Question about 1993 Ford Crown Victoria

1 Answer

I bought a new alternator from autozone but its not charging

New alterntor not charging

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 318 Answers

Check your wiring and the related fuse on ignition circut do you have power at exciter wire with ignition on?

Posted on Dec 10, 2012

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: 2000 Ford Ranger Alternator

have the alt tested there not very good do you have 12 volts going to the big wire on the alt and with key on you should have it to a small wire going to the regulator to turn it on

Posted on Dec 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Starter, alternator wiring diagram


Would need to post year make and model for a diagtam. In all probability when the battery got shorted out by the pulley it damaged the voltage regulator inside the alternator. Make sure all your connections are clean and tight.

Aug 09, 2016 | Cars & Trucks

1 Answer

Computer box


Your belt is stretched and not charging the system or your tensioner is bad or both.Here's a link to it,the part is number one on the picture,also watch belt as it turns and rev up and see, Repair Guides Charging System Alternator AutoZone com

Feb 28, 2014 | Ford Explorer Sport Trac Cars & Trucks

1 Answer

Not chaeging battery where is the inline fuse from alterntor


The red wire coming off the alternator goes to the battery cable. There is no fuse per say, the wire is designed to melt if the amp draw is too high. The engine computer controls alternator output.

Jan 31, 2014 | 2002 Chevrolet Tahoe

1 Answer

New alternator for crown vic but not charging


Fuse and or wiring to alternator small exciter wire needs ignition voltage for it to work

Dec 10, 2012 | 1993 Ford Crown Victoria

1 Answer

My 1999 mitsubishi diamante will not start. I got a friend to jump it but it still would not start. I took the battery out and took it to autozone to charge it. But autozone would not charge it because...


It sounds like you need a new starter. If you hear the starter click when you turn the key to start, replace your starter since you already replaced the battery. You might want to have your alternator checked out, or when you get your car started, test the battery terminals with a multimeter. You should have around 14 volts with the car running. If not, you will need a new alternator. The alternator won't keep the car from starting though, unless the battery was drained because it wasn't charged. Even then it is the battery keeping the car from starting.

If the starter is not clicking, check your fuses under the hood. If all checks out, you may have a bad ignition switch.

Jul 02, 2011 | 1999 Mitsubishi Diamante

2 Answers

1994 olds cutlass supreme volt gauge shows low I have a new battery and a new altenator could the both battery and altenator put out correct volts no drain on battery even change dash volt meter still in...


check with a volt meter if u have 12 volt at the big lead on the back of the alternator engine off

if thats good start engine check to see if alternator is charging check the battery a good alterntor charges 13.5 - 14 volts, u may have a bunk alternator

Mar 25, 2010 | 1994 Oldsmobile Cutlass Ciera

1 Answer

BATTERY OVERCHARGED AND ALTERNATOR IS FINE


If you have a fully charged battery when you installed then 14 volts is way to much charge for the battery which would mean that the alternator probably has a faulty regulator and the alternator needs to be changed otherwise you will continue to install new batteries. If the battery was in an uncharged state then it is possible for the alternator to charge at full capacity to charge up the battery.

Dec 17, 2009 | 2002 Nissan Altima

1 Answer

Car quit running


if you get the car going and you can drive it long distance without it cutting out or dying on you then the alterntor is charging, recommend battery check, however if itis dying on you get alternator and wiring to *** checked

Mar 23, 2009 | 2000 Mercury Mystique

1 Answer

Jump start the car and start it only for it to die a few minutes later. could this be the altanator or batery?


It is the alterntor, if the charging system was ok the engine would continue to run. Make sure the battery is fully charged (engine cranks fast) before you replace the alternator or you could burn out the new alternator from overheating.

Aug 03, 2008 | Chevrolet Lumina Cars & Trucks

Not finding what you are looking for?
1993 Ford Crown Victoria Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

fordexpert

Level 3 Expert

5572 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...