Question about 2004 Chevrolet Silverado 2500HD

1 Answer

Where does the fuse go for the trailer brake control

Not sure where the fuse goes for the electric brake control. I'm sure it's the sme panel where the pig tail plugs into, but which fuse location?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Try looking under the hood, there is a fuse box on the driver side

Posted on Jan 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 dodge 2500 diesel it has a new brake controller. trailer brakes work when you push the controller manualy but trailer brakes don't work when you push the brake pedal


there is likely a wire that goes from your brake pedal switch to the trailer brake controller this wire is probably broken or not hooked up. if it is hooked up and no wires are broken I would start making sure everything is hooked up right.

May 28, 2015 | Dodge Ram 2500 Cars & Trucks

1 Answer

I need a fuse diagram for a 2006 Ford F250 2WD. My lights all work great on the PU but when I connect the trailer the lights work but no brake lights or turn signals.


If all the lights work properly with the trailer wiring not connected then the truck itself is fine. If attaching the trailer wiring causes the lights to permanently stop working on the truck then you are blowing a fuse and it will need to be replaced. Your owners manual will show you where the fuse panel is. You should be able to check the wiring plug at the back of the truck to be sure it is working properly with a test light and a helper. If the power for signals/brakes etc are not all working at the plug, then trace back and fix these. If all is good at the truck's plug, then the trailer wiring must be faulty. Again, go through it and fix anything that is broken or corroded. Of course it goes without saying, make sure all the bulbs are good.

Nov 02, 2014 | Cars & Trucks

1 Answer

How do I wire a brake control unit into mitsubishi magna V6 auto?


the unit you buy will have the instructions for getting a 12 volt feed from the fuse box (never direct of the battery has to have a fuse )
the unit slide controller will be near the driver side and a 12 volt wire will run through that controller inside the car to the back of the car to the trailer plug connection matching up with the wires to the trailer/caravan horse float .electric brakes

Aug 29, 2014 | Mitsubishi Magna Cars & Trucks

1 Answer

Location of fuse to control side mirrors on 2009 97x


Fuse panel in end of fascia
No. Amp. Function
1 15 Steering wheel lock
2 5 Steering column unit; ignition switch
3 10 Hands-free; cabin CD changer; SID
4 10 Main instrument unit; manual climate control;
automatic climate control (ACC)
5 7.5 Control module in front doors; Park Brake Shift Lock
(automatic transmission)
6 7.5 Brake light switch
7 20 Fascia fuse panel; fuel filler door
8 30 Control module in passenger front door
9 10 Fascia fuse panel
10 30 Trailer socket; electrical socket in storage compartment
between seats
11 15 Data link connection (diagnostics)
12 15 Interior lighting incl. glove compartment
13 30 Accessories
14 20 Radio, sound system I; control panel,
Infotainment System
15 30 Control module in driver's door
16 - -
17 - -
18 7.5 Manual climate control; fan
19 - -
20 7.5 Headlight levelling switch
21 7.5 Hands-free; brake light switch; manual climate
control; clutch pedal switch
22 30 Cigarette lighter
23 40 Cabin fan
24 7.5 Airbag control module
25 - -
26 5 Yaw sensor (cars with ESP)
27 - -


Trunk fuse panel, left-hand side
No. Amp. Function
1-5 MAXI -
6 30 Control module in left rear door
7 30 Control module in right rear door
8 20 Trailer
9 - -
10 30 Left-hand brake light; rear right turn signal; right tail
light; right reversing light; high-mounted brake light;
trailer lights
11 - -
12 - -
13 - -
14 - -
15 15 Seat heating, left seat
16 15 Seat heating, right seat
17 7.5 Autodimming rearview mirror; rain sensor; tire
pressure monitoring
18 15 Sunroof
19 7.5 Telematics (OnStar)
20 7.5 DVD player (navigation system)
21 7.5 Saab Parking Assistance (SPA); control module in
rear doors
22 30 Amplifier, sound system III
23 - -
24 10 Movement sensor; CD changer in trunk (accessory)
25 30 Electrically adjustable driver's seat with memory
26 30 Right-hand stop light; rear left turn signal; left tail
light; rear fog light; left reversing light; license plate
lighting; trunk lighting; trailer lights
27 - -
28 - -
29 - -

Fuse panel in front of battery
No. Amp. Function
1 60
MAXI
Secondary air injection pump (certain models)
2 20 Fuel pump; preheated oxygen sensors (lambda
probe)
3 10 A/C compressor
4 30 Main relay
Relays
1 Secondary air injection pump
2 A/C-compressor
3 Preheated oxygen sensors (lambda probe)
4 Main relay, engine (ECM/EVAP/injectors)

Sep 13, 2012 | 2006 Saab 9-7X

1 Answer

Installed a brake controller and the green light won't go on. I am told I need to add a fuse where is the fuse box to add the fuse so that the system recognizes the brake controller in a 2002 Eddie...


Hi, this may true if you connected the trailer brake to the connector on the factory wiring harness. There are several fuses that are needed for trailer towing. In the box by the battery, fuses 13, 25, 27, 53, and 54 are needed. You will need a relay in relay slot 19 for the trailer running lights, a relay in relay slot 20 to charge the trailer emergency battery; and, if your trailer has backup lights (6 or 7 wire connector), you will also need a relay in the relay slot 15. If you did not use the factory connector for your trailer brake controller, check to make sure you have connected the controller to an appropriate power source in the truck. Please let me know if you have questions, and thanks for using FixYa.

Jun 22, 2011 | Ford Explorer Cars & Trucks

1 Answer

We just hooked up our Ford 1996 econoline van to a trailer. The trailer brakes are not working. We checked all the fuses - all seem to be fine. The fuse diagram on the fuse box panel does not tell you...


First thing is your van equipped with a trailer brake controller and is it working. This is usually a small box that is installed inside the vehicle and is needed to operate the brakes. Next what type of plug do you have on the vehicle to plug the trailer into some plugs do not support wiring for trailer brakes. If you have a aftermarket trailer brake controller it will not be fused in the fuse panel so you will to locate a inline fuse used to power up the controller. Hope this helps.

Mar 04, 2011 | 1996 Ford Econoline

1 Answer

2009 Silverado 4x4 pickup with towing package and factory installed Trailer Brake controler installed at factory. The system has worked in past. I had my Stock trailer rewired and things tested out fine...


It sounds like you lost a ground.
check traier hookup first.
Probably not the controller.
P.S. There are multiple fuses for this setup. check all ! ! !

Aug 19, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

Installed electric trailer brake controler in 03 ford 150 not getting any power to trailer plug


Did you wire it with the instructions that came with the brake actuator? Check to see that yoir wiring is correct and if it is....check your fuse box for a blown fuse

Mar 20, 2010 | 2003 Ford F150 Regular Cab

2 Answers

Trailer towing fuses


Battery junction box (BJB) fuse(s):
  • 5 (30A) (trailer electric brake controller)
  • 34 (25A) (trailer tow turn relays)
  • 42 (30A) (trailer tow parking lamps)
  • 44 (30A) (trailer tow battery charge relay switch side)
  • 63 (15A) (trailer tow reversing lamps

Mar 20, 2009 | 2008 Ford F 250 Super Duty 4WD

2 Answers

Diagram of fuse panel under dashboard


2003 Excusion, V10, 2wd, Eddie Bauer

I had a hardtimefinding this informaton, hope it helps.

fuses
Fuse link
cartridge
2A Grey Grey — — —
3A Violet Violet — — —
4A Pink Pink — — —
5A Tan Tan — — —
7.5A Brown Brown — — —
10A Red Red — — —
15A Blue Blue — — —
20A Yellow Yellow Yellow Blue Blue
25A Natural Natural — — —
30A Green Green Green Pink Pink
40A — — Orange Green Green
50A — — Red Red Red
60A — — Blue — Yellow
70A — — Tan — Brown
80A — — Natural — Black
Passenger compartment fuse panel / power distribution box
The fuse panel is located below and to the left of the steering wheel by
the brake pedal. Remove the panel cover to access the fuses.
Roadside Emergencies
To remove the fuse panel cover,
turn the panel fasteners
counterclockwise.
To remove a fuse use the fuse puller
tool provided on the fuse panel
cover.

The fuses are coded as follows.
Roadside Emergencies
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse Panel
Description
1 15A* Adjustable pedals
2 20A* Power point -floor console
3 20A* Power point – 3rd row
4 20A* Power point -instrument panel
20A* Power point -right rear quarter
6 20A* Trailer tow turn/stop relay
7 30A* High beam headlamps / Flash to pass
8 — Not used
9 20A* Heated mirrors
10A* A/C clutch
11 20A* Radio (main)
12 20A* Cigar lighter / OBD II
13 5A* Power mirrors/switches
14 15A* Daytime running lamps
10A* Driver’s seat module memory
16 15A* Rear seat controller
17 15A* Exterior lamps
18 20A* Turn lamps/Brake on-off switch (high)
19 10A* Body security module/4x4 module
— Not used
21 25A* Rear wiper motor
22 20A* Engine control
23 20A* Engine control
24 15A* Air suspension
10A* 4-Wheel Anti-Lock Brake System
(4WABS) module
26 10A* Airbags
27 15A* Ignition switch Run feed
28 10A* EATC module module/Front blower relay
coil
29 10A* Customer access
Roadside Emergencies
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse Panel
Description
30 15A* Highbeam headlamps
31 15A* Clutch interlock switch
32 5A* Radio (start)
33 15A* Front wiper
34 10A* Brake on-off switch
35 10A* Instrument cluster
36 10A* PCM Keep-Alive
37 15A* Horn
38 20A* Trailer tow park lamps and backup lamps
39 — Not used
40 20A* Fuel pump
41 10A* Instrument cluster
42 15A* Delayed accessory
43 10A* Fog lamps
44 10A* PATS module, transceiver
45 10A* Ignition switch Run/ Start feed
46 10A* Left-hand lowbeam
47 10A* Right-hand lowbeam
48 10A* Rear wiper motor
101 30A** Trailer tow electric brake
102 30A** Door locks/Body security module
103 50A** Ignition switch
104 40A** Heated backlite
105 30A** Injector driver module
106 30A** Front wiper main
107 40A** Front blower motor
108 40A** Auxiliary blower motor
109 30A** Heated seats
110 50A** Ignition switch
111 30A** 4WD/Shift on the fly
112 30A** Left-hand power seats

Roadside Emergencies
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse Panel
Description
113 30A** Starter motor
114 30A** Right-hand power seats
115 20A** Trailer tow battery charge
116 30A** Ignition switch
601 30A CB Door window motors
602 60A** 4-Wheel Anti-Lock Brake System
(4WABS) module
210 — Not used
211 — Not used
212 — Not used
301 — Front blower motor relay
302 — Powertrain (EEC) relay
303 — Injector driver module relay (Diesel
only)
304 — Heated backlite relay
305 — Trailer tow battery charge relay
306 — Delayed accessory relay
307 — Starter relay
* Mini Fuses ** Maxi Fuses

Jan 27, 2009 | 2002 Ford Excursion

Not finding what you are looking for?
Cars & Trucks Logo

285 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...