Question about Chevrolet HHR

Open Question

After plugging progressive snapshot into my car,my abs and traction control lights do not work properly.has anyone had this problem.

I have had the car checked out completely by my mechanic and has tried several different modules for the abs they has checked all wiring and they believe it is working correctly,just lights are still on.the problem started right after I plugged progressive snapshot into my car.could this have messed up the cars computer.

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: ABS and Traction control stay on after smart car is started

Although I am unfamiliar with the smart cars, it sounds like you just need to reset your computer. Remove the negative cable from your battery, then flip your lights on, pump the brakes, press the horn. What this will do is drain all the capacitors including the ones in your computer. Ultimately it will reset your computer (aka turn off the ABS and TC light) hope this is helpful and good luck

Posted on Feb 04, 2009

chuck943
  • 783 Answers

SOURCE: 2001 Mercury Grand Marquis brake and ABS dash lights on and off

The red brake light is the key here. That usually indicateds a hydraulic problem. Check you fluid level in master cylinder and see if it is low. Also the level indicator sensor there in the master cylinder maybe sticking or corrioded. If ABS sees the red brake light it will shut off and turn on the ABS light,also traction control would be disabled as well.

Posted on Feb 05, 2009

wyatt1582
  • 453 Answers

SOURCE: abs and traction control light faults after a brake job. 2005 Pontiac grand prix

You have a bad sensor at one of the tires that need replacing that operates ABS and traction control. If you take it in to a shop it will run $130 but they can find which sensor is causing the problem. But if you do it you might have to replace all 4 sensors to make sure you got the right one. Every hard to diagnoses. Its better for the shop cause they can get electrical read outs for each sensor.

Posted on May 21, 2009

  • 1 Answer

SOURCE: traction control light comes on while driving in good weather

My 2002 Millenia just started doing this the other day, while on the freeway when it started doing it i would shut engine off and restart it and it would be good for a while then it would do it again, i am still looking for solution, has any one found one?

Posted on Jul 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Abs light came on


What it looks like: The traction control warning light typically takes the form of the acronym "TC." Sometimes this light is a small illuminated picture of a car losing control What it looks like: The traction control warning light typically takes the form of the acronym "TC." Sometimes this light is a small illuminated picture of a car losing control. How this system works: Traction control uses wheel speed sensors to detect when one or more of the car's wheels lose grip and traction. When the system registers a loss of traction in one or more of the wheels, a computer will limit power to the wheels that are still in solid contact with the road to prevent a skid. Common reasons for this to happen:
  • ABS is malfunctioning: Traction control and ABS (anti-lock braking system) often share the same control module and internal self-diagnostics system. As a result, sometimes an issue in the ABS can trigger the traction control light. If this is the case, then both the ABS and Traction Control lights will be on.
  • Broken wheel speed sensors: Wheel speed sensors are usually in the wheel bearing assembly, and determine the rate at which each wheel is moving. The sensors relay that information to the traction control module, which determines whether or not power needs to be shifted. Wheel speed sensors can get dirty or damaged and stop working, which prohibits the traction control module from knowing when to enable the system.Traction control module is faulty: The traction control module - which, again, is often shared with the ABS - can malfunction and break altogether, causing the system to stop working. What to expect: A top-rated mobile mechanic will come to your home or office to determine the source and cause of the traction control issue, and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs. How important is this service? It's important to have the traction control issue investigated as soon as possible, as adverse driving conditions can arise at any time. While your car is unlikely to incur further damage from a faulty traction control system, it won't be safe to drive in rain, snow, sleet, or other inclement weather, or even possibly through pools of water on the road. Furthermore, the issue that is causing the traction control light to illuminate could also be impacting the ABS.

Sep 30, 2016 | 2006 Pontiac Torrent

2 Answers

We have a 2002 Ford Taurus with 77000 miles. It was running great but now when we hit the highway or when we go around 50-60 mph the trac control indicator goes off and the car don't accelerate. It feel...


Sounds like you have a bad speed sensor on the ABS. Have the ABS scanned for codes. If you want to test this, unplug one of the speed sensors. The ABS light should come on and disable the traction control system. Then the transmission should work fine. If it does, diagnose the ABS/Traction control system.

Jul 07, 2009 | 2002 Ford Taurus

1 Answer

Light abs traction control stays 1998 buick park avenue


PRE-DIAGNOSTIC INSPECTIONBefore diagnosing ABS/TCS, perform a comprehensive visual inspection of system as follows.Check ABS/TCS wiring harness connectors for looseness. Check harness routing; pay particular attention to wheel speed sensor wiring harness routing. Check fuses No. 1D, 5B and 6B in instrument panel fuse block. Check fuses No. 1 and 2 in underhood fuse block. Check brake fluid level in master cylinder reservoir. Check brake fluid level in Pressure Modulator Valve (PMV) assembly reservoir. Ensure parking brake is fully released. Ensure parking brake switch is functioning properly. Always perform ABS/TCS system functional check before using DIAGNOSTIC CODE CHARTSThe EBCM/EBTCM has self-diagnostic capability, which can detect system failures. Fault codes stored by EBCM/EBTCM can be displayed using Tech 1 scan tester. There are no provisions for flash code diagnostics.Begin ABS/TCS diagnosis with PRE-DIAGNOSTIC INSPECTION procedure. If failures are found during pre-diagnostic inspection, perform necessary repairs, and proceed with ABS/TCS FUNCTIONAL CHECK. See Fig. 5 .If no failures are found during pre-diagnostic inspection, go to ABS/TCS FUNCTIONAL CHECK. See Fig. 5 . The ABS/TCS FUNCTIONAL CHECK will either indicate ABS/TCS is functioning properly or direct technician to various diagnostic procedures such as diagnostic charts, symptom diagnosis or BRAKE warning light diagnosis.CHART D - TRACTION OFF WARNING LIGHT ON CONTINUOUSLY & NO DTC SET (BUICK WITH UH8 OR U2A INSTRUMENT CLUSTER)Circuit DescriptionWhen ignition switch is first turned to RUN position, EBTCM goes through a self-test, which lasts 2-4 seconds. During self-test, EBTCM commands TRACTION OFF indicator warning light on. Powertrain Control Module (PCM) can also command EBTCM to set a Code 75 which will illuminate TRACTION OFF indicator.Traction control switch is located either on instrument panel center trim plate or driver's front door trim panel. Switch allows driver to select traction control mode (on/off). When traction control system is turned off, TRACTION OFF warning light comes on.EBTCM monitors transaxle temperature through

Jul 12, 2014 | 1998 Buick Park Avenue

1 Answer

2003 lincoln ls traction control always on


Have the ABS Braking System tested

You most likely have a Bad Wheel Speed Sensor

The Control Switch on console does absolutely nothing,I know
I have a 2004 LS

You can not disconnect a thing
I have the factory wiring diagrams &
the answer is no

You have dash lights on-- why have you not checked for
codes & resolved the problem,same procedure when
ever any dash light stays on after motor is running

An dash light on you have an OBD2 system failure

Oct 18, 2012 | 2003 Lincoln LS

1 Answer

Is the car safe to drive when the ABS, Service and the Traction Control OFF lights are on?


Truthfully, yes. But not as safe with the ABS and traction control systems working properly. The ABS system probably just needs a new sensor (located on the inside of the wheel) they are very easy to fix yourself if you want to take it on, just reply back and I can tell you how. The traction control is off because the ABS system is not working properly and it will not work until you fix the ABS. Depending on why the Service light is on may be another problem entirely, so I would take it to your local car parts place to see why the light is on, if it's related to the brakes, then it's all one thing. If it is something else, the car may not be safe to drive related to the engine light. I hope this helps! Good Luck

Jan 16, 2011 | 2000 Pontiac Sunfire

2 Answers

Abs, brake and traction control light stay on. how do i reset them


I have a 2001 Cadillac Deville with 105,000 miles. The ABS and Traction Control light stay on. What could be the problem? Could I reset the ABS and Traction Control light?

Jan 09, 2011 | 2001 Cadillac DeVille

1 Answer

The traction control off light and the abs light came on at the same time. It does not seem to affect the driving. Any suggestions?


You probably have a bad abs sensor on one of your wheels, usually the traction control system will disable its self when the abs system is not working properly. The sensors aren't very expensive to replace (if you have any mechanical knowledge, you could do it yourself easily, they pretty much just screw on and have an electrical clip, you could also check them to see if one came unplugged), and when it's fixed the traction control will reengage its self automatically. It won't affect the driving unless you get yourself into a situation where you need the abs or traction. I would get it fixed sooner than later though. Some insurance companies will check the computers on cars if theres an accident and if your car was 'improperly working' at the time they could pin an accident on you. Drive safe!

Jan 02, 2011 | 2002 Buick LeSabre

3 Answers

Traction control and anti-locks(ABS) lights come on.


Traction control and anti-locks(ABS) lights come on there is sensors that are pluged in behind the rotors check and see if they are disconected or loose sometimes when you change your brake pads they might come loose and not making contact.

Jul 06, 2010 | 1998 Cadillac DeVille

3 Answers

Abs light and traction control light


Hi ,
Take it back and tell them to code it properly! F.O.C.

Jul 11, 2009 | 2002 Audi A4

2 Answers

ABS/TRACTION CONTROL WARNING LIGHTS ON


Sounds like they may have left something disconnected like the ABS/ Traction control wheel sensor, make them fix it!!

Sep 08, 2008 | 1998 Cadillac DeVille

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...