Question about 2005 Hyundai Getz 1.3

Open Question

Tighten rear view mirror on getz - 2005 Hyundai Getz 1.3

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1348 Answers

SOURCE: removal of inside rear view mirror

glass shops do it all the time.call a windshield repair place and ask how they do it...either heat or a chemical that dissolves the adhesive,which is a special glue.

Posted on May 14, 2009

Ad
carlsbiz
  • 1124 Answers

SOURCE: how do I tighten my rear view mirror in my 2002

There should be a small allen key on it..

Hope this help !!
Rate me good ;o)

Posted on Jul 13, 2009

alenjogy
  • 123 Answers

SOURCE: rear view mirror needs tightening

go to a workshop

Posted on Jul 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to reattach the inside rear view mirror the whole attachment??


remove, little plate with correct size allen wrench. Next, buy rear view mirror glue kit, at any automotive store, and follow directions. re-attach mirror to plate, once dried on windshield, and re-tighten allen screw.

May 11, 2012 | 2006 Toyota Corolla

1 Answer

Drivers outside rear view mirror is loose in the mount


look under the covers and their is either a screw or a bolt that will tighten the spring loaded cups

Jul 17, 2010 | 2000 Dodge Caravan

1 Answer

Need a diagram for installing a drivers side electric power mirror on a 1995 mercury villager van


here's 1996, all I have. Please rate.

Mirror, Power — Outside Rear View NOTE: This procedure applies to both RH and LH power outside rear view mirrors.

Removal
  1. Remove the front door trim panel (23942). Refer to Section 01-05 for the removal procedure.
  1. Remove the two outside rear view mirror inside mounting hole cover screws and the outside rear view mirror mounting hole cover (17K709) from the front door (20124).




  1. Remove the wire clip.
  1. Disconnect the power outside rear view mirror electrical connector.




  1. Remove the three power outside rear view mirror bolts and the power outside rear view mirror.




Installation
To install, reverse the removal procedure. Tighten the three power outside rear view mirror bolts to 3-4 Nm (27-35 lb-in). Glass, Outside Mirror
Removal and Installation
Refer to the glass replacement procedures in Manual Mirror for power outside rear view mirror glass (17K707) Trim Cover
Removal
  1. Remove the front door trim panel. Refer to Section 01-05 for the removal procedure.
  1. Remove the two outside rear view mirror inside mounting hole cover screws.


    Remove the outside rear view mirror mounting hole cover.
Installation
To install, reverse the removal procedure. Mirror Control
Removal
  1. Use a small flat-blade screwdriver to pry the power outside rear view mirror control switch from the instrument panel (04320).


May 13, 2010 | 1995 Mercury Villager

1 Answer

Seperate rearview mirror from plate both came off


f

Replacing the rear view mirror on a Ford Explorer is easy. The only obstacle you might encounter is fear of breaking the glued metal plate off the windshield. Do not sweat it. You can buy glues at the auto parts store to reattach the mirror to the windshield (Difficulty: Moderately Easy).

Instructions:
  1. Tap gently at the base of the mirror where it slides on over the metal plate glued to the windshield and pull upward. Some rear view mirrors have a small Allen screw that tightens the base of the rear view mirror to the metal plate. Disconnect the electrical plugs if your rear view mirror has them.
  2. Pull the rear view mirror clear of the metal plate. Clean around the metal plate glued to the windshield. If the metal plate has come off because of harsh weather or from hammering too hard at it, reattach it with glue designed for this job.
  3. Clean the area where you will be attaching the metal plate on the windshield. Apply the glue evenly on the surface of the metal plate that will go against the window. Be sure to clean and scrape off all the old glue before applying the new glue. Gently push the metal plate against the windshield in the spot you wanted it and hold tight for five minutes.
  4. Wait a day before putting the base of the mirror or replacement rear view mirror onto the metal plate. Do not force the base over the plate. Forcing it will likely dislodge it again. Press firmly until it will not slide along the grooves of the metal plate. Reconnect your electrical plugs and tighten the Allen screw if your new mirror has one. Adjust the mirror according to your safe viewing preference

Hope help with this (remember rated this help). Good luck.

Mar 12, 2010 | 1999 Ford Explorer

1 Answer

How do i replace left door mirior


remove trim panel, remove mirror fasteners.

Glass, Outside Mirror—Town Car

Removal and Installation
  1. Push upper edge of outside rear view mirror glass (17K707) into the outside rear view mirror to expose latch release.
  1. Using a small flat-bladed screw driver or equivalent, move latch release to released position.
  1. Remove outside rear view mirror glass mounting back and outside rear view mirror glass from outside rear view mirror.
  1. Disconnect heater wire connectors and auto dimmer connector, if equipped.
  1. To install reverse Removal procedure.
------------------------------------------------------------
Mirror, Power—Outside Rear View
Town Car

Removal and Installation
  1. Disconnect battery ground cable (14301). Refer to Section 14-01 .
  1. Remove front door trim panel (23942). Refer to Section 01-05 .
Trim Panels, Door Front—Town Car
Removal
  1. Snap out two door pull strap retaining screw covers. Remove screws.
  1. Remove three screws on front and rear side and center of front door trim panel (23942).
  1. NOTE: The following procedure must be used during removal and installation of the door armrest and trim panel. Refer to the appropriate illustrations for component and vehicle model identification.

    Using the Trim Pad Removing Tool from Rotunda Windshield and Moulding/Trim Removal Kit 107-R0401 or equivalent, pry the trim panel retaining clips from the door inner panel.
  1. NOTE: Do not use front door trim panel to remove trim clips from door inner panel. Replace any bent, damaged or missing push pins.

    Remove window regulator control switch housing from front door trim panel. Lift up housing in front and disconnect all connectors.
  1. Disconnect wiring harness and heated seat switch electrical connectors if equipped.
  1. Remove the door trim panel.
  1. Disconnect two electrical connectors.
  1. Remove nut from outside rear view mirror mounting base.
  1. Swing outside rear view mirror (17682) toward driver door window glass to expose screw in mount base.
  1. Remove screw from outside rear view mirror base.
  1. Remove outside rear view mirror from front door (20124). Guide wiring and connectors through hole in front door.
  1. To install, reverse Removal procedure. Tighten nuts to 8-10 Nm (71-88 lb-

Nov 05, 2009 | 1996 Lincoln Town Car

1 Answer

2004 vw beetle conv interior rear view mirror is loose


No, the mirror is just a friction fit. You will need a new mirror.

Sep 17, 2009 | Volkswagen New Jetta Cars & Trucks

1 Answer

Reattach rear view mirror


there is a small alan screw in the base of the backup mirror. loose it and slide the mirror back on to teh base on the windshield and tighten down the alan screw.

May 12, 2009 | 1994 BMW 3 Series

1 Answer

99 explorer drivers side mirror vibrates


are you trting to tighten the mirror glass or the mirror where it attaches to the body? I don't think glass is removable in 99. Only can try to press on glass to seat if unseated. not too hard.

  1. Remove the front door trim panel; refer to Section 501-05 .
  2. go to car-part.com for a used mirror. Page with * is cheapest seller.
  1. Remove the speaker.
    1. Remove the screws.
    1. Disconnect the electrical connector.
    1. Remove the speaker.
  1. Remove the outside rear view mirror (17682).
    1. Disconnect the power mirror wiring clips.
    1. Remove the outside rear view mirror nuts.
    1. Remove the outside rear view mirror.
      • Feed the power mirror wiring through the opening in the front door (20124).
------------------------------------------------------
f9d70e9.gif
----------------------------
SECTION 501-09: Rear View Mirrors 2001 Explorer/Mountaineer Workshop Manual
REMOVAL AND INSTALLATION Exterior Mirror Glass, 2001 model Removal
NOTE: Exterior mirror glass is serviceable only on vehicles built after July of 2001.
NOTE: Passenger side exterior mirror shown, driver side exterior mirror similar.
All mirrors
  1. Position the glass in the full up position.
  1. Locate the notch at the bottom of the exterior mirror glass.
  1. Release the exterior mirror glass.
    1. Insert a long flat-bladed screwdriver in the notch.
    1. Push the screwdriver into the notch until the glass is released.
Heated mirrors
  1. Position aside the exterior mirror glass.
  1. Disconnect the electrical connectors.
All mirrors
  1. Remove the exterior mirror glass (17K707) passenger side or (17T675) driver side.
Installation
Heated mirrors
  1. Connect the electrical connectors.
All mirrors
  1. Position the exterior mirror glass on the exterior mirror motor.
  1. Place a hand against the back of the exterior mirror housing and a hand flat against the exterior mirror glass. Press the glass in place until fully seated.
4d9527f.gif

Apr 12, 2009 | 1999 Ford Explorer

Not finding what you are looking for?
2005 Hyundai Getz 1.3 Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...