Question about Nissan Bluebird

Open Question

The fuel center gauge of nissan bluebird 1995 where is located

The gauge, stop in the center of the fuel tank

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2920 Answers

SOURCE: fuel gauge fluctuates on 1995 chevrolet tahoe

if you replaced the tank and all i assume you didnt change the fuel pump. if you dint then all thats wrong is that the float on the fuel pump is gas logged and will move more than if you had put in a new pump thus the fluctuation in the guage.

Posted on Jan 28, 2009

Ad
  • 99 Answers

SOURCE: Erratic fuel gauge 1995 Ford F-350

my friend most of the latest car come's across such problem so it's not the ground wiring problem it's the problem with the fuel gauge unit fitted inside the fuel tank it's time to get replaced it one thing is for sure that part is costly b'cause the fuel gauge is combination of  2 part's the fuel supply pumping motor unit & fuel level indicating gauge unit for such problem see for your nearest FORD authorised service centre across near by so till then drive safe have happy motoring so see you soon my friend..... !

Posted on May 08, 2009

  • 750 Answers

SOURCE: where is the fuel pump located on the 1992 nissan bluebird arx

its located in the fuel tank makes up part of the fuel level sending unit

Posted on Jun 24, 2009

  • 7 Answers

SOURCE: My car engin dose not start,it is 1993 nissan bluebird ARX?

This def sounds like a fule pump issue ...it should be located in the gas tank its self although i would check the fuses first before getting into the tank.
If this is in a 240sx the way into the tank is through the trunk.Lift the carpet and you will see on the mid right side a small 6-8" lid with some wires going into it. Unscrew that and your on your way in.
If you do pull out the pump just be careful handling it as to not break the sensor unit attached to the pump.

Posted on Aug 19, 2009

  • 518 Answers

SOURCE: 2005 nissanmaxima fuel gauge went haywire

the gauge connections must be loose or adrift

Posted on Jul 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1983 Nissan 720 pickup with 2.4l fuel gauge not working. What should I check


Hi Margie,I have a 85 Nissan 720 4x4 king cab.Go to the fuse box at the driver side kick panel,check all fuses.You also have some fusible links at the positive battery side,check those wires,for burnt or melted wire.Also could be your fuel gauge unit,here's a link to it. Repair Guides Fuel Tank Fuel Tank Location AutoZone com

Dec 30, 2016 | Nissan Cars & Trucks

1 Answer

My gas gauge does not work, what could be wrong with it?


In most cases, the reason why a gas gauge might stop working is because the sending unit located insider the fuel tank may have worn out. In some cases, this may require you to replace the fuel pump as well, because a lot of times they come with the fuel level sending unit attached. Otherwise, if your car is indeed fuel-injected and you are planning on dropping the fuel tank and changing the sending unit, I would also recommend changing the fuel pump as well, for good measure. I hope this helps! :)

May 02, 2014 | 1993 Nissan Sentra 4 Door

1 Answer

RPM rising and falling on Nissan bluebird fuel and ignition seems ok


1998 Nissan Maxima bluebird?
did not bluebird end in 1994?
ill answers for 1998 USA, if car is a JDM , well that be different

you have idle surge, (aka hunt)
the ECU controls idle at all times.
there are 10 or 2o things that can cause surge.
many tests. are you up for tests and buying tools, or just want a wild guess>?
1: EGR mains stuck open.
2: ISC stick (electric idle valve)
3: TPS switch ,not closed, at idle (that kills idle controls dead
4: lean AFR. and ISC has lost control or makes it hunt.
5: intake air leaks.
6: ECU in limphome. the USA cars (no location stated, bad)
all usa cars have OBD2 this year, ever use a $7 scan tool yet?
CEL stuck on running. never pulled the DTC errors?

ill stop here, there are 10 more. at least.

Oct 09, 2013 | 1998 Nissan Maxima

1 Answer

My fuel gauge dosent work on my 1986 nissan 300zx


The fuel level sensor is defective in almost every case. It is located inside the fuel tank, the tank must be removed from the car to replace it.

