Question about 2000 Pontiac Montana
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.
Posted on May 12, 2009
SOURCE: how to replace a fuel filter
The fuel filter is located on the drivers side about the mid point of the van inside the frame rail. Loosed the fuel cap to relieve some of the pressure in the fuel system. The filter is held in place by 1 nut (which will probably break off when you try to remove it) and held to the fuel lines on each end by a plastic clip. Pull out these plastic clips with needle nose pliers and pull the fuel lines off. It is easier to understand if you already have the new filter in your hand so you have some idea what these plastic clips look like. Like I said, you will get fuel on you as the lines have fuel in them and well as the filter will be full of fuel.
Posted on Jul 15, 2009
remove the ignition coil pack ( 2 10mm bolts on front of it and 2 13 mm nuts on the back side) u will need a long extension and deep socket for the back ones , and unplug all electrical connectors and remove it from the vehicle and you should be able to reach the back plugs without a problem.
Posted on Jul 28, 2009
Tips for a great answer:
Feb 16, 2013 | 2000 Pontiac Montana
Aug 24, 2012 | 2000 Pontiac Montana
Nov 21, 2017 | 2000 Pontiac Montana
Jan 24, 2011 | 2000 Pontiac Montana
Jan 28, 2010 | 2000 Pontiac Montana
Oct 01, 2008 | 2004 Pontiac Montana
71 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: