Question about 1997 Plymouth Grand Voyager

1 Answer

Windows not working. Turn signals and wiper blades not working.

First, driver side rear vent window went. Then, driver side front window went. Turn signals sometimes activated wiper blades prior to non-operation of both.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,101 Answers

Check the BCM bdy control module

Posted on Dec 10, 2012

  • ruscle2784
    ruscle2784 Dec 10, 2012

    Will do. Thanks for the suggestion.

×

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 96 Answers

SOURCE: My electric window on the drivers side and the

It is USUSALLY just the rocker switch in the door there. Water drips on it when window is open during wet weather. This causes the contacts under that switch to corrode. Those are simple an easy to replace. Pop off the inside door panel (screw under the inside door latch handle, 2 or 3 screws under the arm rest - then plastci pop screws all around the sides and bottom. these can just pull out. Then it lifts off the top ledge. turn it and you'll see the switch still attached to the panel. try cleaning - will probably need replacement.

Posted on Aug 17, 2010

wireguy212
  • 1627 Answers

SOURCE: neither the power window nor the rear vent on the

Check the harness going from the door to the inner fender for broken wires,this happens a lot due to the constant bending and flexing when the door is opened and shut.You will need to cut the plastic covering so be careful not to cut more deap than you have to to avoid further wire damage.

Posted on Nov 12, 2009

  • 4 Answers

SOURCE: Right Turn Signal not flashing.

quick fix,try to run jumper wire from solid lime green wire to tail light green/orange wire Your problem is no power

Posted on Apr 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I Have a 97 Ford Explorer XLT 4 door with power windows, the windows and wipers stop and start working at the same time, has anyone seenthis before?


what does that mean.
1: active window and wipers move , or reverse.
2: or i must turn on both to get either working??????
or????? be more clear. please.
all wipers move front and rear.?
and all windows do this or just one?


Shot gun effects:
and forgot to do the tests. and that meant you missed bad connections.
money to burn?
the FSM book covers this 100% read that. see those tests.
guessing works like 20% time? shot gun, 50%. leaving what?
wires and connections and bad fuses,(hair cracked)

ill look up what wire that is using alldata.com
so can you , hint?
pardon my shock but never knew folks did shot gun fixes.. wow....
pay a tech 1hr labor for him to tell you what it is ?
I know , you live in the jungle forest like me.
here we go, there. alldata.

fuse 16 runs the
here is the left front, window.
the GEM controls both wipers and windows. so , my guess
bad GEM or the inputs to it are WRONG. (basic logic 101)
be more clear on what works, here, and dont. all windows and all wipers front and rear and what this means.
at the same time

56363e00-bc37-432f-b269-26892a74ea77.jpg

Jun 24, 2014 | 2002 Dodge Stratus

1 Answer

1999 Cadillac Deville wiper blade on driver side not moving


bent/broken wiper arms under the base of the windshield..remove the vent cover and service/replace broken parts.

Feb 09, 2013 | 1999 Cadillac DeVille

1 Answer

F250 Power windows and wipers


What year is the vehicle ?

Jul 06, 2017 | Cars & Trucks

1 Answer

2000 BUICK REGAL MY WIPER BLADES (DRIVER SIDE) WENT OFF THE WINDSHIELD THE OTHER NIGHT. WHEN I PUT IT BACK IT DID NOT WORK PROPERTY WHAT COULD BE WRONG DO I NEED TO TAKE IT TO A DEALER?


i`m not sure what you mean by it not working properly i assume that you mean it goes back and forth like the passenger side, but it doesn`t clean the window and you put the blade on the arm correctly then the wiper may be damaged and you will have to replace the wiper blade.check and compare the installation of the driver`s side to the passenger side wiper and correct the installation of the blade

Mar 08, 2011 | 1999 Buick Century

1 Answer

What size wiper blades for front windshield


Driver side: 24"
Passenger: 20"
Rear: 16", although I use 18-20 for better coverage

Passenger side: 20" ; Driver's side: 24" GK



At 2001 Windstar all old models, driver front 24", passenger front 20", rear window 16"
Driver side 24 inches, passenger side 20.


Hope helps (remember to rate and commen this).

Dec 20, 2010 | 1998 Ford Windstar

1 Answer

How to replace the wiper insert at the back of


moz-screenshot.jpg
  1. REMOVE RR WIPER BLADE
    1. Raise the rear wiper blade to the position as shown in the illustration where the meshing of the claw disengages with a clicking sound. NOTE: Be careful not to break the claw.
    2. Pull straight the rear wiper blade to vehicle's left from the wiper arm. NOTE: Do not fold the rear wiper arm with the rear wiper blade removed from it.1722d05.gif

  1. REMOVE REAR WIPER RUBBER
    1. Place the rear wiper with the rear end of the rubber protruded from the blade stopper as shown in the illustration. NOTE: Do not pull out the wiper rubber forcibly, as the backing plates will become deformed or the blade claws will become damaged. HINT: The rubber can be easily pulled out by pushing the middle area of the blade.
f54b10a.gif
  1. INSTALL REAR WIPER RUBBER
    1. Install the 2 wiper rubber backing plates to the rear wiper rubber. NOTE: Be careful to observe and keep direction of curvature for correct replacement.
0dd144d.gif
b. Insert the rear wiper rubber from the claw of the middle of the rear wiper blade into the rear end position.
8f40009.gif
c. After passing the rear wiper rubber through the rear end side claw, protrude it from the rear end stopper and pass it through the front tip side claw.

Sep 12, 2009 | 2005 Toyota Matrix

1 Answer

1998 E230. power seats,central locking,power windows, turn signals, wipers, power mirrors all stopped working


hello,check your fuse number 4 ,15 for signal light ,check also the rear fuse box for power window,central lock,power seat ,located at rear seat in front of battery,ty

May 01, 2009 | 1999 Mercedes-Benz E-Class

2 Answers

2005 Chevy Equinox Wiper blade hits edge of window


The 23 should work on the drivers side but you will need a 19" on the passenger side.
Hope this helps and let me know.
Regards,

Feb 18, 2009 | 2005 Chevrolet Equinox

1 Answer

Front windshield wiper blades


The 2006 Toyota RAV4 takes a 24" drivers side, 17" passenger side and has a special 17" rear blade. Don't just go by lengths though - when buying windshield wiper blades be sure to always use the application guide book at the store or now-a-days you can Google 'lookup wiper size'.

You want to look this up because correct wiper fit is more than correct length, it's also proper attachement. Not all attachments fit all arms. Using the application guide or looking up wiper size online will avoid headaches of buying the right lengths with the wrong attachements.

The replacement wiper blades will come with step-by-step, illustrated instructions and once you have the instructions and the wiper blades/arms in your hands in front of you, it will all make better sense and will an easy maintenance task. Very simple and takes 5-15 minutes usually not requiring any tools. If in your budget, upgrade to the newer-style frameless "beam blades" which perform better than conventional framed wipers. I use Trico NeoForm Beam Blades which are fantastic. Hope this helps!

PS: Your question is about the front blades but if you address the rear blade too, this vehicle has what they call a "Roc Lock 2" rear arm. You can go to your dealer or I know Trico makes an "Exact Fit Rear Integral Blade 12-A". There may be others available too. I've got the Trico on my Jeep and it fits/works great.

Aug 11, 2008 | 2006 Toyota RAV4

Not finding what you are looking for?
1997 Plymouth Grand Voyager Logo

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...