Jun 16, 2012 | 1986 Nissan 300ZX

2 Answers

I have a nissan bluebird u13 and it jerks while running before stalling.i have to turn the IG on several times to prime the pump before i can continue i have checked the fuel system pressure and the only...


hi i have a nissan bluebird u13, when i stop at traffic lights it jerks then just stops and i have to restart the car. i have taken it back to my mechanics 3 times in a 2 weeks and he keeps telling me theres nothing wrong. i'm at the stage where i can't drive it anymore. what can be the problem. merryn

Feb 27, 2011 | Nissan Sentra Cars & Trucks

2 Answers

Where is the fuel pump on a 1995 Nissan PU


see instructions from AutoZone:
The fuel pump assembly is located in the fuel tank. Refer to the fuel tank assembly illustrations in this section. On most applications, the fuel tank must be lowered to remove the fuel pump assembly. The fuel pump assembly is cooled by the fuel in the tank.

REMOVAL & INSTALLATION


See Figure 1
  1. Before disconnecting the fuel lines or any of the fuel system components, release the fuel system pressure as described previously in this section. Releasing system pressure is a very important step for the correct removal of the electric fuel pump.




0900c1528018d240.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 1: Internal view of the electric fuel pump
  1. Disconnect the negative battery cable. Unfasten the fuel pump assembly electrical connector and remove the fuel tank inspection cover.

If the truck has no fuel tank inspection cover, the fuel tank must be lowered or removed to gain access to the in-tank fuel pump.
  1. Disconnect the fuel outlet and return hoses. Remove the fuel tank assembly, if necessary.
  2. Remove the ring retaining bolts and the O-ring, then lift the fuel pump assembly from the fuel tank. Plug the opening with a clean rag to prevent dirt from entering the system.

When removing or installing the fuel pump assembly, be careful not to damage or deform it. Always install a new O-ring.
To install:
  1. Install the fuel pump assembly in the fuel tank with a new O-ring. Install the ring retaining bolts. Install the fuel tank if removed.
  2. Reconnect the fuel lines and fasten the electrical connection.
  3. Connect the battery cable, then start the engine and check for fuel leaks.

The "Check Engine Light'' may stay on after installation is completed. If so, the trouble code in the control unit's memory must be erased. To erase the code, disconnect the battery cable for 10 seconds, then reconnect it a verify that the light is extinguished.

TESTING


See Figures 2 and 3
  1. Relieve the fuel system pressure, as described previously in this section.
  2. Disconnect the fuel inlet hose at the electro injection unit.




0900c1528018d241.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 2: Make sure that the fuel line hose clamps are installed properly



0900c1528018d242.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 3: Testing fuel system pressure using a gauge and a "T'' fitting
  1. Install a fuel pressure gauge.
  2. Start the engine and check the fuel line for leakage.
  3. Read the pressure on the pressure gauge. The gauge should read approximately 36.3 psi (250 kPa).
  4. Relieve the fuel system pressure again.
  5. Remove the pressure gauge from the fuel line and reconnect the fuel inlet hose.

Aug 25, 2010 | 1995 Nissan Pickup

2 Answers

I have fuel pick up problems on a 1995 bonneville....gas guage says 1 quarter tank of fuel


I believe that the fuel pump and gas gauge are all one. They are located in the fuel tank. When they start going bad they sometimes start reading the amount of fuel left in tank incorrectly.

Nov 27, 2009 | 1995 Pontiac Bonneville

2 Answers

Where is the fuel pump located on the 1992 nissan bluebird arx


its located in the fuel tank makes up part of the fuel level sending unit

Jun 18, 2009 | 1993 Nissan Altima

1 Answer

My car engin dose not start,it is 1993 nissan bluebird ARX?


This def sounds like a fule pump issue ...it should be located in the gas tank its self although i would check the fuses first before getting into the tank.
If this is in a 240sx the way into the tank is through the trunk.Lift the carpet and you will see on the mid right side a small 6-8" lid with some wires going into it. Unscrew that and your on your way in.
If you do pull out the pump just be careful handling it as to not break the sensor unit attached to the pump.

Jun 17, 2009 | 1992 Nissan 240SX Fastback

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...