Question about 1996 Audi A4

1 Answer

When I switch gear in reverse my car won't move why?

I just had a rebuilt transmission in my car just a year ago. I got stuck in the snow and try to get out and my reverse gear went out.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My 1996 audi a4 2.8 awd reverse gear works for a couple of second then stops moving....

Posted on Jan 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1981 ford f150 4x4 with a 302 engine An automatic transmission that works fine shifts properly going forward But when I put it in reverse I hear a clunk and sometimes it goes into gear and...


If the transmission was rebuilt 2 years ago the fluid and filter did not need to be changed. In a 1981 there are no trouble codes to retrieve so whoever suggested that is out to lunch, Unfortunatley you need to get the transmission rebuilt again, hopefully it gets done better this time. Using the dexron oil in Ford transmissions is something transmission shops do because they don't want to stock different fluids. While it's not likely that using dexron oil lead to the failure it would be better to use mercon or type F oil.

Mar 01, 2015 | 1981 Ford F 150

2 Answers

No reverse second is drive and Reverse is Neutral,


Check your transmission fluid, and if that is good you may have damaged the transmission in a fashion that it may need to be rebuilt or replaced.

Jan 03, 2015 | 1999 Ford Expedition

1 Answer

Transmission won t shift out first gear


Clogged transmission coolant line. Use air to blow out and replace filters and fluid.

Mar 11, 2014 | Dodge Durango Cars & Trucks

1 Answer

RX 300 Transmission will not change gears nor engage reverse


check transmission fluid levelif you see metal shaving in oil pan time for rebuilt if you see more than a table spoon full of shavings but i would change transmission fluid and filter.if engine running higher rpm on acceleration transmission is slipping.

Dec 19, 2012 | 2002 Lexus RX 300

1 Answer

95 mustang v6 auto no forward gears but works in reverse had ****** rebuilt and same thing


Maybe your differential is shot and will only allow reverse spin or the transmission was not really rebuilt professionally. Was the transmission checked outside of your car after rebuild? Does your vehicle have a Powertrain Control Module (PCM)? Maybe the module went bad or faulty.

Jun 18, 2012 | Cars & Trucks

1 Answer

2004 nissan altima 2.5s will start but won't move in any gears


You have a failed automatic transmission. You will need to remove and replace it or have it rebuilt.

May 31, 2012 | Cars & Trucks

1 Answer

I got my 99 jeep grand cherokee stuck in the snow. I called a tow ing company which dragged my jeep backwards out of the snow. Now my car will not drive in reverse. when I put the gear in reverse I can...


sounds like when you got it stuck you tryed to get it out and got the clutches hot and they stuck / welded when you put it in revurse does it pul the engine speed down like it is in gear but you give it gas and wont move trying to go forward and back at the same time sounds like trans rebuld time

Dec 29, 2009 | 1999 Jeep Grand Cherokee

1 Answer

Transmission - no reverse


i had to put a new trans in my 2000 jimmy about a year ago there is something inside called a "reverse hub" its made from aluminum and not very hard to break..when mine broke i was stuck trying to move in reverse and it heard a pop then a winding down noise and sure enough its the reverse hub to fix it i just had the trans rebuilt

Sep 08, 2008 | 2000 GMC Jimmy

Not finding what you are looking for?
1996 Audi A4 Logo

Related Topics:

739 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

yadayada
yadayada

Level 3 Expert

70365 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13554 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...