Question about Cars & Trucks

Open Question

Where can i buy the speedometer for kawasaki bajaj 135 rouser

Model sprint(JD) instrument cluster bal.p.no: JD 40 2401 pricol p.no.: C 10 3337 vendor code 106666

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 18 Answers

SOURCE: 1991 Volvo 740GL Speedometer

I remove two panel underneath the steering column. The first panel is removed using a 10 mm socket. The second panel is removed using a torx socket (can't remember the size). Removing these two panels gives you room to get to the clip on speedomter. Looking at the speedometer, you should see two rectangular holes on each side of the speedometer cover. I use a awl to push in the clip (you could use a screwdriver). Looking underneath the dash, you should be able to see the clip you are pushing on with the awl. I take my 2nd awl and put it behind the clip. I get the left side to release. One the speedometer cover releases, you can see the speedometer. You will see the 4 torx screws (t20) and two smaller clips holding the speedometer. All that is left is the wiring. (I take a sharpie pen and mark one of my wire locations on the speedometer. I am not sure what it does. It is a single wire.)

Posted on Aug 20, 2008

Ad
  • 1 Answer

SOURCE: instrument cluster panel

The transistors are BST80, the numbers are just SMD codes, but the reason to make transistor to fail is the illumination layer is faulty. There is also a transformer which may have open circuit You should check that either

Posted on Oct 30, 2008

  • 8 Answers

SOURCE: 2004 Chev Venture- Speedometer has stopped working

how is your shifting, usually a bad speed sensor will set a check engine light and may cause shift errors, this trans has a internal and external speed sensor, the pcm uses the external for shift and for cruise and for also cruise control. A quick no scanner way to tell is if your cruise is working, if it is then your most likey looking at a bad cluster, take it from me i'm a master gm tech. if i don't have a scanner to do a guage sweep it's like having a broken arm while fixing these. but this should help you out.

Posted on Jan 06, 2009

  • 48 Answers

SOURCE: 2000 Chrysler Voyager Instrument Cluster is dead

have you got a dimmer switch on your model to dim the dash lights. if you have it may be faulty. link the cables together if the lights work the switch is faulty. if you have not got a dimmer switch
your printed circuit on the back of the dash may be faulty or the plug in the back of the dash is not pushed all the way in. hope this helps

Posted on Apr 16, 2009

frankzen
  • 19 Answers

SOURCE: My bmw 318is instrument cluster doesnt work

Common problem on BMW's apparently...there are on-line repair services but they are NOT cheap...100-300 bucks. Tough to fix yourself...unles you are a highly skilled techie!

Posted on May 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998'Ford Explorer and half the dash lights are out and all pod a sudden my speedometer just quit. Need to know what fuses would go to these, so I can try that. Ty


Sorry but it's not a fuse problem . There is not a fuse just for the speedometer . The microprocessor inside the instrument cluster determines where the speedometer needle points , just like the fuel gauge , tachometer etc... Having the vehicle checked for DTC'S would be the proper step to take .
Vehicle Speed Signal
The vehicle speed signal is generated by the rear anti-lock brake sensor and sent to the 4-wheel anti-lock brake system (4WABS) module. The 4WABS module sends the vehicle speed signal via circuit 679 (GY/BK) to all systems which require a vehicle speed signal input.
Speedometer
The electronic speedometer receives a speed signal from the 4WABS module.

  • The Speedometer/Odometer Is Inoperative
  • Circuitry.
  • Speedometer.
  • GO to Pinpoint Test E .

No where in this factory diagnostic step does it say to check a fuse !

PINPOINT TEST E: THE SPEEDOMETER/ODOMETER IS INOPERATIVE CONDITIONS DETAILS/RESULTS/ACTIONS E1 CHECK THE VOLTAGE TO THE INSTRUMENT CLUSTER
Instrument Cluster
Measure the voltage between instrument cluster C288-7, circuit 1001 (WH/YE), and ground.
  • Is the voltage greater than 10 volts?
Yes GO to E2 .

