Question about 2006 Pontiac G6 GT
Heavy fuel smell at the rear of car vehichle wont start without pumping the gas pedal
Is the check engine light on? Could possibly a bad EVAP canister or a leak in the fuel system.
Posted on Dec 12, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Fuel Pump Relay Switch
Underneath your hood, behind the passenger side headlight, behind the core support, is a bank of 2-8 relays. One of those relays is the relay needed for your fuel pump. There will also be a fuel pump relay fuse located there. The relay designation should be on the cover of the relay compartment.
Posted on Jan 03, 2009
SOURCE: bleed brakes but no pedal
Good! You bled the master cyl. before installation! The proper order of bleeding the lines, is to start with the wheel the greatest distance from the master cylinder. Then work your way to the next greatest distance, and last, the closest wheel. Make sure all air is removed from the lines before you proceed to the next wheel, and frequently check the master cyl. level, because, as I'm sure you know, if you **** in air at the master, you have to start all over again. I'm assuming you don't have a power bleeder, so with a helper do this with car running (make sure it's on safety stands and not going to fall on you!) Pump pedal 3 times, no need to mash the pedal into the floor, just 3 pumps 1/2 way down, hold 3rd pump at half way down level while bleeder is opened, when flow is about to stop at bleeder, close bleeder and repeat til no evidence of any air. Let me know how it goes and if you need any help.
Posted on Apr 21, 2009
yep i seen it in happen .i was at a gas station a guy drove car to the gas station on empty.he fill his tank up .could not get it to crank .some cars you have to restart fuel pump when run out of gas. like chrysler.you use a scanner. but chervrolet you run low over heat damage the pump.it has to stay submerge gas to keep it cool. check fuel pump pressure.it should be 41 - 47 psi.
Posted on May 05, 2009
The fuel pump is in the fuel tank.Sit in the car.....turn on the ignition switch to run.....listen very closely to the rear of the car...or have someone kneel down by the back wheel.....you should hear a "prime cycle"......the pump running for 2 or 3 seconds if the key was off for 15 seconds before trying this.If you hear silence you most likely need a fuel pump.Before pulling the tank down....check for power on the gray wire at the fuel tank connector just ahead of the rear axle under the car.Check for power with a test light that will last for 2 to 3 seconds as you turn on the key to run.Power means you really most likely need a pump.No power means you may need a fuse or a fuel pump relay.
Posted on Aug 11, 2009
Tips for a great answer:
Mar 31, 2016 | Cars & Trucks
Mar 20, 2014 | 2001 Kia Sportage
White smoke and Acrid Smell? http://whoisbyme.blogspot.in/2012/07/white-smoke-and-acrid-smell.html
---------- Car stalls and throws white smoke from exhaust? http://repairhelpcenter.blogspot.com/2012/01/car-stalls-and-throws-white-smoke-from.html
This will help.
Jul 20, 2012 | Cars & Trucks
Jun 09, 2012 | 1994 Mazda Protege
Feb 28, 2010 | 1995 Ford Mustang
Aug 14, 2009 | 2002 Saturn L-Series
Jul 11, 2009 | 2005 Hyundai Santa Fe
May 17, 2009 | 2001 Jeep Grand Cherokee
Oct 28, 2017 | 1999 Chrysler 300M
364 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: