Question about Cars & Trucks

Open Question

Explanation of 2006 FUSO trouble code P1630 and P1462

Code p1630 and p1462 is showing on scanner but no real problem is noticed when driving truck. Any suggestions as to code ID or repair? Thanks !!

Posted by on

4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1665 Answers

SOURCE: codes

P0455= Evap. Emission system leaks.

Posted on Jan 06, 2009

  • 1986 Answers

SOURCE: mercedes e320 saloon diesel error codes

P1617 Control Module Fault Or Control Module Not Coded
P1630 Drive Authorization Signal

It sounds like there's an issue with your Car's computer

Posted on Sep 24, 2009

Testimonial: "Thanks for the prompt help. The computer does seem a bit flakey as I get spurious codes which can be cleared temporarily by using the diagnostic. "

  • 78 Answers

SOURCE: car resistor problem unable to start change key


Posted on Apr 30, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2006 Cobalt LS. codes P1630 passlock module and code P0315 cranck shaft relearn. It starts and dies after couple of seconds. replaced both without any luck. Any ideas?

Does the dash show the theft light/picture?If so turn the key to on and leave it on until it relearns the key chip.

Jul 09, 2017 | Cars & Trucks

1 Answer

2001 Cadillac debille security light stays on some times flashes but runs how do you find what resistanc the chip has with a meater and were you put it. to by pass

There is no resistance you can check , no place to by-pass anything . If the security light is on have it checked for DTC'S - diagnostice trouble codes . This will say what to check !

DTC B2734
DTC B2960
DTC B3031
DTC B3055
DTC P1630
DTC P1631

Autozone , napa , advance , pep boys , none of these can check for these codes , Dealer !

When an ignition key is inserted into the ignition lock cylinder, the transponder embedded in the head of the key is energized by the exciter coils surrounding the ignition lock cylinder. The energized transponder transmits a signal that contains its unique value, which is received by the theft deterrent control module. The theft deterrent control module then compares this value to a value stored in memory (learned key code). If the value is correct the theft deterrent control module sends the enable password via the serial data circuit to the powertrain control module (PCM).

Mar 24, 2017 | Cadillac Cars & Trucks

1 Answer

How ti reset or fix a P1630 error code on a Isuzu KB300 TDI Anyone please

welcome to USA forum
the country with not one
KB truck
in fact are EPA illeggal here. but not in AFRICA
for faster service, post to African forums>?

we have no cars, no books or parts here for KB of any kind.

google KB truck forums...

Mar 10, 2017 | Isuzu Cars & Trucks

2 Answers

2006 holden rodeo with 3 ltr Isuzu engine. Will run and drive and then stop with error code p1630a. If you pump priming pump and hold throttle down it will start and run for a while.

P1630 "Theft Deterrent Learn Mode Active", this causes a stall and the hard start. You may have a problem with the control module.

Aug 31, 2016 | Isuzu Cars & Trucks

1 Answer

I have mitsubishi has p1630 to fix it.thanx

Fault code p1630, internal damage, no drive to injection pump

Aug 15, 2016 | Mitsubishi Cars & Trucks

1 Answer

I have a 2001 Toyota Ipsum 240e. The engine check light goes off when I disconnect the battery terminal. The light will not come on when the engine is run as long as required but once it is switched off...

You should have the error code read from the vehicle's computer (a code scanner is needed for this). If you constantly are disconnecting the battery, some manufacturers program an error code in the computer indicating that the battery has been disconnected within the last XX number of starts. If the code is P1600 or P1630, this is probably your problem. If you're disconnecting the battery for security reasons, either install an aftermarket security/anti-theft system or realize that the check engine light will keep coming on.

Sep 29, 2013 | 2001 Toyota Sienna

1 Answer

How do you reset the security light on a 2005 chevy cobalt?

There is no reset , if security light is lit there is a problem with the anti-theft system .Should have it checked for DTC'S - diagnostic trouble codes . Could have 8 different B - codes
DTC B0685 DTC B2955 DTC B2960 DTC B3031 DTC B3033 DTC P1626 DTC P1630 DTC P1631
You would need a professional type scan tool to read these type codes , not an OBD 2 code reader .

Apr 14, 2012 | Cars & Trucks

1 Answer

Mercedes e320 saloon diesel error codes p1630 AND p1617 Can't find date on these, anyone know? Bruce

P1617 Control Module Fault Or Control Module Not Coded
P1630 Drive Authorization Signal

It sounds like there's an issue with your Car's computer

Sep 24, 2009 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

1 Answer


P0455= Evap. Emission system leaks.

Jan 05, 2009 | Hyundai Motor 2003 Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

480 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides