Question about 1990 Audi Quattro

Open Question

Which power steering pump for my 2.8 Ve Audi

Hi there.. I am in PErth.. and I can't find one power steering pump for my v6 2.8 audi 078 133 205 E ?? do you have any picture detail or some info about this piece?? My car ride.. but without this pump i can't replace the serpentine belt.

Posted by on

  • Alessandro Fares
    Alessandro Fares Dec 17, 2012

    Hi there.. finally I have find the right number of the engine.
    Is *ABC 112249* , now, do u know which power steering pump I need ?? I have to fix this car !!!

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 29 Answers

SOURCE: Audi power steering pump location

Before you replace the pump, check the filter located inside the oil tank. This filter cleans the oil before going to pump. REMEMBER that Audi uses a special oil!!! Not your normal power steering fluid! Mixing them could cause damage to the entire system!

Posted on Feb 05, 2009

Ad
chet_02
  • 1 Answer

SOURCE: audi a3 electric power steering not working in one direction

79a153a.jpg

Posted on Mar 01, 2009

  • 398 Answers

SOURCE: audi serpentine belt problem

are you sure you put it on the right way go to autozone.com and get a belt diagram. did you put the belt on upsidedown?

Posted on Mar 07, 2009

  • 3 Answers

SOURCE: Audi A6 How do I replace Serptine Belt?

In response to BiTurboA6 comment, there is a full write-up at http://www.scribd.com/doc/12127197/2001-Audi-A6-Alternator-Replacement-Instructions  

Posted on Apr 27, 2009

abauto
  • 353 Answers

SOURCE: serpentine belt diagram for 1996 audi a4 quattro

Ribbed Belt: Service and Repair
Ribbed Belt, Removing and Installing
Ribbed belt, removing and installing
CAUTION: Mark the direction of belt travel before removing, using a crayon or marker. Reinstalling a used belt in the opposite direction
could damage the belt
Note:
There are two different types of ribbed belt, identified as versions A and B.
Ribbed belt versions, identifying, refer to Application and ID
Removing
Old version A
- Remove ribbed belt guard.

4f56130.jpg
- Loosen ribbed belt tensioner using 15 mm wrench and drift 3204.
- Remove ribbed belt.

New version B
52631fe.jpg
- Using 10 mm hex socket wrench, turn downward in direction of arrow to loosen ribbed belt.
Installing
Install in reverse order of removal, noting the following:
- Place ribbed belt over drive pulleys and idler roller first, and onto tensioning roller last.
- Remove drift 3204.
- Install ribbed belt guard.

Posted on Oct 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My audi a6 4.2 transmission slips bad when car heats up what causes this?


At this point you need a complete rebuild
Once the slipping starts the clutches are burnt


After the trans is broken down then you may be
told what caused the problem but I doubt it

If you don't change the trans & power steering fluids
every 3 years you loose the trans & the steering rack
will be next & then all your other vehicles the same

Same for brake fluid--every 2 years or big dollars
for ABS Unit

Oct 05, 2012 | 2001 Audi A6

1 Answer

Steering fluid leaking, but brakes are failing - 1995 2.6L V6 Audi 80


Does the brake system use a power assist from the power steering ?

Jun 30, 2012 | Audi 80 Cars & Trucks

1 Answer

Hi I I have Audi 2..5 v6 tdi, when driving at speed of 10mph a warning beeps and a yellow sign showing mph. It beeps every time I go over 10mph and doesn't beep again until I Stop and manoever off...


Hi your car got a speed warning system in the dash you need to reset it,check on your steering wheel or wiper and inticator levers for buttons for dash menu some models have a reset button also.hope this helps.

Jul 05, 2011 | 2002 Audi A6

1 Answer

I have an Audi A4 2.5 V6 TDI. starts lovely when cold but when warm it doesn't start so easy. So far I've changed the cranking sensor, Glow plugs & ECT sensor . . . Any suggestions?


can be injectors leaking when parts is warm and expanded or temp sender not sending correct signals to ecu,so get injectors tested and replace temp sender.hope u succeed.

May 27, 2011 | Audi A4 Cars & Trucks

1 Answer

I have a 1998 audi A4 quattro v6 5 speed. My question is does those cars come with air ride? I c sum red tubes coming out of the strut n there is no springs. Can some 1 please get back 2 me.


They didn't come with air ride but it sounds like your car had it installed. I'd figure the prior owner would've told you about it though.

Jan 07, 2011 | 1998 Audi A4

1 Answer

Hi, I have a 1999 Audi A6 Avant. The steering wheel squeals when I turn left or right. I had the steering pump replaced. It stopped after replacing it and then started again shortly after. Took the car...


the pulley tentioner on the power steering belt, i ve done lots of them, they are self tentioning and over time can cause to much tention on the belt, if this the case when you have the steering at full lock it should squeal the loudest.

Aug 29, 2010 | 1999 Audi A6

2 Answers

Show me diagram of altenator belt for Audi A4 2005 1.9TDI


See picture below:

433562a.jpg CS = Crankshaft
F = Fan pulley
Gen = Alternator
T = Tensioner
AC = Air Conditioning
PAS = Power Assisted Steering
WP = Water Pump

Aug 10, 2010 | 2004 Audi A4

1 Answer

1996 Audi A4. On a very cold morning the power steering fluid overflows from the resevoir.


Check up the hydraulic power steering pump.
See picture below for 1.6, 1.8 liters Audi (4 cyl.) engines:
bb7166b.png
If you find leaks and noise when runing, the hydraulic vane type pump is damaged. The pump **** air inside and mix air with oil resulting foam. Therefore fluid volume inside steering instalation rises. Then pressure overflows oil from the reservoir. You need repair or replace hydraulic vane type steering pump.

Dec 30, 2009 | 1996 Audi A4

1 Answer

Support Bracket power steering AUDI 1998 2.8


Any comparable car should work. Your car is a 98, so you would have to stick with Audi/VW cars that have the 30v V6 (98-01.5). The 97 and earlier years used an older 12v V6 and those aren't compatible. It's unlikely that the 1.8T models would work either. You'd have to look for A4, A6, and Passat cars in the model range I mentioned, and you may find that if you have a quattro model, your replacement would have to come from a quattro (Audi) or 4motion (VW) car as well. Try to find a donor car with your same drivetrain (30v V6, auto/stick - whichever you have, and 2wd/4wd, whichever you have).

To tell at a glance which engine is which, the 30v has black covers on the valve covers that say "5V" (for five valves per cylinder). The older 12v cars I believe actually say "12v" on them.

Oct 22, 2008 | 1998 Audi A4

Not finding what you are looking for?
1990 Audi Quattro Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

yadayada
yadayada

Level 3 Expert

77169 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...