Question about 1994 Ford Bronco

Open Question

94 bronco with a 51 air bag code. Once the thermal fuse issue is corrected, do I have to reset the computer or will the flashing 51 code auto reset?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 373 Answers

SOURCE: air bag code

Hi, ON your 2002 ford taurus, The Flashing code 33 ( B 2292 )

This code refer to : Driver side seat belt pretentioner ( seat belt bucklet) problem.

Check the conecctions under the driver seat.
Repair as need, and recheck if thi code is present.

But if you had an accident on you taurus. You need to replace the Seat belt Pretentioner ( seat belt bucklet)

OK. I hope this information work for you.

Than's.

Posted on Jul 11, 2008

Ad
  • 142 Answers

SOURCE: Air Bag Code

Code 52 relates to low voltage detected in a capacitor inside the airbag module. 45 seconds after key on, this capacitor should have a voltage of around 23 volts.

This capacitor stores energy to deploy the airbag in the case of a collision.

Because your airbag light is on, your system is deactivated (cannot deploy)

In your case, the airbag computer detects less than 23 volts at that capacitor 45 seconds after key on, and disables the system.

There is a diagnostic procedure involved in fixing this problem, but usually means a bad airbag module (computer)

This should only be checked by a qualified technician, as airbag service can be dangerous and there are strict procedures to follow so the bags don't inflate suddenly and cause injury.

Posted on Aug 27, 2008

  • 4861 Answers

SOURCE: code 51

A common cause for this fault on FORD vehicles  is the yellow connector underneath the passenger seat making a poor contact. Push them together so that it is tight and that normally cures the problem.

It is usually caused by being disturbed by pushing stuff under the seat (eg  tools , boxes . legs etc ) or the seat being adjusted too often

Posted on Aug 30, 2009

  • 124 Answers

SOURCE: How do I fix a code 44 problem? Air bag light

The air bag code 44 indicates that the air bag computer is not receiving a signal from the right front air bag sensor. This could be caused from defective wiring (loose wire or grounded through chafing) or the sensor being defective.

Posted on Nov 05, 2009

Testimonial: "Thanks. That is what was wrong; my husband finally checked with the dealer."

  • 4861 Answers

SOURCE: air bag light is and flashing code 27

This is a common fault on FORD
 
Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the passenger seat.
 
 
Just push it together properly and it should clear the AirBag fault light 
 


Posted on Jan 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Air bag light flashes code 51.


If your airbag code is blinking, and you get 51, it means that your internal thermal fuse in your airbag computer is blown which is caused by an intermittant short to ground on one of the wires in the circuit. When the short to the ground is removed, code 51 flashes with the use of the airbag warning lamp, 5 flashes, pause, 1 flash, longer pause. According to the Ford, this is a nonrepairable fix, you must buy a new air bag module which is a blue box located in the vicinity of the the steering column.

Apr 10, 2014 | 1994 Ford F150 Styleside Supercab

1 Answer

Flashing airbag light 4 blinks 6 blinks


This is a code 46 LH Crash Sensor - Not Mounted to Vehicle Properly. Often there is a poor contact on one of the wiring connectors. Some of the problems can happen from a poor connection where everything connects under the drivers side seat.
Here is a list of codes for the airbag light issues.

Air Bag Fault Code Table

AIR BAG DIAGNOSTIC MONITOR FAULT CODE PRIORITY TABLE

Priority Code Component/Fault Description

Highest -- No Air Bag Lamp - Inoperative Lamp Circuit or No Ignition Voltage to Diagnostic Monitor

' -- Continuous Air Bag Lamp - Diagnostic Monitor Disconnected or Inoperative

' 12 Low Battery Voltage

' 13 Air Bag Circuit or Crash Sensor Circuit - Shorted to Ground

' 21 Safing Sensor - Not Mounted on Vehicle Properly

' 22 Safing Sensor Output Circuit - Shorted to Battery Voltage

' 23 Safing Sensor Input Feed/Return Circuit Open

' 24 Open in Circuit 944B or Low Resistance in Crash Sensor(s)

' 32 Driver Side Air Bag/Safing Sensor Circuit - High Resistance or Open

' 33 Pin 7 Not Grounded at Diagnostic Monitor

' 34 Driver Side Air Bag/Safing Sensor Circuit - Low Resistance or Shorted

' 35 Low Resistance Across Pins 8 and 9 at Diagnostic Monitor

' 41 Crash Sensor Circuit - High Resistance or Open

' 44 RH Crash Sensor - Not Mounted to Vehicle Properly

' 45 Center Radiator Crash Sensor - Not Mounted to Vehicle Properly

' 46 LH Crash Sensor - Not Mounted to Vehicle Properly

' 51 Diagnostic Monitor Internal Thermal Fuse - Blown and Short to Ground No Longer Exists

' 52 Backup Power Supply - Voltage Boost Fault

' 53 Internal Diagnostic Monitor Fault

Lowest -- Rapid Continuous Flashing of Air Bag Lamp - All Crash Sensors Disconnected

Hope this helps...

May 05, 2011 | 2003 Ford Escape

1 Answer

I have code 51 flashing. Where is the air bag diagnostic module located?


Hi, the code 51 flashing means that the internal fuse is blown and the short to ground is no longer present. If the short to ground returns, the code will change to 13 (air back circuit shorted to ground) or 14 (primary crash sensor circuit shorted to ground), but it will only flash 13 or 14 when the short is present. If the code remains 51, then first find and repair short before replacing the diagnostic monitor (what people call air bag module).
Take care

Aug 03, 2010 | 1994 Mercury Grand Marquis

1 Answer

I have a code 51 blinking air bag light from my 1995 ford taurus. what does this mean


Hi Branda1, It will have to go to a dealer to repair. Air bags are not something you want to do yourself, very dangerous. Here is what code 51 means.. hope this answers your question.. Cobra

Diagnostic Trouble Code 51—Air Bag Diagnostic Monitor Internal Thermal Fuse—Fuse Blown Due to Intermittent Short to Ground Normal Operation
NOTE: The air bag diagnostic monitor contains an internal thermal fuse that is not serviceable. The thermal fuse is controlled by the microprocessor inside the air bag diagnostic monitor . The microprocessor inside the air bag diagnostic monitor will blow the thermal fuse whenever a short on the deployment circuits occurs. The thermal fuse does not blow because of excessive current flowing through it. DO NOT attempt to short circuit the thermal fuse with a circuit breaker or any other type of fuse.

Jul 06, 2010 | 1995 Ford Taurus

2 Answers

What is airbag light code 31 and 51 on a 1994 ford taurus


I was unable to locate code 31 in my book here is a copy of the codes. looks like you just need a fuse for #51. this may fix 31 as well.

Diagnostic Trouble Code Table 1994

AIR BAG DIAGNOSTIC MONITOR DIAGNOSTIC TROUBLE CODE PRIORITY TABLE
Priority Code Component/Fault Description
Highest - No Air Bag Indicator - Inoperative Lamp Circuit or No Ignition
Voltage to Air Bag Diagnostic Monitor

Continuous Air Bag Indicator - Air Bag Diagnostic Monitor
Disconnected or Inoperative
12 Low Battery Voltage
13 Air Bag Circuit Shorted to Ground
14 Primary Crash Sensor Circuit Shorted to Ground
21 Safing Sensor Not Mounted to Vehicle Properly
22 Safing Sensor Output Shorted to Battery Voltage
23 Safing Sensor Circuit Input Feed/Return Circuit Open
24 Safing Sensor Output Feed/Return Circuit Open
32 Driver Side Air Bag Module High Resistance or Open
33 Passenger Side Air Bag Module High Resistance or Open
34 Driver Side Air Bag Module Circuit Low Resistance or Shorted
35 Passenger Side Air Bag Module Low Resistance or Shorted
42 Center Radiator Primary Crash Sensor Feed/Return Open
44 Center Cowl Primary Crash Sensor Not Mounted to Vehicle Properly
45 Center Radiator Primary Crash Sensor Not Mounted to Vehicle Properly
51 Diagnostic Monitor Internal Thermal Fuse - Fuse Blown Due to
Intermittent Short to Ground
52 Backup Power Supply - Voltage Boost Fault
53 Primary Crash Sensor Circuits - Resistance to Ground or Air Bag
Diagnostic Monitor Failure

Lowest - Rapid Continuous Flashing of Air Bag Indicator (No DTC) All Primary

Sep 30, 2009 | 1994 Ford Taurus

1 Answer

Airbag lt on


Hi!

Code 51 means: Air Bag Diagnostic Monitor Internal Thermal Fuse ä Fuse Blown Due to Intermittent Short to Ground. It means that the computer controlling the airbags sensed a short in the wiring and disabled itself by tripping an internal fuse for safety reasons so that the air bag cannot be deployed accidentally. To repair the car, the wiring problem must be fixed, and then the airbag module replaced. Look for smashed wires, wires that are rubbing against bare metal or other wiring damage affecting the airbag circuits. This wiring is all under the plastic cowl around the steering column.

Please do rate the solution as FixYa and revert for further clarification.

Thanks
Rylee

May 30, 2009 | 2003 Ford Taurus

2 Answers

SRS light now repeatedly blinks 5-1 problem code - stop/reset?


Sounds like an air bag problem. You will not be able to reset the light without fixing the problem. The steering wheel airbag electrical contact is suspect. Airbag will have to be removed and problem repaired. . I do not recommend you repair the problem unless qualified.

Mar 12, 2009 | 1998 Lincoln Mark VIII

1 Answer

Instrument Panel Codes??


Yes, it's called a lamp fault code.

9 is not familiar to me. Call dealer service department and ask them what code means.

Here are codes for a 94 Aerostar. I don't have 91 Sable. Sorry.



Air Bag Diagnostic Monitor Diagnostic Trouble Code Priority Table Diagnostic Trouble Code Component/Fault Description — No Air Bag Indicator — Inoperative Indicator Circuit or No Battery Positive Voltage to Air Bag Diagnostic Monitor — Continuous Air Bag Indicator — Air Bag Diagnostic Monitor Disconnected or Inoperative 12 Low Battery Voltage 13 Air Bag Module or RH Cowl Side Panel Air Bag Sensor Circuit Shorted to Ground 21 LH Cowl Side Panel Air Bag Sensor Not Mounted to Vehicle Properly 22 LH Cowl Side Panel Air Bag Sensor Circuit Shorted to Battery Voltage 23 LH Cowl Side Panel Air Bag Sensor Circuit Input Feed/Return Circuit Open 24 LH Cowl Side Panel Air Bag Sensor Diagnostic Circuit Open or Low Resistance in Center Air Bag or Front Air Bag 32 Driver Side Air Bag Circuit High Resistance or Open 33 Passenger Side Air Bag Circuit High Resistance or Open 34 Driver Side Air Bag Circuit Low Resistance or Shorted 35 Passenger Side Air Bag Circuit Low Resistance or Shorted 41 Center Radiator and RH Cowl Side Panel Air Bag Sensor Circuits High Resistance or Open 44 RH Cowl Side Panel Air Bag Sensor Not Mounted to Vehicle Properly 45 Center Air Bag Sensor Not Mounted to Vehicle Properly 46 Open Splice Center Air Bag Sensor Ground Monitor 51 Air Bag Diagnostic Monitor Internal Thermal Fuse Blown and Short to Ground No Longer Exists 52 Backup Power Supply Voltage Boost Fault 53 Sensor Circuits Resistance to Ground or Internal Air Bag Diagnostic Monitor Fault — Rapid Continuous Flashing of Air Bag Indicator

Feb 25, 2009 | 1992 Mercury Sable

2 Answers

Air bag


 12 Low Battery Voltage 
| 13 Air Bag Circuit or Crash Sensor Circuit - Shorted to Ground 
| 21 Safing Sensor - Not Mounted on Vehicle Properly 
| 22 Safing Sensor Output Circuit - Shorted to Battery Voltage 
| 23 Safing Sensor Input Feed/Return Circuit Open 
| 24 Open in Circuit 944B or Low Resistance in Crash Sensor(s) 
| 32 Driver Side Air Bag/Safing Sensor Circuit - High Resistance or Open 
| 33 Pin 7 Not Grounded at Diagnostic Monitor 
| 34 Driver Side Air Bag/Safing Sensor Circuit - Low Resistance or Shorted 
| 35 Low Resistance Across Pins 8 and 9 at Diagnostic Monitor 
| 41 Crash Sensor Circuit - High Resistance or Open 
| 44 RH Crash Sensor - Not Mounted to Vehicle Properly 
| 45 Center Radiator Crash Sensor - Not Mounted to Vehicle Properly 
| 46 LH Crash Sensor - Not Mounted to Vehicle Properly 
| 51 Diagnostic Monitor Internal Thermal Fuse - Blown and Short to Ground No Longer Exists 
| 52 Backup Power Supply - Voltage Boost Fault 
| 53 Internal Diagnostic Monitor Fault 
Lowest -- Rapid Continuous Flashing of Air Bag Lamp - All Crash Sensors Disconnected 

Dec 11, 2008 | 2002 Ford Ranger Regular Cab

Not finding what you are looking for?
1994 Ford Bronco Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...