Question about Chrysler Voyager

Open Question

P1389 in jeep grand cherokee 2001

Turns over wont start

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 20 Answers

SOURCE: 2001 Jeep Grand Cherokee which fuse controls heated seats?

Fuse # 20, located in the Junction Block (interior, drivers side). This is a ten amp fuse.

CLICK_HERE

Read the information at the above site. The TSB (technical service bulletin) may be of interest to you.

Posted on Nov 20, 2008

emissionwiz
  • 75235 Answers

SOURCE: Turn signals not working on 2001 Jeep Grand Cherokee

replace the turns signals flasher unit.

Posted on Mar 02, 2009

  • 6982 Answers

SOURCE: 1993 JEEP GRAND CHEROKEE LAREDO- TRUCK WONT

OK...I have a 93 outside...one diagram I have shows an ignition module next to coil...but there is none on mine, (4.0 engine)
Two items to check are crank sensor and cam sensor inside distributor. Test procedure can be found in just about any manual including haynes.
You will need a decent volt/ohm meter to do testing. You can also check codes by turning ignition switch on/off three times, leaving it on the third time. Check engine will flash code #'s (ex: one flash, pause two flashes= the number twelve.then followed by a longer pause then another set of flashes etc.)

Posted on Mar 05, 2009

  • 1 Answer

SOURCE: window motor replace 2001 jeep grand cherokee

You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.

Posted on May 01, 2009

  • 6982 Answers

SOURCE: 2001 Jeep grand cherokee motor knock 4.7 motor

First, if the noise is from the upper part of the engine and is more of a tapping than a knock, likely you have a problem in the valvetrain, most often a bad lifter or worn rocker arm. If the noise is low, deep inside, the noise is from a bearing. This is generally accompanied by lower than normal oil pressure. Regardless of the underlying cause, correcting the cause will not stop the knock. To do that correctly, the engine needs to be removed and all crankshaft bearings and the crankshaft itself need to be replaced (crank can sometimes be "undercut" and thicker bearing shells can be used depending upon the amount of wear.) If caught very early, sometimes only one bearing can be replaced in-car, but in 99% of all cases I have ever seen, most will fail again, sometimes more severely if done this way.

Posted on Dec 10, 2009

Testimonial: "Thanks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ok my 2001 Grand Cherokee Laredo wont stay in park


Transmission sticks in reverse- won't go into park. - JeepsUnlimited

www.jeepsunlimited.com/forums/showthread.php?...won-t-go-into-park
Jun 14, 2013 - 12 posts - ‎5 authors 2003 6 cyl 4x4 Grand Cherokee Laredo automatic- Occaionally, when shifting from REVERSE TO PARK, my Jeep will stay in reverse. Typically its ... '2001 WJ'4,0L'42RE'NV 242'380000 km'ECE Compliant' ??????????? ??? ...

2001 jeep grand Cherokee laredo - CarGurus

www.cargurus.com > Questions > Jeep > Grand Cherokee
CarGurusJan 27, 2014 - 2001 jeep grand Cherokee laredo - Just purchased a 2001 Jeep GrandCherokee Laredo and ... It starts in PARK sometimes and sometimes it won't and I have to start it in Neutral. ... Hatch shuts flush, but won't stay shut. help!

Oct 22, 2015 | Cars & Trucks

1 Answer

Have a 2004 jeep Cherokee that has a p1389 code in


gee 1, last year of Cherokee is 2001, so you meant Grand right??????
gee2, wont start or stalls, no other symptoms????? just 1 DTC, no others using a real scan tool? that be first huh?
Geewise 3, what engine, wow, wrong car, no engine or country.?

the FSM covers this, and the ASD has 8 ways to trip off line'
UP TO 8 ways , just like old wonder bread had.

answering for 2004 GC, (i actually look it up in the real book)
not google butchered DTCs.
P means power train, 1 means factory codes.
a 3 coin toss lands...
2004 GC, vin N, 4.7L v8 automatic,


it reads. verbatim.
Trouble Code: P1389
No Auto Shutdown Relay Output Voltage To PCM
Number of Trips to Set Code: 1
  • Catastrophicmonitor failure.
Trouble Code Conditions:
Engine cranking; and the PCM did not detect any voltage on the ASD Relay Output circuit to the PCM during the CCM test.
Possible Causes:
  1. ASD relay connector is damaged, loose or shorted
  2. ASD relay output circuit is open between the relay and PCM
  3. ASD relay power circuit is open (test power from Fused B+)
  4. ASD relay is damaged or has failed
  5. PCM has failed (nah)


it means, to me.
  • the relay is unplugged
  • or fuse blown "fused B+" (a top reason, world wide)
  • the relay is bad.

my buds ASD page,

http://www.fixkick.com/Jeeps/ASD.html

Oct 20, 2014 | Jeep Cherokee Cars & Trucks

1 Answer

I have a 2001 jeep grand cherokee drive it a while turn the engine off wont start back up


Your starter solenoid armature is sticking. It is mounted atop the starter and the heat from the exhaust manifold sometimes causes this problem on older systems. You can try a temporary fix by placing some type of heat shield over the solenoid using something that is fire proof but replacing the solenoid will eventually be necessary.

Nov 22, 2013 | 2001 Jeep Grand Cherokee

1 Answer

How can Iget the code to tell what is wrong with my 1999 jeep grand cherokee?


with the key on the check engine lite should start flashing if not you'll need a code reader

Aug 27, 2012 | 2001 Jeep Grand Cherokee

1 Answer

2001 jeep grand cherokee laredo wont start, tries but wont start


allways cheek your oil and cheek your hd Leeds and spark plugs

Apr 18, 2012 | 2001 Jeep Grand Cherokee

1 Answer

My left turn signal wont work in my 2001 jeep grand cherokee


IF LEFT TURN SIGNAL BULB GOOD.TURN SIGNAL SWITCH COULD BE FAULTY.

Dec 06, 2010 | 2001 Jeep Grand Cherokee

2 Answers

2001 jeep grand cherokee wont blow air through vents


there is a flap to redirect the air flow under the dash, it may be an item like a pen :) that has dropped down the vent opening stopping it from moving to redirect the air ... failing that, one of the motors/cables that operate the flap has failed

Dec 05, 2009 | 2001 Jeep Grand Cherokee

1 Answer

2001 Jeep Grand Cherokee Limited 4wd 4.7L won't start when hot


vehicle needs serviced fuel filter blocked hope this helps?

Aug 25, 2009 | 2001 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...