washer does not work at all...front or back...makes no sounds when engaged...no fluid...just nothing


check the fuse first,and wire connected or not,if still not work then u have to change washer motors

Jan 05, 2010 | 1998 Jeep Cherokee

1 Answer

Windshield washer fluid not working jeep 1998. It was low on fluid. Jeep is new to us. We filled it. It is cold 20 F. Tried to warm it with heat gun. Still not working M


First, in your climate you should use windshield washer fluid that has a rating for as low as the temperature will get. If you remove the tank, on the bottom of the tank is a little pump. If it is not getting power, you could have a blown fuse. But it's more likely the pump is bad. You can get one at any auto parts store for about $20.00.

Dec 19, 2009 | 1998 Jeep Cherokee 4WD

1 Answer

1998 Jeep Cheroke(4 door): front windshield washer does not function ... could it be aa electrical problem, bad fuse? Need to know where the fuse for the pump is located so I can check that first before...


Hi Ins,

No need to take apart the reservoir just yet. You'll see two pumps attached to the reservoir, one front, one rear.

Just switch the plugs. Then try the rear washer switch, it should spray up front. That will tell you if the pump is bad or not.

The fuses for the wipers and the pumps are under the drivers dash, left kick panel.

Best regards,
Mike

Dec 11, 2009 | 1998 Jeep Cherokee

1 Answer

2001 jeep cherokee windshield washer pump not working


Can you hear the washer pump run when it is activated? If so check for a split small hose at the washer reservoir. You may need to repalce the pump. It is in the bottom for the washer fluid reservoir.

Sep 24, 2009 | 1999 Jeep Cherokee

1 Answer

1998 jeep cherokee


The rear washer pump is located under the washer resevour under the hood. There are 2 pumps. The one closest to the firewall is the pump for the rear. The other is the one for the front windshield.

Jan 29, 2009 | 1998 Jeep Cherokee

2 Answers

What fuse controls the windshield washer pump? on a 2001 Jeep Che


usually it's in the washer bottle which is usually in the fender well, ahrd to get to.
The fuse that controls it should be listed in your owners manual. Usually a 10 amp fuse in the fuse panel inside the car usually on the instrument panel somewhere.

Jan 09, 2009 | 2001 Jeep Grand Cherokee

1 Answer

2000 Jeep Cherokee Windshield Washer


You have a motor for the front and rear washer. Check the fuses. If the intermitted wipers does not work, there is a relay under the dash near the steering colum that needs to be replaced.

Jan 01, 2009 | 2000 Jeep Grand Cherokee

2 Answers

97 Jeep Cherokee Sport Windshield Washer Pump Replacement


Remove the windshield wipers. Pull away from windshield until and use a screwdriver to pry clip on bottom of wiper arm and remove entire arm from mount. Now remove shroud that is under wiper arms you just replaced. After you move the shroud, you should be able to get at the pump.

Oct 22, 2008 | 1997 Jeep Cherokee

Not finding what you are looking for?
1998 Jeep Cherokee Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...