No REPAIR circuit 1001 (WH/YE). TEST the system for normal operation.
E2 CHECK THE INSTRUMENT CLUSTER PRINTED CIRCUIT
Instrument Cluster
NOTE: Measurements must be made to the speedometer gauge pins that are inside the instrument cluster printed circuit clips.
    Measure the resistance between the speedometer pins (which can be seen in the middle of the instrument cluster printed circuit clips) and the corresponding instrument cluster terminal. Refer to the table for the pin and terminal assignments.
    Instrument Cluster Terminal Speedometer Gauge Pin C286-13 C287-1 S C287-2 G C288-7 BATT
    .

  • Are the resistances less than 1 ohm?
Yes GO to E3 .

No INSTALL a new instrument cluster printed circuit. REFER to Instrument Cluster Printed Circuit . TEST the system for normal operation.
Your best bet , take it to a qualified repair shop

Mar 30, 2017 | Cars & Trucks

1 Answer

Speedometer stopped working after fitting an alarm. What could be the problem?


Put everything back the way it was and see if speedometer starts working again?
Newer instrument clusters, the gages are not hardwired, The cluster receives buss data telling the instrument what to do with gages and speedometer. Checking the speedometer/vss sending unit would be a thought. Hopefully, you didn't hurt the instrument cluster?
What is year--make--model?

Apr 26, 2016 | Cars & Trucks

1 Answer

How do you replace the speedometer cable in a 1998 chevy tracker


Removal Procedure
  1. Remove the instrument cluster assembly. Refer to Instrument Cluster Replacement .
  2. Unhook the speedometer cable from the heater case.
  3. Remove the grommet from the bulkhead.
  4. Feed the speedometer cable through the bulkhead.
  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Unscrew the speedometer cable (1) from either the transfer case or the transmission. Remove the speedometer cable (1) from either the transfer case or the transmission. Remove the speedometer cable (1) from the clamp. Remove the speedometer cable (1) from the vehicle.
Instrument Cluster Replacement
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Disconnect the negative battery cable. Remove the hazard lamps switch by gently pulling the knob straight up. Remove the instrument cluster bezel from the instrument panel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement . Remove the 4 screws and pull the instrument cluster assembly forward from the instrument panel. Disconnect the 3 electrical connectors. Remove the speedometer cable at the speedometer head. Remove the instrument cluster assembly from the vehicle.
Remove the 5 screws (2) and the steering column upper and lower covers (1, 3).
Remove the 4 screws and the instrument cluster bezel from the vehicle.

Jun 17, 2015 | 1998 Chevrolet Tracker

2 Answers

Can the electronic speedometer be fixed?


what make , model an year vehicle do you have ? Most vehicle's you would have to replace the instrument cluster ! GM vehicles - Chevy , Cadillac , GMC , Buick , Pontiac , Oldsmobile you can replace the stepper motor that controls the speedometer ! How to repair GM Instrument Cluster Speedometer Gauge Stepper

Apr 27, 2015 | Cars & Trucks

1 Answer

What is the location of fuse for speedometer on 2o04 ford explorer


Speedometer The instrument cluster receives the vehicle speed sensor (VSS) signal from the powertrain control module (PCM) through the standard corporate protocol (SCP) communication network. The instrument cluster monitors the VSS input from the PCM and commands the speedometer with a corresponding movement of the pointer.
  • The speedometer/odometer is inoperative
  • Circuitry.
  • Powertrain control module (PCM).
  • Instrument cluster.
  • Go To Pinpoint Test L .
PINPOINT TEST L: THE SPEEDOMETER/ODOMETER IS INOPERATIVE Test Step Result / Action to Take L1 RETRIEVE THE RECORDED DTCS FROM BOTH CONTINUOUS AND ON-DEMAND INSTRUMENT CLUSTER SELF-TESTS
  • Use the recorded instrument cluster DTCs from the continuous and on-demand self-tests.
  • Are any instrument cluster DTCs recorded?
Yes
If instrument cluster U1123 is retrieved, REFER to Powertrain Control/Emissions Diagnosis (PC/ED) manual to continue diagnosis.

For all other instrument cluster DTCs, REFER to the Instrument Cluster Diagnostic Trouble Code (DTC) Index.

No
For inoperative speedometer, GO to L2 .

For inoperative odometer, GO to L3 . L2 CARRY OUT THE SPEEDOMETER ACTIVE COMMAND USING THE DIAGNOSTIC TOOL
  • Connect the diagnostic tool.
  • Key in ON position.
  • Enter the following diagnostic mode on the diagnostic tool: Instrument Cluster Active Command.
  • Select the instrument cluster speedometer active command.
  • Trigger the speedometer and scroll in increments of 10% while monitoring the speedometer. The speedometer should increase in increments of approximately 20 km/h (12 mph) for each 10% change.
  • Does the speedometer increase within specifications?
Yes
REFER to Powertrain Control/Emissions Diagnosis (PC/ED) manual to continue diagnosis.

No
GO to L4 . L3 MONITOR THE INTEGRATED CIRCUIT DISPLAYS
  • Key in ON position.
  • Monitor the compass, air temperature and message center functions of the integrated circuit display.
  • Do the compass, air temperature or message center displays operate correctly?
Yes
GO to L4 .

No
Go To Pinpoint Test AE . L4 CHECK FOR CORRECT INSTRUMENT CLUSTER OPERATION
  • Disconnect all instrument cluster connectors.
  • Check for:
    • corrosion
    • pushed-out pins
  • Connect all instrument cluster connectors and make sure they seat correctly.
  • Operate the system and verify the concern is still present.
  • Is the concern still present?
Yes
INSTALL a new instrument cluster. REFER to Instrument Cluster in this section. TEST the system for normal operation.

No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the self-test. There isn't a fuse just for the speedometer , there are four fuse for the whole instrument cluster . If one of these fuse's were burnt you would have more then just the speedometer not working ! You need to have a scan tool to find out what is up ! you could need a new cluster ! Is the check engine light on ? if not wouldn't think vehicle speed sensor bad , besides speed info for speedometer PCM uses for transmission shift points ! Good luck ,hope this helps !

Mar 17, 2015 | Ford Cars & Trucks

1 Answer

1990 HONDA CIVIC DX ENGINE LIGHT ON


More info needed. Is this a hatch back, sedan, or CRX? Is the odometer mechanical [old style] or digital [LCD numbers] The vehicle speed sensor [located behind the speedometer in the instrument cluster] drives both the speedometer and the odometer [mileage meter]. It sounds like an electric problem in the instrument cluster. Remove the instrument cluster and take it to your local speedometer repair shop. Look in the yellow pages for them. Or simply buy and install a used instrument cluster from a junk yard.

Nov 10, 2011 | 1990 Honda Civic

1 Answer

Speedometer will not return to "0" is the speed sensor the likely cause?


No this not the speed sensor, it is a bad stepper motor in the instrument cluster. These are known to go bad sometimes. There are vendors on Ebay that repair the clusters, if you are able to remove the cluster from the vehicle.

Aug 09, 2011 | 2003 Chevrolet TrailBlazer

3 Answers

My speedometer on my 2005 AMC Pick up isn't


Pretty common problem with these. Here's a guide to learn how to fix GM instrument clusters yourself, I used it to fix mine and it worked great.How to guide for Silverado instrument cluster repair
Pretty common problem with these. Here's a guide to learn how to fix GM instrument clusters yourself, I used it to fix mine and it worked great.How to guide for Sierra instrument cluster repair

Jul 15, 2010 | 2005 GMC Sierra

2 Answers

I think my speedometer cable is disconnected somewhere uderneath my car, because my speedometer is not working at all. where is the speedometer cable located underneath my car?


If your's has one it hooks in the side of the transmission. Most newer cars are electronic. There is a small motor that drives the speedo. After you get the instrument cluster out it is easy to change. Make sure you can buy the motor before you take the cluster out.

Jan 06, 2010 | 1992 GMC Yukon

1 Answer

Speedometer stuck at 20 miles an hour?


My 96 did the same thing. The speed sensor is and was fine -- the problem is an open circuit in the wires inside the gauge itself.

The Chilton's manual has pretty good instructions on how to replace the instrument cluster. You can buy just the speedometer gauge, or an entire instrument cluster for $100 or so on eBay. Just be sure you get a cluster that matches your model and trim line -- the LX and DX have different clusters, and of course the automatic and the 5-speed are different as well.


Do be sure to disconnect the battery before you begin the project, as there's a (slim) chance you can discharge the airbags if you don't

Oct 01, 2009 | 1996 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...