Question about Chevrolet Silverado 1500

Open Question

Help po449, po300 codes

I replaced spark plugs, spark plug wires, fuel pump, fuel pressure regulater, fuel filter, battery, maf sensor, map sensor, intake manifold gasket, and timing chain. Where do i go from here?

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ZJLimited
  • 17970 Answers

SOURCE: po300 code possible fixes?

HI there:

Basically this means that the the car's computer has detected that not all of the engine's cylinders are firing properly.


A P0300 diagnostic code indicates a random or multiple misfire. If the last digit is a number other than zero, it corresponds to the cylinder number that is misfiring. A P0302 code, for example, would tell you cylinder number two is misfiring. Unfortunately, a P0300 doesn't tell you specifically which cylinder(s) is/are mis-firing, nor why.


Symptoms may include:

the engine may be harder to start
the engine may stumble / stumble, and/or hesitate
other symptoms may also be present

A code P0300 may mean that one or more of the following has happened:
Faulty spark plugs or wires
Faulty coil (pack)
Faulty oxygen sensor(s)
Faulty fuel injector(s)
Burned exhaust valve
Faulty catalytic converter(s)
Stuck/blocked EGR valve / passages
Faulty camshaft position sensor
Defective computer


Possible Solutions: If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.


If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.


Random misfires that jump around from one cylinder to another (read: P030x codes) also will set a P0300 code. The underlying cause is often a lean fuel condition, which may be due to a vacuum leak in the intake manifold or unmetered air getting past the airflow sensor, or an EGR valve that is stuck open.


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Posted on Aug 03, 2012

Testimonial: "thank you for your suggestions.codes were cleared,so far po140 has not returned (bank one,sensor two).code po300 returned in less than five minutes.will check vacuum,hoses,and egr next."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Gm code po300


This is a misfire code. Start with the basics, fuel filter, spark plugs, vacuum leaks, wires etc. If after checking/changing necessary parts, if problem persists you will need to go deeper as in coils and computer controlled parts such as map sensor, maf sensor

Sep 10, 2014 | 2002 Chevrolet Blazer

1 Answer

1998 volvo s70 2.4 glt turbo


code p0102 refers to MAF/VAF sensor ---low input ===causes --wiring short to ground. MAF/VAF sensor
code po172 refers to system too rich --bank 1=== causes ---intake blocked --EVAP canister purge valve---fuel pressure ---HO2S sensor
code po random misfires ---plugs --wiring ---injectors--low compression
code po305 refers to cylinder 5 misfire detected ===causes --engine mechanical fault--ignition/ fuel system ---injector ---ECT/MAF

I would check that the air filter is not blocked first as it affects the MAF/VAF sensors . Have a fuel pressure system pressure test done

Feb 13, 2014 | Volvo S70 Cars & Trucks

1 Answer

Is there an erg valve on a honda accord 2008 4 cyl


code p0300 refers to--random/multiple cylinder/s misfire detected...Causes---spark plugs---HT leads---injectors---ignition coils ---low compression ---wiring
code p0302 refers to cylinder 2 misfire detected Causes ---engine mechanical fault---wiring---ignition/fuel system ---ECT/MAF sensors ECM
code po303 refers to cylinder 3 misfire detected Causes Engine mechanical fault---wiring---ignition/ fuel system ---injector---ECT/MAF sensor ECM The common fault to all is the fuel/system ignition
I would have the injectors checked and have a pressure test done on the fuel manifold to check pump and fuel regulator valve.

Apr 05, 2013 | 2008 Honda Accord

1 Answer

2004 grand am ecotoc idles surges from 500 too 1000 rpms. i had a PO300 code and i replaced map sensor,maf sensor, fuel regulater, spark plugs and boots,icm and coil pack. now i have no code showing b


three things to check-idle air control valve if you haven't checked already-a crack or leak in the intake manifold-or clogged ports in your intake manifold

Mar 24, 2013 | Cars & Trucks

2 Answers

2002 Chevy Silverado po300 po449 codes


Have you checked the EGR valve? The P0449 EVAP code is normally or the purge solenoid on the intake. Unplug the line that feeds the EVAP system from the purge valve and connect a vacuum gage. It should flutter while it is activated. If not, that could be the culprit.

Dec 12, 2012 | 2002 Chevrolet Silverado 1500

1 Answer

Question about a P0191 DTC on a 2004 Ford Explorer XLT


What repairs can fix the P0191 code?

  • Replacing fuel filter(s) or fuel pump
  • Replacing the fuel pressure regulator
  • Repairing any broken, frayed, or shorted wires that lead to the fuel pressure sensor
  • Repairing corroded connector to the fuel pressure sensor
  • Replacing fuel pressure sensor
  • Repairing any vacuum leaks in the engine

    Many times this error will also occur if there already exists fuel/air problems, like your previous code 2106 means there are one or more components in your car's intake/exhaus/air/injection systems that is having serious problems

Mar 06, 2017 | Ford Explorer Cars & Trucks

2 Answers

2000 lincoln ls want start. replace fuel pump and fuel pump relay.


have you checked the fuel pressure regulater or the map sensor

Mar 20, 2012 | 2001 Lincoln LS V8

1 Answer

VERY ROUGH IDLE NO EXCELERATION


Try a few if these ideas...

Priority Action Part Type Cause
1 Inspect Spark Plug Fouled, Damaged, or Broken Spark Plug(s).
2 Inspect Hose (PCV) Clogged or Collapsed PCV Hoses.
3 Inspect Wireset Worn, Damaged or Faulty Spark Plug Wire(s).
4 Inspect Distributor Worn, Damaged or Faulty Distributor.
5 Inspect Catalytic Converter Clogged or Faulty Catalytic Converter.
6 Inspect Fuel Pump Low Fuel Pressure.
7 Inspect TimingSet Slipped TimingChain or Worn TimingGear(s).
8 Inspect Knock Sensor Improperly Connected or Faulty Knock Sensor.
9 Inspect M.A.P. (Manifold Absolute Pressure) Sensor Faulty M.A.P. Sensor.
10 Inspect Throttle Position Sensor Faulty or Incorrectly Connected Throttle Position Sensor.
11 Inspect Mass Air Flow (MAF) Sensor Damaged, Loose, or Faulty Mass Air Flow Sensor or Circuit.
12 Inspect Air Cleaner Temperature Sensor Damaged or Faulty Air Cleaner Tempature Sensor.
13 Inspect Fuel Injector Pressure Regulator Faulty Fuel Injector Pressure Regulator.
14 Inspect Piston Ring Set Worn or Broken Piston Rings.
15 Inspect Timing Specification Incorrect Ignition Timing.
16 Inspect Fuel System Pressure Incorrect Fuel Pressure Being Delivered to Carburetor or Fuel Injection System.
17 Inspect Fuel Filter Clogged or Dirty Fuel Filter.
18 Inspect PCV Valve Plugged or Damaged PCV Valve.
19 Inspect Valve Burned, Worn, or Sticking Exhaust Valves.
20 check idle stop solenoid - if faulty, could cause rough idling
21 inspect distributor cap/rotor - if burnt, could cause loss of acceleration

Apr 18, 2011 | Chevrolet Cavalier Cars & Trucks

2 Answers

Chevy s-10 2003 4.3 lt v-6 4x4


catalytic convertor may be plugged

Jul 21, 2009 | 2001 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...