Question about 2000 Dodge Ram 1500 Truck

Open Question

15 amp park LMP fuse keeps blowing

Lost all ext. lights. Found 15 amp park lmp fuse blewout. I installed new fuse, but keeps blowing.

Posted by Anonymous on


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 224 Answers

SOURCE: 99 dodge neon # 10 fuse ing feed 15 amp blows out

There's a short in the circut. Check continuity of the wires that feed from that fuse (you'll need a wiring diagram to identify each wire). You've got something that is causing too much amperage to move through the circut and the fuse blows. Make sure the amperage on the fuse is correct for the application (your owner's manual or fuse box diagram should tell you what amperage rating to install in each fuse slot).

Posted on Jul 03, 2009

  • 1252 Answers

SOURCE: 2000 dodge neon keeps blowing

You may have to replace your "clock spring" in your steering wheel, this works the horn and cruise control and air bag.....Thats the only thing i can think of...when you turn your wheel....michael_cass_73.jpg

Posted on Jun 18, 2011

Mr BrokRench
  • 1623 Answers

SOURCE: 1999 dodge ram truck 1500

This 30 amp fuse, If it blows when cranking, it is usually the starter dragging, if it blows by just turning the key on it is usually the fuel pump drawing too many amps.
I hope this helps.

Posted on Sep 16, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2001 Pontiac Grand Am GT reverse light does not work on my driver's side. I need to get it fixed by the end of this week in order for me to pass the safety inspection. I need help fast!

Backup Lamps
Vehicles equipped with an automatic transmission, the BU LMP fuse in the IP fuse block supplies battery positive voltage to the park/neutral position switch. Vehicles equipped with a manual transmission, the BU LMP fuse in the IP fuse block supplies battery positive voltage to the backup lamps switch. When the driver places the gear selector lever in the REVERSE position, the current flow is from the park/neutral position switch or the backup lamps switch, to the back up lamps. The backup lamps are grounded at G401 and G402.
Do a voltage drop test ! This show which side of the circuit has the problem , power or ground ! Here is a video from youtube ! Buy a cheap DVOM .

Mastering Voltage Drop Testing with Pete Meier and Jerry Truglia

Jun 01, 2017 | Pontiac Cars & Trucks

2 Answers

Keep blowing tail light fuse 45 on my 2002 Pontiac Grand Am?

There is an issue, you have a dead short in the circuit, no quick fix for this. You must first get a wiring diagram of the entire circuit and then follow it until you locate the shorted wire or component.

Sep 12, 2016 | 2002 Pontiac Grand Am

1 Answer

2003 Chevy Malibu back up light fuse location to be replaced.

Backup Lamps
The B/U LMP fuse #42 in the underhood junction block supplies ignition positive voltage to the park/neutral position switch. When the driver places the gear selector lever in the REVERSE position, the current flow is from the park/neutral position switch to the backup lamps. The backup lamps are grounded at G401 and G402.
Are you also having shifting problems ? If not , I can tell you it's not the fuse ! Wiring problem, the bulbs , park/neutral position switch !

Sep 17, 2015 | Cars & Trucks

1 Answer

2005 kia sorento change ext fuse and it keep blowing

I have a 2004 Sorento EX and my EXT fuse along with the stop lamp fuse kept blowing. The ext would blow as soon as I turned the vehicle on. The stop lamp would blow after a couple pushes of the brake pedal causeing me to have no rear lights at all regarding brake and the lights that you turn on at night. After much reading online in forums such as this, I was led on a chase looking for grounding wires, broken wires, dirty battery terminals, faulty altinator, and for a drl module. I could not find a drl module as I now do not believe there is one in sorentos, or at least in mine. I then came to the brake switch that is located on the arm of the brake pedal. I disconnected it, put a couple of new fuses in, started my vehicle and checked my fuses, and at last they did not blow! I reconnected the brake switch and checked the fuses and they had blown. I have a hunch that I am dealing with a faulty brake switch. Hope this helps

Jan 05, 2014 | 2003 Kia Sedona

1 Answer

No dash lights or park lights/ tail lights. found the fuse that was blown # 14 its a 15 amp, put a new one in and it blew as soon as i turned on the lights, so i bought a new light switch for like 50...

As with any electrical problem where a fuse blows, you will have to trace the circuit to find the overload or short to ground. It could be any of the lamp sockets or in the wiring harness.

Jan 23, 2013 | 1992 Buick Park Avenue

1 Answer

Tail lights wont come on keeps blowing fuse blows 10 amp 15 amp and even 5 amp fuses

put a 12 volt light bulb in place of the fuse. It will stay lit until you find the short circuit. Check tail and park light & side marker bulbs first.

How about if you just turn parking lights on, not headligths

Oct 11, 2011 | 2001 Ford Focus

2 Answers

Tailights are out and the dash lights are out

Hi, first check the park lmp fuse (#3) in the cab to see if that has blown. If good, suspect your headlight switch is bad. You can get a new switch for under $20 at autozone. Please let me know if you have questions, and thanks for using FixYa.

Apr 02, 2011 | 1999 Ford Ranger SuperCab

1 Answer

What is the fuse called in the fuse box for tail and brake lights havng problems finding the right one

Hi, tail and brake fuses are separate. Brake fuse is usually labeled STOP LMP, and tail is usually PARK LMPs. If you can be more specific about the problem you're having and the model and year of the car, I will see if I have the wiring diagrams to help you.


Jan 29, 2011 | Honda Accord Cars & Trucks

1 Answer

Dash and tail lights out.

You may need to go back and check the bulbs again,,, because if it's using a standard 1157 bulb, the bulb plugs in "only one way",,, but is easy to get installed incorrectly,,, causing a short which blows the fuse.
If you find this not to b the case,,, then remove the emergency flasher switch from the fuse box along with all the light bulbs, front and back. Then reinstall a new fuse.
If it still blows the fuse without bulbs in it, the you either have a faulty bulb seat or a wire is pinched and grounded to the body somewhere. (this will require an intense visual inspection)

Feb 06, 2009 | 1999 Pontiac Grand Am GT

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides