Question about Ford Cars & Trucks
SUZU Trooper electric fuel pumps are almost always located inside the fuel tank, but there are some vehicles where the pump may be located along the frame rail or mounted to the body near the fuel tank.
KTAG K-TAG ECU Programming Tool
Posted on Dec 11, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Undo the fuel inlet Banjo bolt and carefully fish with a piece of wire bent at the end (as pictured) and fish out the filter (under the spring) wash and replace. Can be very fiddly, so patience is a must.
Posted on Dec 01, 2009
Well, one problem is, if its an 8.1, its not a diesel. The 8.1, or Vortec 8100, is a gas engine. The DuraMax is a 6.6 engine. There is usually not a priming system on a gas engine, because the fuel pumps will usually get it through the smaller filters used quick enough you dont need them. However, if it is a DuraMax engine, then right on top of the fitting where you mount your diesel filter, there is a primer pump and an air bleed valve. What you do is, open up that air bleed valve ( its a little black plastic octagon shaped thing on the top of the filter mount) then you pump the primer (the silver button looking thing) until you get diesel squiting out the air vent without too many air bubbles or gurgles.
Posted on Jan 23, 2009
I have the same problem and have trouble codes 35 and 36. I found out that there is a computer module that needs replaced as it sits low in a valley and gets hot and seperates. I am reseaching about the a/m fix that installs the new module away from heat.
Posted on Mar 12, 2009
simple : obtain replacement pump from parts provider (no used stuff)
Now help me out here: thats the year they were bolted to the pass side front of engine
and not inside the tank right? (better go look to see for sure)
using a tube wrench unscrew the fuel lines (i use large wire nuts to temp block off fuel leakage)
with a 12 mm wrench undo the two side bolts holding the pump to block
wiggle pump it should come straight off
clean mounting place on block with solvent let dry
silicone back (or use gasket that comes with pump ) of pump
apply pump to block (depending on where crank stopped you may have some tension on arm you will have to overcome to get flange to meet block )
use locktite (blue)or simmiliar thread lock on bolts retighten firmly but not hang up the dog tight
use light grease or vasolene on tube connections don't try to tighten dry
Now the fun part your diesel now has air in the fuel system
there are two ways to remove this ( hard and harder)
your choice here are both methods
loosten the fuel supply line for #8 injector ( I did not say remove) 1 full turn ought to be enough
crank engine 30 seconds only
wait 5 minutes for starter to cool down
crank engine 30 sec again
did it start but runs rough while it's still running tighten #8 injector (caution fuel under high pressure)
engine smooth out good your lucky
engine did not start yet
wait 5 minutes
crank engine 30 sec again
if so tighten #8 injector up
Now here's something I've done to my diesel to make this much less a hasstle
trace fuel line as it comes up from pump
obtain a small low pressure electric fuel pump and a two short pieces of fuel line
and a few clamps
use tube cutter and cut fuel line just before it bends to go in filter
slide tube and clamps over pipe (both sides)
insert pump observe flow arrrow towards filter
the wires of pump can be stretched over to #1 battery terminals
now any time you change a filter or open your fuel system for any reason
all you need do is connect pump to battery
open sharader valve on top of filter for a few min
and start truck as normal
then disconnect wires and stow away for another day
Posted on Jul 08, 2009
what year car is it fuel tank is located behind rear seat early xj 40 fuel pumps are under car near drivers rear door later ones pump in tank
Posted on Jul 18, 2009
Tips for a great answer:
May 06, 2015 | 2006 Opel Corsa Utility
Dec 30, 2014 | Ford Cars & Trucks
Oct 28, 2013 | Cars & Trucks
Sep 24, 2010 | 1991 Honda Accord
Jan 17, 2010 | 1999 Dodge Ram 2500 4WD
Nov 25, 2009 | 2005 Ford F 350 Super Duty
Nov 16, 2009 | 1992 Ford Econoline
Jun 01, 2009 | 1986 Dodge Ram 50
Mar 22, 2009 | 1995 Ford F350
210 people viewed this question
Usually answered in minutes!