Question about 2001 Dodge Durango

Open Question

Where is the map sensor located on 2001dodge durango 4.7,liter engine

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 82 Answers

SOURCE: 2001 dodge durango v8 4.7

It is acually called the vehicle speed sensor I do believe. It should should be located on the top of your transmission with a wiring harness attached to it. It should also have 1 bolt holding it in also. Whatever you do, do not rotate the gear when you remove it. Try to mark the exact way it came out when you replace the sensor. When you pull the sensor out it will have this gear attached to it which will need to be placed into the new sensor and put back into the vehicle in the same way it came out or you will throw a code and it will not be pretty. Good luck, hopefully I didn't scare you it can be a simple repair just mind your P's and Q's.

Posted on Jan 07, 2009

Cutlass85
  • 10 Answers

SOURCE: loacte the fuel filter on 2000 dodge durango 4.7 liter v8

if i am not mistaken the fuel filter is built into the fuel pump. which requires you to drop the tank and replace both.

Posted on Jun 01, 2009

  • 10 Answers

SOURCE: 2001Dodge Durango power steering is stiff

Get it to a shop you may have a power steering censor leak. If your handy read on.. Check the fluid level if it's low don't add more change the censor first then refill. The issue is the fluid travels through the censor into your wiring harness to your computer and other censors shorting everything out. If your fluid is low pull the censor wire off it's next to the fill tank on the pipe connected to it, if you see fluid in that wire bring this truck to Dodge. Or as I said before if your handy and you suspect this is the case, wright back and I'll give you a call and walk you through this. This is a common serious problem the can destroy your computer and possibly you engine. It can be fixed for under a hundred dollors.

Posted on Jun 05, 2009

Molson02536
  • 3854 Answers

SOURCE: Map sensor location

If you are looking at the motor from the front of the car it is on the right side of the plenum it has a wire hook up and it gets vacuum straight from the plenum its just a square box don't look like its important . Hope this makes some sense. 

Posted on Jul 01, 2009

  • 1244 Answers

SOURCE: crank sensor location for 2002 durango 5.9

should be on the drivers side back of motor stuck in the tranny bellhousing at the top held in by either a 10mm bolt or a 12 mm

Posted on Jan 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where isthe cam sensor 2001dodge durango exactly located


best I can do is provide you an image. It is position 2.
th?&id=hn.608023616843678251&w=300&h=300&c=0&pid=1.9&rs=0&p=0this is a visual of what Mr. BrokRench explained.

Jun 28, 2014 | 2001 Dodge Durango

1 Answer

IAIR FLOW SENSOR LOCATION 1998 DODGE DURANGO 5.9


Your vehicle is not equipped with a Mass Air Flow (MAF) sensor, but it does have a Manifold Absolute Pressure (MAP) sensor. Here is a picture of where it is located.

93_cr99duran_14-030b.png&width=560&height=467&displaytype=display&imgrotation=&links=

Sep 21, 2012 | 1999 Dodge Durango

1 Answer

Does a 2002 dodge Durango with a 4.7L engine have a mass air flow sensor and if so where is it ?


No mass air flow sensor but if you are talking bout MAP-Manifold Absolute Pressure Sensor
The write up is right here

http://www.ehow.com/how_7974375_replace-1999-durangos-map-sensor.html


Hope this helps

Positive Feedback ALWAYS Appreciated :)

Mar 06, 2011 | 2002 Dodge Durango

1 Answer

WHERE IS THE LOCATION OF THE MAP SENSOR?


5.3 liter engine? see below.

jturcotte_963.gif

If you have the 4.2 liter engine, it is similar--MAP sensor is mounted on the intake manifold and actually sticks itself into a hole on the manifold.

Feb 01, 2011 | 2003 Chevrolet TrailBlazer

2 Answers

I need to find the intake air temperture sensor in my dodge


depends on the engine...
3.7 liter, #1 below:

jturcotte_112.jpg

4.7 liter:

jturcotte_113.jpg

5.7 liter, #2 below:

jturcotte_114.jpg

Jan 01, 2011 | 2006 Dodge Ram 1500

1 Answer

Where is camshaft position sensor locate at? for dodge durango 2000 ,4x4 5.9 liter.And how much it cost?thz


Under hood, center, upper engine area, rear of intake manifold, mounted in distributor. I believe you have to replace the whole distributor, runs about $115.00 with your old core.

Jun 02, 2010 | 2000 Dodge Durango

1 Answer

How hard is it to replace the MAP sensor on a 2001 dodge durango?


VERY SIMPLE!!!!!

4.7L The MAP sensor is located on the front of the intake manifold. An O-ring seals the sensor to the intake manifold.
  1. Disconnect electrical connector at sensor.
  2. Clean area around MAP sensor.
  3. Remove 2 sensor mounting bolts.
  4. Remove MAP sensor from intake manifold.
To Install:
  1. Clean MAP sensor mounting hole at intake manifold.
  2. Check MAP sensor O-ring seal for cuts or tears.
  3. Position sensor into manifold.
  4. Install MAP sensor mounting bolts (screws). Tighten screws to 3 Nm (25 inch lbs..) torque.
  5. Connect electrical connector.

Apr 23, 2010 | 2001 Dodge Durango

1 Answer

Which spark plug is for the #2 cylinder on a 2001Dodge Caravan


2001 Dodge Caravan FWD
3.3 liter V-6 VIN "R"Cylinder # firewall, Passenger to drivers side, 1-3-5
Cylinder # radiator, Passenger to drivers side 2-4-6

Coil Block post # firewall, Passenger to drivers side 5-1-3
Coil Block post # radiator, Passenger to drivers side 2-4-6

Good luck

Nov 28, 2009 | 2001 Dodge Caravan

2 Answers

My check engine light is on. The code is P0121


I believe all the Mopar OBDC codes are the same. A list of the 2001 codes were posted on a PT Cruiser site here: 2001 Chrysler codes

Your error says the throttle position sensor and MAP sensor disagree with each other

Jun 22, 2009 | 2001 Dodge Durango

1 Answer

1991 buick regal , 3.8lt,


1991 3.8 liter engines used a Mass Air Flow sensor in the intake tract (measures incoming air) instead of a MAP sensor. The MAF sensor is located on the engine just behind where intake hose is attached.

Jul 04, 2008 | 1991 Buick Regal

Not finding what you are looking for?
2001 Dodge Durango Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...