Question about 2004 Lexus RX 330

Open Question

Replacing license plate bulb for my 2005 lexus 330

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 92 Answers

SOURCE: 1990 Lexus SL400

there is usually a housing for the light with a screw holding it in place

Posted on Dec 16, 2008

  • 2 Answers

SOURCE: burned out license plate bulb

open trunk,

remove felt liner from rear of trunk, (liner directly behind rear lights in side trunk) should be 4 plastic Phillips head screws. Loosing screws, then slowly peel liner away. You will see 3 nuts on each side, removing these nuts will loosing the rear light lenses, so you can pull the lense away from the body from the out side to gain access to the license plate bulbs. Re-install in reverse order. While in there I would recommend replacing your brake light and reverse light bulb. Hey your already in there might as well do a little preventive maintance.

Posted on Jan 31, 2009

repro51
  • 1 Answer

SOURCE: 1999 Lexus GS300 license plate lights

You access these bulbs from the inside of the trunk lid. Remove the carpet type cover by inserting a small slot screwdriver in the opening of the holding clips. Remove all of the clips, and the cover comes off easily. Then you can reach in through holes in the metal to access the lights. You will need to twist the bulb holder like you would if you were unscrewing a standard screw (counter clockwise) from the side the wire attaches to the light bulb socket. It's a snap in place fixture, so it can be tough to turn. When it comes loose, it only needs to turn a small amount to remove the light fixture from the socket that holds it in place. Once you have it out, simply pull the bulb straight out and put the new one in. Then reverse the process that you used to take it all apart.

Happy motoring!

Posted on Jul 07, 2009

  • 564 Answers

SOURCE: 2005 Lexus RX 330

sounds like a bad speed sensor or a bad 02 sensor hope this helps

Posted on Jul 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Plate light does not work, but lights are good and sockets seem good


check bulb the number plate light runs on the same circuit as the side lights so if they are working its got to be a bad earth on the plate light

Jan 24, 2016 | Cars & Trucks

1 Answer

How do you change number plate bulb for a lexus is250 2008 Thanks in advance


Cannot be replaced without replacing the assembly. Sorry. Club Lexis has a thread found here http://www.clublexus.com/forums/is-second-generation/625770-is250-license-plate-bulb-diy-or-new-housing.html

Mar 22, 2015 | 2008 Lexus IS 250

1 Answer

2005 Replace high mounted stoplight lexus es 330


It is not as complicated as you think. You just reach the light housing from the rear seats and squeeze the housing to release it from the rear panel. Once it is out, you can unplug the cable and replace the bulb. Good luck!

Jun 17, 2011 | 2004 Lexus ES 330

2 Answers

Need to replace license plate bulb on my 2005


1. Open the hatch and stand under it.
2. Remove pull handle from the inside of the hatch (2 screws under pop panels).
3. Starting in the lower corners, gently pry the entire interior panel from the hatch,
and leave it hanging from the wiper area near the glass.
4. Grasp the bulb housing and twist to the left while pressing inward.
5. Replace with a 1156 bulb.

Nov 01, 2009 | 2005 Nissan Pathfinder

1 Answer

How do I change the license plate lights on a 1997 Lexus ES 300?


Open the deck lid (trunk) to better access the lights. There will be 2 of them. Recommend replacing both at the same time even if only one has failed. Generally sold in pairs anyway.

Directly above the license plate will be mounted 2 clear light covers. On the right side of each light cover you can see a small plastic rivet. Push in the center 1/4 inch with a small screwdriver then you will be able to pry out and remove the rivet without damaging it. This will save you from buying replacement plastic rivets for re-installation. Remove the light cover with the bulb harness attached.

The bulb harness requires a short turn counter clockwise to remove it from the light cover and the new bulbs snap into the harness. No twisting or screwing. Replace the bulb harness the same way and fasten the light cover back into place using the plastic rivet.

Saves time because both bulbs and light covers are exactly the same style, there is no left or right. Cheers!

Apr 29, 2009 | 1997 Lexus ES 300

1 Answer

Tag light is not working on 2002 Lexus GS300


I'm guessing you are referring to the license plate light. There are two bulbs. Pretty rare for both to go out at the same time. It could be the fuse. You can check if the fuse location by looking at your owners manual.

I think the license plate bulb is W5W LL. (Check to make sure). You can find the bulb a your local auto store, Walmart, Target, etc....


Dec 24, 2008 | 1998 Lexus Gs 300

1 Answer

Burned out license plate bulb


open trunk,

remove felt liner from rear of trunk, (liner directly behind rear lights in side trunk) should be 4 plastic Phillips head screws. Loosing screws, then slowly peel liner away. You will see 3 nuts on each side, removing these nuts will loosing the rear light lenses, so you can pull the lense away from the body from the out side to gain access to the license plate bulbs. Re-install in reverse order. While in there I would recommend replacing your brake light and reverse light bulb. Hey your already in there might as well do a little preventive maintance.

Dec 12, 2008 | 1995 Lexus ES 300

1 Answer

Change License Plate Light Bulb


you should be able to get to thru the trunk

Dec 10, 2008 | 1995 Lexus ES 300

Not finding what you are looking for?
2004 Lexus RX 330 Logo

Related Topics:

606 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

874 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...