Question about 2000 Daewoo Lanos

1 Answer

Cannot find clutch fluid reservoir

Found all clutch fluid had leaked out while car was parked

Posted by on

Ad

1 Answer

Then you need to replace the entire slave
cylinder assy

Posted on Dec 10, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where to check clutch fluid level on 2004 mini


the clutch fluid reservoir is at the clutch master cylinder or is an extension of the brake master cylinder
look for a hose from the clutch master cylinder to the brake master cylinder reservoir

Dec 28, 2015 | 2004 Mini Cooper

1 Answer

My clutch has very little pressure can still shift it through gears when parked. The day it happened brake fluid leaked out


The clutch must be hydraulic on your car, so it needs service. Likely the clutch master cylinder is leaking, but if so it would be good idea to replace the slave cylinder also and maybe any rubber hose.

May 01, 2015 | Cars & Trucks

1 Answer

Clutch on 1994 Ford laser not working. Car has been sitting in garage for 12 months. What do I need to look for?


Does the car have a cable clutch or hydraulic? If cable, there will be a rather hefty cable leading from the firewall (engine side) to the bell housing. If hydraulic, there will be a second fluid reservoir next to the brake fluid reservoir, engine compartment.
Hydraulic clutch: check for fluid level. If low, check for fluid leaks at the servo cylinder, that is the cylinder that operates the release fork on the bell housing, check for fluid leaks from the main cylinder. If it leaks, it will leak inside the car where the clutch pedal rod connects to the main cylinder. Any leaks you find on the main or servo can be repaired with a kit from your spares dealer.
If cable clutch - Check your pedal. If it is low, the cable can be adjusted to take up the slack. On older vehicles, I have found that the firewall itself sometimes corrodes if the cable is anywhere near the battery, and then adjustment does not help. The firewall has to be reinforced first.
If the clutch pedal feels good, have someone work the pedal while you have a look underneath at the release lever (or in the engine compartment if front wheel drive). See if it works well.
As a last resort, the friction plate or pressure plate could be worn, and this will mean removing the gearbox if your car is rear wheel drive. On most front wheel drive cars the clutch / pressure plate can be replaced while the gearbox is in place, a 45 minute job.

Apr 03, 2015 | Ford Laser Cars & Trucks

1 Answer

Clutch fluid reservoir on 2005 Kia Sportage where is it located


In the brake fluid reservoir. Both are the same. No clutch pedal, replace the slave or master. I would replace both.

Dec 23, 2014 | Kia Cars & Trucks

1 Answer

Woke up found my jaguar 2002 X type (petrol) clutch pedal on floor. No signs of leakage of fluid. After pumping clutch up and down several times, clutch returns. A few mins after no clutch.


sounds like the concentric clutch slave cylinder is faulty/leaking, is there any sign of fluid loss from the resovoir, it uses the brake resovoir for its fluid supply, the leaked fluid is probably in the flywheel houslng, big job to change. front subframe has to be removed, if its a 2.5 or 3.0ltr transfer box also.

Mar 07, 2014 | 2002 Jaguar X-Type

2 Answers

1994 Toyota Camry clutch goes to the floor and stays there what would be the problem for that, and is there an easy fix


Sounds like the clutch slave might be the issue. You should be able to find it on the front of the transmission. Peal back the rubber boot and see if brake fluid drips out. If there is fluid behind the boot than it is leaking. You can also look up under the dash to see it the clutch master is leaking. It will leave a brake fluid trail from where the metal rod goes in. If either of those are leaking than your clutch fluid reservoir is likely empty. You can find it under the hood just to the drivers side of the brake fluid reservoir. After you have replaced the leaking parts fill the reservoir with new brake fluid and bleed the system. Make sure you keep the reservoir full while you are bleeding. You should be back in business when you are done!

Aug 07, 2012 | 1994 Toyota Camry

2 Answers

1994 Honda Accord clutch is on the floor


if it,s hydrolic look to put in fluid.

Feb 14, 2012 | 1994 Honda Accord

1 Answer

Clutch pedal has no pressure and goes straight to the floor when pressed. clutch disk is in good condition. parked the car the night before was working perfect. next morning no pressure and out of fluid....


Pump the clutch pedal and then check for leaks again, including under the dash where the rod from the pedal goes into the clutch master cylinder. Once you find the leak, replace what's leaking and bleed the system to restore the pressure (bleeds from the slave unit, just like bleeding brakes)

May 30, 2011 | 1996 Honda Civic

Not finding what you are looking for?
2000 Daewoo Lanos Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8557 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...