Climate control not heating
SOURCE: 2002 Ford Expedition Climate Control System
you have a loss of vacuum. There is a small diameter black plastic tube from the engine compartment that feeds the climate controls. Check at back of control head, or there is a plastic connector under dash were other color tubes join to operate the other actuators of the system the black tube must have vacuum when engine is running. check under hood the black tube is spliced. separate the tube and check for vacuum The tube enters the firewall near the heater hoses.
SOURCE: heat climate control doesn/t blow warm air when on lower setting
It sounds like the blower resistor is shot. Just change out the resistor and that should take care of it.
SOURCE: new climate control unit but when on blower not working for heat or ac
I'm assuming the problem is the blower motor isn't coming on or working. 1st, check the fuse. 2nd, remove the glove box or pull the 2 tabs that act like stops when it's open ( the glove box will open out further) and you'll see the power plug connector for the blower unit. Turn on the blower through the climate control (heat, A/C, or whatever) and wiggle the connector to see if the blower turns on. If starts working, then an easy solution is pull the connector off and gently press the prongs together or inward. Then carefully reconnect with damaging the prongs. This worked for 96 Mark VIII due to the fact the prongs were not "seating" correctly in the female connector. It's been about 2 years since I did this and the connection is still good. If wiggling the plug doesn't work, pull the plug, turn on the climate control (heat, A/C), and check for voltage to the plug. That's about all I can help with.
SOURCE: 2003 escalade rear climate control no heat just cold air.
there are two separate actuators for the rear system. one controls temperature and the other controls vents from head to feet. mine problem was the later. that acutuator for esv 2003 is 89018365. it is located just below third seat cup holder passenger side and can be replaced simply by removing cup holder. triangular shaped part with wire harness.
SOURCE: My 2002 vw passat wagon blows hot air out of the
If you don't want just start replacing parts , then give it to your mechanic and let him scan it for you , I'm sure it can be done much faster and more efficiently rather then try to fix it over the internet.
220 views
Usually answered in minutes!
×