Question about 2007 Ford Edge SEL Plus

Open Question

Is there a way to reset the anti theft device

The keys are inside the car

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: anti theft device for 97 ford expedition

I have 2007 expedition XLT and the interior light blinking all the time what the solution ?

Posted on Oct 18, 2008

alicantecoli
  • 22156 Answers

SOURCE: 2001 ford focus anti theft

yes its possible to disable the alarm immobiliser ,remove the ECU unit .then solder in a 12v supply from the on side of ignition,find a suitable connection in the wiring harness feed and solder to a switching transistor on the side of unit with a heat sink to the base connection of a transistor that controls the feed to another three transistors ,starter motor earth for relay,fuel pump earth relay,and ignition ,no relay and away you go location of transistors iam not saying as i dont wont the car theives reading it ,but its as easy as falling off a log when you know the colour of the wires, pin numbers and a magnifying glass soldering iron .took me hours to follow the the connections in the fuse box separating the two halves to follow circuit,tracing wires back to ECU then following printed circuit but i have done it .SO DEALERS EAT YOUR HEART OUT ANOTHER FOOD WITHOUT WORKING FOR IT JOB LOST .going to try it out on a dammed renault when i get time.Also sell the details over the internet ???? no i dont think so iam just glad i have pissed off the local dealers that wanted 200€

Posted on Dec 10, 2008

junmag
  • 175 Answers

SOURCE: anti theft device for 1997 ford expedition

try using a spare key first

Posted on Jun 02, 2009

  • 30 Answers

SOURCE: how do you reset the anti theft system

Try disconnecting your battery cables then wait about 10 minutes. The computer should reset itself. Reconnect the wires to the battery. It is normal for the theft light to blink about every 5 seconds when the ignition key is out or in the off position. This means the system is armed and working properly. Hope this helps. God bless!

Posted on Oct 19, 2009

wfservices
  • 260 Answers

SOURCE: 1996 Explorer anti-theft system won't disable

Try re-setting the computer...Disconnect the negative terminal of the battery and leave off for 5-10 minutes. This will allow the computer to reset. The charger may have interupted the signal or something.

Posted on Mar 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I reset the anit-theft system on the vehicle?


your anti theft device is activated,you need to lock and unlock your doors a couple times with the key fob,not the key,and then you need to put the key in the ignition and start it,if you dont have your key fob,call your car dealer to get a new one,they are programmed for each car only,you cannot bypass it.

Jun 21, 2015 | 1998 Mercury Mountaineer

1 Answer

How to reset the anti theft on a 03 mach 1 mustang gt


your anti theft device is activated,you need to lock and unlock your doors a couple times with the key fob,not the key,and then you need to put the key in the ignition and start it,if you dont have your key fob,call your car dealer to get a new one,they are programmed for each car only,you cannot bypass it.

Jun 16, 2015 | Ford Mustang Cars & Trucks

2 Answers

How to reset anti-theft on a 2000 alero


The security, antitheft or lock picture/icon is a visual indication that something in the car's antitheft system is failing. In most GM cars and trucks there is a hidden system that most people are unaware even exists. From the moment you put your key in the ignition, there begins a constant line of communication between your key's security chip or transponder, to the ignition's lock cylinder, and then to the car's TDM (Theft Deterrent Module). These 3 parts are in CONSTANT communication. If the key is in the ignition, then these parts are sending signals to each other. The security light illuminates when that signal gets broken, even just for a second. When the signal breaks, the car misinterprets this as an attempt at theft and goes into antitheft mode. The car thinks its being stolen or hotwired because it is not getting that signal from YOUR specific key. This is why the security light turns on and shuts down your vehicle. This link explains it pretty well.
http://www.diy-gm-security.com/

25627937-vycpj41x2iphfdmbx4v0vfed-3-0.jpg

Apr 04, 2015 | 2000 Oldsmobile Alero

1 Answer

How do I reset the truck to start after the anti theft lock has been activated?


Insert correct key in to Drivers door and turn clock wise then turn counter clock wise unlocking and resetting security system. This usually dose the trick HUCK.

May 06, 2017 | Chevrolet Cars & Trucks

1 Answer

How to reset a anti thef system


There is no way to reset the "Anti-Theft" system. Hopefully you have more than one ignition key. Slide one key into the ignition cylinder and try to start the engine. If nothing, try the same thing with the other key. There is a transponder inside each key and the exciter ring will send a signal to the key. If the signal that it receives is not valid, then the Anti-Theft system will tell the ECU not to allow the car to be started. What is the security light doing while you try to start the engine? Did this problem happen out of the blue? Was a repair performed on the ignition switch? Are there any other symptoms? Please write back and let me know, good luck.

Mar 25, 2014 | 2013 Toyota Prius c

1 Answer

Is there a way to reset the anti theft device on a 2007 Ford Edge


Cars equipped with keyless entry are common now. They contain a remote key chain that triggers the door to unlock. Inorder to reset the anti Theft device on the 2007 Impala a scan tool is needed. It does sometimes reset after 10 min.


-----------------------------------------------------
Renault CAN Clip Diagnostic Interface V123

Dec 12, 2012 | 2007 Ford Edge SEL Plus

1 Answer

07 ford focus anti theft light flashes all the time


If the security or anti-theft light is flashing when you attempt to start your car, and the engine does not crank or does not start, you have an anti-theft problem. The system may not be recognizing your key's key-less entry signal, or there may be a fault in the anti-theft module or wiring.
There is a reset procedure to stop this anti-theft light flashing.many a times this helps The reset procedure is as follows:-- Reset the alarm by locking and unlocking the drivers side door.Do this a couple of times and then check it will reset the factory security system . If the reset procedure does not helps then its time to get the anti-theft system checked.There is a short circuit in the anti-theft system wiring. For more detailed help on this anti-theft light blinking issues please click on the link below http://www.aa1car.com/library/troubleshoot_antitheft_system.htm
Thanks. you can rate this solution and show your appreciation.

May 18, 2010 | Cars & Trucks

2 Answers

Car wont start. computer says its the anti theft device


is their a button you have to push be4 starting the car?

Jun 19, 2009 | 2001 Chevrolet Malibu

1 Answer

How to reset the anti theft swith and Where is it


Some possible solutions that might help: 1. I'm not sure if this model comes with a Master Ignition key (which is usually a different colour fob or shape). If it does, then try starting the car with the Master key, it should override and reset the antitheft system and allow the car to start. 2. The Alarm keyfob (if it has one) battery may need replacing. 3. There may be an override key operated switch on the alarm itself or secreted away somewhere inside the car, which you can use to activate/deactivate the antitheft device? 4. You may have to key a code number onto a set of buttons on the dashboard to reset the Antitheft device? 5. Do you have the User Manual for the vehicle. There should be some explanation in there about what precautions to take when replacing the vehicle battery, and how to reset the anti theft device so that the engine can be started again

Jun 08, 2009 | 2001 Chevrolet Cavalier

Not finding what you are looking for?
2007 Ford Edge SEL Plus Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...