Question about 2002 Chevrolet Silverado 1500

1 Answer



Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Chevrolet Master
  • 21,873 Answers

Could be the blower motor, or the resistor, or a bad connection in the harness. Someone would need to check for power and ground at the motor first.

Posted on Dec 12, 2012


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 116 Answers

SOURCE: 1998 chevy silverado 1500 heater fan wont come on.

replace the blower motor .,....

Posted on Dec 11, 2008

  • 1 Answer

SOURCE: Blower does not work on my 2006 Chevy Silverado truck

I had this same problem. What I did to resolve it was to slap the underside of the fan housing (in the passenger floor board) until the blower came back on. The fan/blower housing is that big black box right under the glove compartment. I know that sounds stupid, but I think there is a plug above the blower that is not making a good connection, so when I slapped it upwards it reseated itself and the blower came back on.

Posted on Jan 03, 2009

  • 90 Answers

SOURCE: heater fan switch only works on 4. nothing on 1-2 or 3

Most likely the blower motor resistor has failed. GM offers an updated version.

Posted on Jan 17, 2009

  • 3 Answers

SOURCE: a/c heater climat control switch

Check the relais module located inside under the rh side of the heather box you can see the connector most of them need to be replaced as they burn out you may need to replace the blower motor as well,high amp draw caused by faulty bearings will overload the blower motor controller

Posted on Feb 15, 2009

  • 166 Answers

SOURCE: Blower fan resistor module replaced, worked for 2 days quit again

hi you probely have a draging blower motor. if it pulling more than 25 amps replace it and check akk wirring connectors for burn or hot spots. good luck

Posted on Jul 17, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

No air/heat coming through vents

u more then likely have a bad blower motor resistor

Jun 20, 2013 | 2000 Chevrolet Blazer

1 Answer

No heat in car back defrost works fine?

I had a similar problem with two different cars. Mice had somehow got into the heater ducting and built nests. This will plug up the ducting, or if nest is next to the heater fan, it can keep fan blades or the squirrel cage fan from turning. If that is the problem, you'll need to take some of the ducting apart and clear the obstruction. Good luck.

Feb 17, 2013 | Cars & Trucks

1 Answer

My 1997 nissan maxima has an intermittent fan/defrost motor, what causes the motor to run one day then not the next?

The most common reason is a faulty blower motor. You would need to check for voltage and ground at the motor when it will not run. If you have power and ground you may be able to tap on the motor and make it work.
If you don't have power or ground you would need to trace the circuits to find the problem.

Jan 07, 2013 | Cars & Trucks

1 Answer

Vent in centre of windscreen not working i have a A4 1.8T 2002 the vent in the centre of the windscreen stopped working a week ago drove the car the next day was working perfect it has just stopped working...

There is only one door. Air flows through the AC evaporator and the blend door diverts some or all of the flow through the heater core. For heat, the compressor is off under electric control and the non-refrigerated air is diverted through the heater core. The door is on a vertical axis and can swing to any position based on random corner turns, fan speed, mode, etc.

Jul 30, 2009 | 2002 Audi A4

1 Answer

Heater fan doesn't blow

most likely the blower motor has gone out completly pull the harness off the blower motor and see if its getting power

Jan 15, 2009 | 1992 Honda Accord

1 Answer

Heater quit working (would only

Sounds like your auto climate control module.

Aug 11, 2008 | Mercedes-Benz E-Class Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides