Question about 2010 Chevrolet Malibu 1LT

Open Question

The buttons on the steering wheel for the radio on 2010 malibu don't work correctly

The up volume turns the volume down, the down volume changes channels

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2004 Chevrolet Malibu

track rod end

Posted on Oct 06, 2008

  • 253 Answers

SOURCE: My 2006 Malibu steering wheel is going bad.

The power steering is electric on that car. It has a electric motor on the column, and a control module. There are several causes that could be the problem. You need to have it scanned to get a better idea of what to do. If you can give me the codes you get then I will be glad to advise you on what's best. Good Luck

Posted on May 18, 2009

  • 14036 Answers

SOURCE: Steering knock/pop while turning on 2005' chevy


Posted on Aug 05, 2009

  • 14036 Answers

SOURCE: the horn on my 97 chevy malibu doesn't's

sound like horn pad is going to have to replace horn pad and air bag as a whole unit.horn and air bag is all in one.this is a dealership fix.

Posted on Dec 03, 2009

  • 1 Answer

SOURCE: how do I change the light bulb in the steering

Pull the steering wheel buttons straight out of the steering wheel. I used a pick that was shaped like an "L". unplug the the button from the wire on the back of it. There isn't much room to work on it but it can be done. Then take the button appart, and FYI this is not a simple plug a new bulb in project. Find the burnt out bulb and desoder it from the board. Now you have to choose, you can either replace with same filiment type bulb that will burn out again soon or you can try your hand at fitting and sodering an LED in there. It can be done I did it. If you do use an led you need a multi meter to find the electrical current direction. You also must use an resister in line with the LED. You can find these on the web for a dime a dozen, I used 3mm 1500mcd and they came with the resisters (FYI they are too bright, go for a lower mcd like 800-1000). Soder in the light you choose, put back together and replace in the truck and your done. Now show all your friends what you did.

Posted on Apr 20, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Toyota 2007 Prius Touring

Usually when it works, then doesn't. Then you shut off power and turn it on and it works again. It is a module. Yours would be the steering module. These are the hardest problems to diagnose(any of the computers on the car can do this). You just spent too much for someone telling you every thing is OK. But not really. Now comes the electrical part. Checking everything from the switch to the computer and making sure it is good.

Aug 20, 2016 | Toyota Cars & Trucks

1 Answer

Horn buttons works the radio

Suspect a short circuit in the steering column wiring

Jun 20, 2016 | Cars & Trucks

1 Answer

Which fuse to change for steering wheel lights and gear shifter lights 2010 ford edge

It's not a fuse , the SJB - smart junction box controls these lights ! This is fords body control module . If the Heater / A/C control panel ,hazard switch ,headlamp switch , message center switch all work, it is not a fuse . The gear shifter I would say the bulb is burnt out . The steering wheel lights could be out because of an open in the clock spring . The clock spring is a device inside the steering column under the steering wheel that keeps your horn , cruise control , radio buttons etc... connected electrically . How cars clock spring works

Feb 04, 2016 | 2010 Ford Edge

1 Answer

How to fix + and mute buttons on steering wheel

you can buy the switch from the dealer and they change very easy

Jun 10, 2015 | Cars & Trucks

1 Answer

The radio in my 1995 jeep grand cherokee plays full volume on the right channel when turned on.

  1. bad radio amp
  2. bad wiring to speakers.
  3. or bad speakers.
the tests are easy, ask.
my guess is the weak side is bad, the load side is ok.
you can turn the volume down on the load side using volumn control
if yes that side is ok, fix weak side.

ask how, but make sure the wiring in all 4 corners are not damage
and at both ends of harness.

Feb 27, 2015 | 1995 Jeep Grand Cherokee

2 Answers

On my 2004 X Type Jag only the volume switch works on the radio unit its self cant change stations play cd of use the steering wheel controls as i said all i can do is turn the volume up or down? any ideas...

Did you find the problem with your radio Terry? I have a 2005 X type and the radio has just suddenly started doing exactly the same thing - cant change radio station or use steering controls, only the volume knob works.

Dec 05, 2012 | Cars & Trucks

Not finding what you are looking for?
2010 Chevrolet Malibu 1LT Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides