Question about Chrysler Cars & Trucks
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
You will need to remove the right front wheel & wheel well liner. The canister purge valve is behind the cover. It should have two tube going into the bottom and one on the side near the top.
You can fix it!
If this helps you out please rate me!
Posted on Mar 19, 2009
I have one of these cars too, also 3.5. I purchased with 34K and has used a quart of oil every 1000 miles since then. It has no leaks or smoke or any other signs of oil consumption. So much research, nobody knows why these engines do this, some have gone as far as contacting Chrysler just for them to say, " that's normal". But here is the diagram for the PCV:
Posted on Mar 13, 2010
There is a purge solenoid for the EVAP system and it is item no.# 1 shown in the diagram below. You have to follow the purge valve vacumn hose to find the charcoal cannister if you need to inspect.
I have included a description of the EVAP system for your understanding.
EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM
The EVAP and on-board refueling vapor recovery (ORVR) system consists of a fill vent valve, fuel shut-off valve, fuel cut (roll-over) valve, fuel liquid/vapor separator, EVAP canister, EVAP canister purge solenoid valve, EVAP canister close valve, vacuum relief filler cap, and connecting lines and hoses. ORVR system is designed to prevent the release of fuel vapors during refueling. During refueling, as fuel enters the fuel tank, a vacuum is created in filler pipe, drawing air into the filler pipe and tank. Fuel vapor in fuel tank is then forced to the EVAP canister via the fill vent valve and the fuel liquid/vapor separator. A fuel tank pressure sensor is used for detecting EVAP system leaks by comparing pressures inside and outside of fuel tank.
EVAP Canister Purge Solenoid Valve
Fuel vapors are vented into the EVAP canister during refueling and when ignition is off. When engine is at normal operating temperature and engine speed is greater than idle, a thermovalve opens and allows vacuum to open the purge control valve. Canister vapors are then drawn into the intake manifold for burning during combustion. The purge control valve is kept closed during idle and engine warm-up to reduce HC and CO emissions.
Posted on Dec 16, 2010
Tips for a great answer:
Aug 01, 2016 | 2010 Chevrolet Impala
Jan 11, 2016 | 2006 Buick Rendezvous
Jun 26, 2015 | 2006 Chrysler 300 Touring
May 12, 2014 | 2004 Ford E250
May 01, 2014 | 2002 Jeep Grand Cherokee
Feb 25, 2013 | 2002 Toyota ECHO
Jan 08, 2013 | Cars & Trucks
Nov 11, 2009 | 2006 Chrysler Pacifica
Oct 21, 2009 | 2004 Chrysler Pacifica
1,300 people viewed this question
Usually answered in minutes!