Question about 2012 Jeep Wrangler Sport Convertible SUV 3.6L V6 4x4 6-speed Manual
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Jeep wrangler Fuse box
i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck
Posted on Jun 30, 2008
There are four (sometimes two) bolts that hold the steering column to the dash. remove them & column will come down to let you get in there.
follow instruction sheet with switch. if you don't get it centered correctly it wont work correctly.
Posted on Jan 05, 2009
unfortinately the fuse box is under the hood and there is no panel inside the 2000 cherokee or diagram, i had to buy an online manual to find out what fuse went where for my jeep but its not with me. You can just pull the fuses out one at a time and look at them - I know its a pain. It might be your window controll switch - mine is bad as well. It is a common problem for these cherokees especially over 100k, they wear out - I initally thought it was my fuse as well because the lights in the window switch didn't light up anymore - but it is my switch.
Posted on Feb 15, 2009
Likely you are looking for a 30 amp circuit breaker...(Looks like a small rectangular metal fuse) But...if the power door locks work, i don't think that it's bad (serves locks & windows) My diagrams show a bunch of diodes and resistors inside the master (drivers) door switch, but I've had a few apart and never saw any. (embedded?) Personally I don't see anything that shows me reliability built into the switch...It's a really "iffy" design (one in my niece's Jeep only works when the sun shines on the drivers door) There is also a control module associated with the windows but I've never needed to replace one and the manuals never tell you where they are!
Check power at the switch and check harness where it goes through the rubber boot between the door and body. at least 80% of problems I've seen are either the switch or that wiring. Wires can be spliced and you can get a decent used switch at most scrap yards.
Good luck...glad they aren't stuck down!!!
Posted on Jun 27, 2009
I have a 97, and my fuse for that is behind the glovebox. Open the box, slide the end of the strap to disconnect it, then remove the box. The fuse is marked. Something like "Dome lt. elim." I think it's located one up from the bottom right. This can actually be done without removing the glove box. For a more permanent fix, quadratec.com has a switch that plugs into the fuse location and mounts under the dash, so you can just flip the switch. Hope this helps.
Posted on Jul 14, 2009
Tips for a great answer:
Jun 27, 2017 | Jeep Cars & Trucks
Jun 26, 2017 | Jeep Cars & Trucks
Dec 25, 2013 | 2012 Jeep Compass Sport 4dr SUV 2.0L...
Mar 06, 2013 | 1995 Jeep Wrangler
May 20, 2012 | 2005 Jeep Grand Cherokee
Jan 26, 2010 | 1999 Jeep Wrangler
Nov 22, 2008 | 1991 Jeep Wrangler
166 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: