Question about 2005 Chevrolet Aveo

1 Answer

1995 chevy lumina serpentine belt

I bought a new belt and replaced the old one. Now the new belt wil not stay on. As soon as I put the belt on and turn the key, the belt pops off. what is it that I am doing wrong??????

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 44 Answers

Make shure you have the right tension on belt. hope this helps

Posted on Jan 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace a serpentine belt on a 1998 Chevy lumina 3.8


Usually it takes a special tool or a crowbar to take the load off the tensioner to remove the old belt and install the new one. Make sure you have a diagram of the belt routing before you take the old belt off.
There should be videos on Youtube for GM engines.

Apr 12, 2015 | Cars & Trucks

1 Answer

1995 chevy luminga wont stay runing, and I have replaced a coil, throttle positioning sensor, ignition moduel, and plugs and wires.


run fault codes and check for HO2S and O2 sensors problems . Check fuel pressure and injectors for operation.

Apr 19, 2014 | 1995 Chevrolet Lumina

1 Answer

95 chevy lumina 3.1 Dashboard lights stay on


usually, this is an ignition switch problem.

Oct 13, 2009 | 1995 Chevrolet Lumina

1 Answer

1995 Chevy Van Cannot start after shutting it off without jumping


Check the crank sensor probably when you replaced the timing belt you could have either not put the crank signal ring in correctly or damaged the crank sensor.

Mar 25, 2009 | 1995 Chevrolet Lumina Apv

3 Answers

1995 lumina cranks but will not start


Does it have the anti-theft system, if so check for the two wires that go to the ignition switch and make sure they are not broken. If they are they will need to be fixed in order to get it too run again

Mar 23, 2009 | 1995 Chevrolet Lumina

2 Answers

I am trying to replace the serpentine belt on a chevy lumina 1996, cannot find a diagram to be sure I am putting it on correctly. any suggestions


See the figures at the bottom of the page at this link. Figure 14 is for the 2.8L and 3.1L engines, which is probably what you have. Figure 15 is for the 3.4L engines.

Dec 28, 2008 | 1993 Chevrolet Lumina

1 Answer

How to change the serpentine belt on a lumina euro 3.1??


I found on my 92 lumina 3.1 the easiest way to change the belt is to have two people handy (you and a helper) push the belt tensioner (which is more in the middle of the belt system, its the only thing that has give when pressure is applied) down (which will loosen the belt) have your partner slip the belt off the altenator (which should be on the very top of the belt system on the passenger side) and just pay attention to the way the belt is routed as you remove it, put the new one on (routed correctly) push the tensioner again have your partner slip it back over the altenator....and you have a new belt on with no tools :)

just pay good attention to the routing of the belt, and i also think there is a black cover over the belt which needs to be removed before the old belt can be taken off (if you dont see it at first you will find it) it has 3 bolts i think and also a diagram of the routing....

TIP: the tensioner will take some muscle to move down, and yes the belt is running over it....

Oct 22, 2008 | 1992 Chevrolet Lumina

Not finding what you are looking for?
2005 Chevrolet Aveo Logo

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63990 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...