Question about 2004 Hyundai Elantra
Starter not getting power when you turn the key
It has a neutral safety switch that prevents you from cranking the engine in gear.
Posted on Dec 11, 2012
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
at the bottom and top of the switch there are retaining tabs. you can try to pop it out at those points with a flathead screw driver, but it is sometimes easier to just remove the door panel to get it out.
Posted on Aug 13, 2009
Wayneard is correct. with one hand on the ignition key try to turn the key towards start. With your other hand hold the steering wheel and turn slightly in either direction. This will take the locking pressure off the ignition cylinder. To prevent this from re-occuring be sure steering wheel is in a straight position before removing key from cylinder. Then be sure not to use steering wheel as a lifting point to get out of the car. If you do the wheel will move into a locked position, which is what you are experiencing now. Keep me posted
Posted on Dec 19, 2008
yes , you need to remove the headlight cover from the back after u move the bulb conector then there is a holder for the bulb u need to push down then move.
i hope it help ,,,, thanx
Posted on Mar 16, 2009
Jack up rear of car till tire is off the ground.
Remove lug nuts & remove wheel.
Remove phillips screw(s) from drum.
Using a hammer, strike the drum to loosen it from the hub.
Remove drum by simutaneously turning it and pulling it outward away from the vehicle.
Posted on Oct 04, 2009
First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.
Posted on Feb 07, 2010
Tips for a great answer:
Apr 19, 2011 | 2004 Hyundai Elantra
Mar 03, 2011 | 2004 Hyundai Elantra
Mar 12, 2010 | Hyundai Elantra Cars & Trucks
Feb 05, 2010 | 2004 Hyundai Elantra
Jan 15, 2010 | 2004 Hyundai Elantra
Oct 03, 2009 | 2000 Hyundai Elantra
Sep 21, 2009 | 2004 Hyundai Elantra
Nov 15, 2008 | 2004 Hyundai Elantra
Aug 07, 2008 | Hyundai Motor 1992 Elantra
Dec 27, 2015 | 2004 Hyundai Elantra
271 people viewed this question
Usually answered in minutes!