Question about Audi S4
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Lower hole in the door jamb loosten allen screw until the cap comes off. Upper hole there is a #20 torx slightly down and inboard of the hole, you need a really long torx bit and pull the handle out slightly. It also helps to pull weatherstrip loose so you can see it.
Posted on Aug 06, 2008
SOURCE: remove right rear door panel
IMPORTANT: Discard the old door trim panel retainers and replace with new retainers before installing the trim panel
Posted on Nov 04, 2008
Remove plastic plug on the inside of door there is 10 mm hole use a hooked pick set pick put through the hole and pull the plastic cir clip towards the back of the door that will release the smaller part of the outer handle then the handle itself can be taken out.this is so simple but so deceiving the actual cir clip is hard to notice because of all the plastic **** on the inside backing plate the cir clip is just on the inside of hole look hard it is 2mm thick & 20mm high (black plastic) place point of pick in between backing plate & cir clip hook it and pull back the front door is based on the same principle but is a lot easier
Posted on Jul 16, 2009
On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you need to pull back the weather seal and then you can access the bolts securing the outer handle
Posted on Nov 05, 2009
has to remove the inside panel door and remove the clip inside to open the handle cover then u can see the two nuts and remove them
Posted on Mar 28, 2010
Tips for a great answer:
Mar 24, 2014 | 2003 Toyota Avalon
Jan 03, 2011 | 2006 Toyota Highlander
Jaguar 2000-06 - Locks & Lock Systems
Power Door Locks - Removal & Installation
Door Lock Switch
Door Lock Diagnosis & Testing
Fig. Removing door lock actuator
Fig. Removing door lock motor-Sedan
Dec 31, 2010 | 2002 Jaguar X-Type
Apr 20, 2010 | 2003 Chevrolet Impala
Jul 15, 2009 | 2003 Suzuki Vitara
Jun 14, 2009 | 2002 Ford Expedition
May 22, 2009 | 2006 Chevrolet Silverado
Mar 24, 2009 | 1997 Lincoln Continental
Feb 12, 2009 | 1995 Mercury Grand Marquis
Nov 04, 2008 | 1998 Oldsmobile Intrigue
Apr 19, 2018 | Audi Cars & Trucks
30 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: