Question about Cars & Trucks

1 Answer

Can you advise where the screen washer is located on the citreon berlingo van

I need to replace the washer motor on my van but have no manual to locate item thanks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 462 Answers

Follow the washer hose from the wiper arm back

Posted on Dec 10, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
shaggyrat
  • 1224 Answers

SOURCE: Winshield washer motor does not run

These days, most windshield washer pumps are mounted to the bottom of the washer fluid reservoir. Where’s that, you ask? Well, inner+fender+w+text.jpgyou know that spout you pour the fluid into—the one that disappears into nowhere? Well, the reservoir is actually 2384f71.jpglocated inside the front fender between the bumper and the front wheel. To replace the pump, you will have to jack up the vehicle, remove the front wheel and then remove the inner fender liner.

Posted on Jun 13, 2008

  • 1 Answer

SOURCE: Diagram of Location of a Starter Motor on Ford Transit 2002/2003

i have a 2001y reg transit tipper and i think the starter motor is going when i go to start it like grinds then some times it starts perfect

Posted on Jan 25, 2009

  • 50 Answers

SOURCE: I cant find a detailed picture of where the location is to check these items.

The crankshaft position sensor is located on the transmission bell housing on the right side (if you're facing the engine from the transmission side). The camshaft position sensor is towards the top center of the timing cover on the front of the motor. They both have 3 wire connectors that are virtually identical.

Posted on Apr 18, 2009

  • 4 Answers

SOURCE: have to change blower motor resistor where is it located

Located behind glovebox. 2 screws and 2 plugs. very simple

Posted on May 30, 2009

  • 784 Answers

SOURCE: location of blower motor fuse

Fuse blower motor is not in the fuse box. It is located outside. lOpen the hood, on the driver side near the fender, about 1 feet from the fuse box toward the direction of the radiator, there is a retangular about 1x2 in with wire coming out from each end. Snap it open, inside is the the wire fuse.

Posted on Aug 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

We're is the crank shaft sensor on 2005 1.9diesal Berlingo van


Adam, Link below may help.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

2005 1 9 diesel Berlingo crankshaft sensor location Google Search

How To Check Crank Shaft Position Sensor

Citroen Berlingo Crankshaft Sensors Up to 50 off dealer prices

Feb 26, 2016 | Cars & Trucks

1 Answer

How I find were the starter motor fuse is on my Citroen berlingo van 2007 model


http://www.citroendriveeurope.co.nz/wp-content/uploads/2013/10/Citroen-Berlingo-Owners-Handbook.pdf

Oct 20, 2015 | Citroen Cars & Trucks

1 Answer

Market value 1983 citroen berlingo 2 door van. Manual


The Citroen Berlingo is produced by the PSA Peugeot Citroen alliance since 1996. So in 1986 it would be C15, not Berlingo.

Aug 07, 2015 | Citroen Cars & Trucks

1 Answer

Citreon Berlingo van. Need to unlock radio but dot have the code,can thius be done.


u can buy an unlock code on ebay from £2.99 you will need to take out the radio from the dash to get the serial number.

Jul 01, 2015 | Cars & Trucks

1 Answer

Citroen berlingo wiper motor switch,headlight switch, heater motor, clocks all go out after about one minute


I think there is a circuit breaker That is overloaded or faulty fit a amp meter in series , switch every thing on and note the reading. The circuit breaker needs to have a 10% higher rate than the reading you have just taken .

Nov 29, 2014 | 2004 Citroen Berlingo 1.9

1 Answer

Engine idle speed on citreon berlingo 1.9


Warm diesels should idle low. Some of them 800-900 revs.
At cold, they should have a fast idle, some 1100 revs.
look if your engine has a cylindrical device, with a bowden cable to the diesel distibutor pump. This will be your coldstart device, responsible for idle revs.

Aug 09, 2014 | 2005 Citroen Berlingo

1 Answer

I need to fit a fanbelt tensioner on my citreon berlingo 1.9d forte 2002 model


Are you replacing the whole tensioner or just the wheel and bearing? If the bearing is just the problem it is just bolted on. You can buy the wheel only at the dealer or on line here.

Oct 02, 2012 | 2003 Saturn L-Series

1 Answer

Citreon berlingo t reg


fuse box is under the dash if iam not confusing the issue with a kangoo ,check the fuse if ok then check for power to the stalk switch and if power but no indicators then change the hazard warning light switch .didnt know they made this model vehicle in 1978 T reg

Apr 26, 2012 | Citroen Berlingo Cars & Trucks

2 Answers

How to set timing up on 1.6 Hdi engine without reluctor after cambelt snapped


please state year and model of this engine as they do change ,i think its a citreon something like a berlingo or maybe a 306 or whatever but need the year as the common rail is different to the injector pump model or is it a dreaded my favourite motor and thats a renault

Feb 29, 2012 | Citroen Cars & Trucks

1 Answer

The oil light on my citreon berlingo van 1.4 petrol will not go off and the stop light flashes and beeps intermittently. I have put about 3 or 4 litres of oil in and there does not appear to be any leaks...


Have you checked the oil level, is it in the norm?, if its normal and still get light, then possible faulty oil pressure sensor. The brake light... are you disengaging the parking brake all the way?, have your parking brake sensor and oil pressure sensor checked out.

Good luck

Aug 19, 2011 | Aston Martin DB7 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...