Question about 2006 Chrysler Pacifica

1 Answer

Fix the 2 broken bolts where my tire goes on at?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,101 Answers

Any garage can do it ,but be careful some charge a lot

Posted on Dec 11, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Rear Tires: Balding

if it has independent rear suspension then have the suspension rubbers checked and replace if necessary. Next for all wheel alignments it is essential that the rear end is aligned first to stop this tyre wear before the front wheels are aligned . IF you have leaf springs at the rear check for axle alignment and broken centre bolts or worn rubbers at the centre bolt mounts.

Mar 24, 2014 | 2003 Buick Rendezvous

1 Answer

Why does my suzuki wagon r shake

one cylinder missing,2 harmonic balance damage 3 engine or gear box mount broken 4sum of your tires out of balance5 suspension bolt loose? tire rim bent bearing loose.

Aug 14, 2012 | Suzuki Wagon Cars & Trucks

1 Answer

Back pass side tier is wobaly. can u help?

The Tire may become wobbaly if it has not been tighten down properly or if some of the bolts that hold it on have become lose or broken.

I would suggest you jack the car up just enough to take most of the weight off the tire but not all the way up. You want to be able to tighten the bolts down without the tire spinning on you but still be able to get the bolt to tighten the Rim (Tire) down all the way.

Check all the bolts to be sure they are not broken. If they are broken you will need to replace them. If the bolts are ok then tighten them down but be sure to start at the top one. Then tighten the opposite bolt, never the one beside the one you just finished but always the opposite bolt. Tightening the opposite bolts until all the bolts are tight will allow your Tire (Rim) to be tightened evenly and should stop the wobble.

Another thing to look for is a loose hub cap giving just the apperance of a wobbely tire but it is just a lose hub cap.

If you have driven through a pot hole or over a curb recently then you may have damaged the Rim the tire sit on or the tire itself and that would mean the tire or rim would have to be replaced.

Lastly you may have a worn out ball joint. In this case it would need to be replaced by a shop as it is very difficult to do if you do not have the correct tools.

Jun 19, 2011 | 2001 Chevrolet Impala

1 Answer

Broken lug nuts

Get how ever many wheel bolt's you need and one more lug nut, you will used that one to press in new wheel bolt, any parts place will have these parts, remove tire with hammer hit broken stud till it come's out through the back side, put new wheel bolt and with extra lug nut press in bolt, hope this was very helpful.

May 20, 2010 | 2004 Ford F150

1 Answer

95 eagle talon broken lower control arm how do i fix?already bought new control arm.

Jack the car up and remove the tire. Use a ball joint separator on the front lower control arm and remove the remaining 2 bolts, if working on the rear lower control arm, remove the 2 bolts holding the arm in place and install the new control arm.

An alignment is recommended when changing any part of the suspension, especially control arms, tie rod ends, etc.

Nov 19, 2009 | 1995 Eagle Talon

2 Answers

Rear wheel wobbles can't drive

That would be the rear control arm. You can provide a temporary fix using a 1 foot piece of 1" square steel tubing and 2 u-bolt brackets that fit over the broken arm (at any hardware store). Center the piece of tubing on the break inside the U of the control arm. Fasten the U bolt brackets 2" in from the ends of the square tube. This will last quite some time so you can get it replaced at a later date.

Sep 28, 2009 | 1997 Chevrolet Lumina

1 Answer

Rear tire lug bolts

You have to remove the tire/wheel assy. remove the brake drum, you will see the spindle with the bolts there. punch out the broken bolts install new buy pushing thru the hole.Find some regular nuts that will fit over the stud, put your new nuts on and tighten up till flush in back.

Jun 07, 2009 | 2003 Chevrolet Cavalier

1 Answer

95 corolla cant get broken lug bolt out

have you tried heating the drum?  Take it to a tire place and have it pressed out.  However, you should be able to just hammer it out.

Mar 23, 2009 | 1998 Toyota Corolla

1 Answer

2 lug bolts on my 4 lug bolt tire broke off.

assuming the bolts that broke, broke while the vehicle was in motion,
the wheel is bent
when the broken bolts were at the bottom, there was twice as much leverage between the wheel edge and the other bolt, and nothing to restrain the near edge, it would bend like cardboard
replace the wheel

Nov 05, 2008 | 1995 Mitsubishi Galant

1 Answer

The bolts that my tire goes on are missing and stripped how do i fix it or how much is it going to cost me if i can not do it ?

I have gone to an automotive machine shop and they had new bolts ready for me to buy. They pressed the new bolt in with a hydraulic press. Ten bucks, all done.

If you can't do this, you'll have to buy a new brake disk or a rear axle...depending on which corner has broken bolts.

Jul 14, 2008 | 1996 Ford Aerostar Extended

Not finding what you are looking for?
2006 Chrysler Pacifica Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides