Question about 2010 Ford Ranger 2.3
I need to fix the rpm meter. I replaced the injector pump
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The egr valve has two sensors. One is an EGR position sensor which is physically attached to the EGR valve. The other sensor is the DPFE (Delta Pressure Feedback EGR) sensor, commonly called the EGR pressure sensor. It's location varies depending on the engine you have. You can fine this sensor by following the vacuum hose on the EGR valve. It will be with in inches of the EGR valve. The sensor will be black (plastic) or silver (metal), have two or three vacuum ports and an electrical connection on it.
The vacuum pressure sensor is a high failure item on fords. Any Ford parts department will have one in stock, as well as some aftermarket parts stores.
The new sensor may not look exactly the same as the old part, but will have all the hook ups as the old one. You may also need to replace the vacuum hose to the sensor as well
Posted on Feb 25, 2009
It does not have an ignition control module. The PCM (powertrain control module) fires the coil pack based on signal it recieves from the crankshaft position sensor and the camshaft position sensor.
Posted on Apr 08, 2009
SOURCE: 2000 ranger fuse diagram
Fuel Pump relay switch is in the main box usually located on the drivers side Fender in a black box.
According to the owner's manual in the power distribution box in the engine
compartment (Ford recommends disconnecting your battery)
Relay # 5 is the fuel pump relay , and also in the PD BOX is a 20 amp mini-fuse
for the fuel pump relay + RAP module in location # 9
( P.S. - don't forget your fuel pump inertia switch , in the right front passenger area ,
by the right front kick panel )Sometimes this gets kicked by passenger or if the car is bummed hard it could set this item to shut down fuel system. Best of Luck
Posted on Aug 28, 2009
Testimonial: "I was skeptical, but the answer fit & worked. Thanks!"
these engines did have some exh valve issues, service bulletin 05-26-3. one other thing to verify is that the cam synronizer (CMP) is correctly installed. if its not right on, its way off.
Posted on Oct 14, 2009
Tips for a great answer:
Oct 29, 2015 | 2006 Ford Ranger
Sep 22, 2015 | 2010 Ford Ranger 2.3
Sep 06, 2013 | 1996 Ford Explorer
Apr 11, 2013 | 1987 Ford Ranger
Sep 01, 2012 | Ford Cars & Trucks
Sep 29, 2011 | 1987 Ford Ranger
Aug 15, 2009 | 1988 Ford Ranger
May 29, 2009 | 2005 Ford Ranger
97 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: