Question about 2002 Chrysler Sebring

1 Answer

CAR RUNS THEN WONT EXCLERATE AFTER IT GETS WORMED UP SPITS AND SPUTTERS.

Car wont excleaterate when it gets wormed up acts like it has a governer on it will hardley run and drive.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 21,873 Answers

Have you had the fuel pressure checked ?
Is the check engine light on ?

Posted on Dec 11, 2012

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pyroshain
  • 42 Answers

SOURCE: 5letting the car running for 20 minutes. After

My first guess would be that you have a bad fuel filter. Once a car sits for a while, all the sediment in the filter settles to the bottom, allow fresh fuel, when you first start it, to travel over it to the engine. After five minutes of run time, the sediments have stirred enought to clog the filter. But at high RPM's, there's enough vaccuum from the engine to pull it through the clog, which is why you were able to keep it running only after holding the pedal to the floor. The fuel filter would be an inexpensive first try.
If this does not fill your problem, go to Jiffy Lube and ask for a fuel injector flush, but that is costly.

Posted on Jan 02, 2010

  • 1 Answer

SOURCE: Spit and sputter/2004 PT Cruiser

Change cam and crankshaft sensors

Posted on Dec 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 buick lesabre spits sputters voltage jumps


check you have good earthing points, also check the earthing strap from engine to shell. main earthing point follow the negative lead it will go to the shell.

Jul 26, 2017 | 2002 Buick LeSabre

1 Answer

Spits and sputters


it\'s your TPS! well Greg first clean intake with toothbrush and carb cleaner! when it gets dirty the throttle position sensor doesn\'t know where it it so it will act like that, so it\'s a good idea to clean it first.

Mar 25, 2013 | 2004 Dodge Intrepid

1 Answer

2004 nissan titan = starts and runs fine for a while - and then spits and sputters and wont run for a while - then runs fine for a while - then spits , sputters, and wont run any...


Not sure to be honest as to what the cause could be ,i would suspect a coil pack problem or even the ignition module if it has one but i think it may be built into the ECU ,although you havent stated if this is a diesel engined vehicle so having more information would help a great deal

Oct 28, 2011 | 2004 Nissan Titan

1 Answer

Hi i have a checy silverado 1500 with a v8. I started it and it ran fine...when I noticed my engine light start to blink the truck acted like it was going to spit and sputter but just stalled out. When I...


Read the codes off of the computer using an OBD-II Scanner to get a clue as to what is wrong. The codes from when it was sputtering will likely be stored in the computer.

Good luck.

Jun 29, 2010 | 2003 Chevrolet Silverado 1500

1 Answer

My runs fine for a little while then starts to spit and sputter like it is starving for fuel.


Hook a fuel preasure gauge to it and run it until it acts up then check the preasure, if the preasure goes low ,replace the fuelpump.

Jun 09, 2010 | 1993 Jeep Wrangler

1 Answer

I have an 86 ford ranger. After it worms up, it


I had a problem with my 86 bronco II, 2.9EFI. Found it to be the water temp sensor. To test, after warm up, unplug sensor and place a jumper wire between contacts on harness. Sensor is behind upper rad hose on manifold, two wire plug. Then test. Note: Rig will be HARD to start cold without the sensor plugged in.

Jun 07, 2010 | 1986 Ford Ranger 2WD

1 Answer

Sportage won't run


no spark but 12v at coils

Jun 04, 2009 | 2002 Kia Sportage

2 Answers

Acts like it aint getting gas


Have you changed the fuel filter.If you have run a temerary feul pipe from the tank to the carb sounds like a fuel restriction,

May 30, 2009 | 1995 Dodge Neon

Not finding what you are looking for?
2002 Chrysler Sebring Logo

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...