Question about 2005 Chevrolet Impala

Open Question

2005 chevy impala heater control valve

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 206 Answers

SOURCE: 2005 chevy impala rear driver power window stopped going up.stuck

If neither switch works it is a bad connection at the motor or bad ground or a bad motor. Remove the door panel unplug the motor push the switch and see if there is 12volts on the wires if there is the motor is bad There are small brushes in the motor that go bad tap on the motor while pushing the switch if it works that way replace it

Posted on Mar 29, 2009

  • 4 Answers

SOURCE: radio unlock coed for chevy impala

• A module which communicates on the class 2 serial data circuit which supplies VIN information to the radio is replaced and not properly setup with the correct VIN information for that vehicle. The only way to unlock the radio is by using a scan tool.

Posted on May 15, 2009

  • 118 Answers

SOURCE: How do i change the Blower motor resistor on a 2005 chevy impala?

The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.

Posted on Jul 20, 2009

dnewcombe1
  • 1564 Answers

SOURCE: need to know where the heater core and heater

The heater core is on the passenger side under the dash within the heater airflow contoller box. If you had Xray vision and could look straight through the glovebox, then you would see it. The heater control vale for the water flow is on the passenger side top of the engine near the firewall. It will have a domed top with a vacuum line to it and it is placed into the heater core supply hose.

Posted on Sep 07, 2009

Testimonial: "very helpful and quick"

SOURCE: heater does not work on my 2005 chevy impala ls

If you car is coming to temp but you get nothing from the heater the first place to look is the coolant valve for the heater core. It is sometimes called a mixing control. See if the control is jammed or your control cable is frozen or disconnected from this valve.

The valve should be somewhere near the cooling lines leading into the heater core. I am sorry, but they may be under the dashboard as well.

Good luck and be careful.

Posted on Dec 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changing heater core


    2005 Chevy Impala 3.8Liter - YouTube

    ? 3:51
    https://www.youtube.com/watch?v=pq2DoQq6q0A
    Apr 18, 2014 - Uploaded by DerrickTheMechanic
    How to change them out.And what they ... 2005 Chevy Impala3.8Liter ... Heater core information, coolant leak, bypass,replacement, hoses, etc.

    How To Change A Heater Core - Part 2 of 2 - YouTube

    ? 3:12
    https://www.youtube.com/watch?v=OFxQJXWszs8
    Jun 19, 2013 - Uploaded by klowny1969
    How To Change A Heater Core - Part 2 of 2. klowny1969 ...Impala . Caprice . Nova . Biscayne . Corvette . Denali . Landcruiser . ... Chevrolet 1500 * 2500 Truck * Heater Core Replacement * Gasoline * 1997 - Duration: 11:59. images for 2005 Chevrolet Chevrolet Impala LS ...


Feb 03, 2016 | 2005 Chevrolet Chevrolet Impala LS

2 Answers

Location of transmission solenoid in a 2005 Chevy Impala


He's back !!!

Inside the side cover on yours--- Jerry

No easy job- as sub frame is in the way, I
suspect

Need a trans shop

Dec 01, 2012 | 2005 Chevrolet Impala

1 Answer

Heater does not work on my 2005 chevy impala ls but the blower does but blows cold air


If you car is coming to temp but you get nothing from the heater the first place to look is the coolant valve for the heater core. It is sometimes called a mixing control. See if the control is jammed or your control cable is frozen or disconnected from this valve.

The valve should be somewhere near the cooling lines leading into the heater core. I am sorry, but they may be under the dashboard as well.

Good luck and be careful.

Dec 11, 2009 | 2004 Chevrolet Impala

1 Answer

2005 Chevy Impala driver's side heat blows cold, but works on passenger side. Was told a vent is probably not opening to allow for the heat to get to the driver's side? Where can I locate this vent?


First....buy a drivers side air flow actuator at a auto parts place for dual zone heating/cooling.
(NAPA etc will have it.....or the dealer)
Open the glove compartment.....all the way....you may have to take the screws out at the bottom......look in at the heater assembly....look over to the left....you will see the two air flow actuators.
Look at the part you have and match it to the part on the heater assembly.
The actuator that is closest to the engine is the drivers side control.
Replace it.
Try your controls and check for heat and cooling on both sides.
The stepper motor in these actuators goes bad on quite a few...but over look that.....you have a great car,good for many miles of trouble free driving.


Nov 03, 2009 | 2005 Chevrolet Impala

1 Answer

What heater blower is compatible with the 2005 impala


2004-2007

cgi.ebay.com/ebaymotors/2004-2007-Chevy-Impala-HEATER-BLOWER-MOTOR---New_...

Oct 29, 2009 | 2005 Chevrolet Impala

1 Answer

I drive a 2005 chevy impala.. everytime i turn on the heater and the driver's side blows out cold air and the passenger side blows out heat.. can you please tell me what is wrong


Do you have separate drivers side and passenger heat controls?
If you do have this system,the common problem is the control unit s on the heater/a/c assembly. Can you adjust heat and cooling on one side?
Then the other side control unit is most likely bad.

Oct 20, 2009 | 2005 Chevrolet Impala

1 Answer

2008 Chevy Impala, was in a front end collision, the heater only blows hot air when the rpms are above idle. when at idle it blows cold. Any ideas?


There's probably a little vacuum actuated valve in one of the hoses going from the engine block to the heater core. make sure this valve is working.

Also... check coolant level

and

Your water pump may be marginal, only circulating adequate collant at engine speeds above 1000 RPM or so.

Mar 08, 2009 | 2005 Chevrolet Impala

1 Answer

2006 Chevy Impala - Heater recently worked on by garage and "control unit" replaced. Now heater motor runs on high at all times irregardless of fan speed control setting and whtehr ignition switch os...


the blower motor resistor is damaged probably in the process of removing the heater core replace the blower motor resistor, and please dont forget to rate me!!

Dec 02, 2008 | 2005 Chevrolet Impala

Not finding what you are looking for?
2005 Chevrolet Impala Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...