Question about BMW X5 Series

Open Question

What does the two car indicator light mean on a BMW X5

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 14036 Answers

SOURCE: 2002 530i bmw, has a double car symbol on the dash.

has to with parking distance control component like a bad ultra sonic sensors .they warn you if you too close to another car.

Posted on Jun 11, 2009

  • 580 Answers

SOURCE: BMW x5 DSC indicator lamp stay on and no power.

When the DSC Dynamic Stability Control light is ON your traction control is OFF. It will sometimes trigger the ABS light and the Rev Limiter it is an engine protection FAIL SAFE mode.
Check your brake switch on the brake pedal, this sounds like the problem wen replaced it will reset the Rev limiter, if the ABS light comes Check the wheel sensors

Posted on Jul 20, 2009

RixsFixes
  • 2200 Answers

SOURCE: I have a 2003 BMW X5, how do I reset the service indicator?

Hi,

You can reset your service indicator, as follows:

  1. Get in the car, close the door, buckle the seatbelt.
  2. Push in the clutch pedal and hold it to the floor
  3. Press the left hand dash button (the one that resets your odometer) and hold it down
  4. Put the ignition key in the key slot, and turn it gently (very gently) until the dashboard lights come on - the key will not click - if it clicks you've gone too far and you have to start again. Hold the key in this position. In five seconds or so, the dash will display "SIA" and some other characters. Do not proceed until this happens.
  5. Release the dash button (and only the dashboard button) and then press and hold it again. In another 5 seconds or so the display should begin to flash "RESET?" Do not proceed until this happens.
  6. Release the dash button and push it again to confirm. You won't need to hold it - the display should change immediately and your service indicator will display five green LED's.
Hope this helps. Please remember to rate this answer. Many Thanks.

Posted on Jul 29, 2009

  • 1 Answer

SOURCE: my bmw x5 3d relising so much smoke from exust

Just had my car in the garage with horrendous white smoke coming from the exhaust. The problem with mine was a blocked crankcase breather. When blocked oil is passed into the exhaust system apparently.
Problem solved by the mechanic and half a day in the garage with the engine running to burn off the excess oil in the exhaust and the problem was solved. Had gentle ride out to the coast yesterday approx 1.5 hrs each way and the smoke has gone.
Good result for £160.00. I dread to think what the dealer would have charged.

Posted on Sep 21, 2009

  • 13 Answers

SOURCE: Fog light replacement 2005 BMW X5

This link decribes how to change the Fog Lamp at Xoutpost.com. ( It is a forum for the X BMW's ). Good luck.

Posted on Oct 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 bmw x5 3.0i reads range mls appears what does that means ?


This is part of the driver display system and it indicates the approximate range of the car on the available fuel.


The BMW Official Website Award Winning Luxury New Cars

Jul 19, 2015 | BMW Cars & Trucks

1 Answer

What reason is caused?A BMW X5 engine oil pressure warning light


May be due to oil pump wear, filter blocked by dirt, oil filter is exposed out of the oil surface, the oil level is low, the oil mixed with air and the pressure gauge is caused by the failure of the. In addition, the oil viscosity is low, the oil seal and poor lubrication, lubricating oil viscosity is too large, too cold oil sludge deposition too much also can cause the oil pressure indicator display abnormal.
source: obd2 tool car diagnostic

Nov 28, 2013 | BMW X5 Series Cars & Trucks

1 Answer

Bmw x5 sidelight out but indicator on


Whenever a light doesn't work and the dash indicator light comes on without flashing, first suspect a bad bulb, or a bad ground at the bulb.
The electricity is feeding back through the system to the dash indicator.
Second would be the flasher, but likely not in your case.
Be blessed.

Feb 17, 2013 | BMW X5 Series Cars & Trucks

1 Answer

What does * LIMIT 4 MPH* message means on BMW X5 2001


It sounds like you inadvertently set the speed warning (you can set it in the OBD to warn you if you go over a certain speed). If the car has nav, look under the "settings", second page, and turn it off or set it to something like 85. If you don't have nav, I'm not sure where the setting is but look for "speed warning" in the manual. Hope that helps.

Jan 14, 2013 | 2001 BMW X5 3.0d

1 Answer

Which means the code of a bmw x5 2774


p2774 means Four Wheel Drive (4WD) Low Switch Circuit High

Dec 01, 2011 | 2005 BMW X5

2 Answers

What would be the causes for brake lining study light to come on in a bmw x5 2005.


Study light? Do you mean warning light?
There are sensors clipped into the brake pads on the front left and rear right wheels. When the brake pads get very thin, those sensors rub on the brake rotors, and the light illuminates in the dash indicating that it is time to replace the brake pads.
The light can also illuminate if something damages the wire to the sensor. I usually replace my pads before they get down to the sensors, so I re-use my old sensors. Although the wires are fairly well secured to the suspension, after a few years, the wires can get chaffed from the wind blowing them around, and the damaged wire can turn on the warning light.

Feb 27, 2011 | 2005 BMW X5

1 Answer

My 2001 BMW X5 locks up after the alarm is triggered and does not unlock. When I say locks up, I mean, all the doors are locked. The engine will not turn over. None of the lights, stereo, ANYTHING works...


Hey i have a 2001 BMW X5 i disconeted the batterie cable and put it back and everything work fine except my key alarm can anybody help??

Jan 25, 2011 | 2005 BMW X5

1 Answer

X5 - Overhead light not turning off and all doors are closed.


Check and adjust or clean the switch on the back passenger door.

May 26, 2009 | 2002 BMW 5 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...