Question about 2000 Mitsubishi Galant

1 Answer

My car recently had work done to the body. When I got my car back, the radop didn't work... all it said was code. I put the wrong code in three times and now it says "off". I have the right code now... what do I do?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Have you tried un-hooking the battery cables for a few mins? or un-plugging the radio from the back of it.. this is the anti-theft mode and will need to be reset..

Posted on Jan 13, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2002 Chevy Impala, my gas gauge was acting all screwy so I purchased a new fuel pump. I paid a "mechanic" to put the new pump in, well he didn't know that you could go through the...

you can put the pipes on the wrong way but the pressure would popped something some were as it is not a pressured line its just a return line. also it would back feed as there is a none return on the intake line. there were test's done on a few common makes of cars just to see what would happen if this was done. and it turn's out on a old engine there was no problems engine would run but over time the engine would fail as the pump was sucking instead of pumping, now it was a different story for egr engines as it would pump fuel out of the exhaust engine would run but it was ruff.and as the egr would get to temp it would catch fire. so on injection engines it was made clear witch way the fuel lines are some models have a 8mm line for the fuel line to pump and a 10mm line on the return. but as the pipes get older they stretch and can be mistaken so you would need to look to see witch line the filter is on to pump out, now this was ok doing it this way but to save money in making the car they used unfit parts that fit other cars and other models. so now the pump out are the same size and a part of the pipe goes to a joint where it changes from 10mm down to 8mm intake line. so would check to see witch line is on what from the pump.

Sep 29, 2013 | Cars & Trucks

3 Answers

Put wrong code in renault car radio now got error message . How do i clear this message to put correct code in ?

If you take the earth lead off the car battery and leave for about 2 0minits then reconect the battery it should reset the radio so that you
can put in the right code.I hope this was helpful and done the trick.

Nov 19, 2012 | 2004 Renault Megane 1.6

1 Answer

Changed head gasket and now wont start at all. When i go to start it back fires out of the throtle body. Is this my timing?

Sure sounds like your timing, or it can do this if you didn't properly adjust the valves when putting the head back on.

Nov 10, 2012 | 2001 Pontiac Sunfire

1 Answer

Transmission will not shift into reverse

Sounds like the shop didn't do their job right. Call them and take it back if you paid to have it rebuilt. It should not be your problem to solve it. Work should be guaranteed, and if it isn't, you should take matter up in civil court.

Aug 29, 2012 | 1993 Dodge Dakota

1 Answer

A/C problem

probably the wire to the compressor was disconnected

May 23, 2017 | 1991 Subaru Loyale

1 Answer

VW Golf Mk4 1.4 16V AHW, backfires when cold. There were three broken wires, one goes to the EGR, one to the throttle body and one to the mass air flow. New throttle body, Coil pack and wires tested....

Aparently, a "full diagnostic" has NOT been done. If this statement were true, you would have found the cause of your problem.

With that said, backfiring is usually caused by damaged/leaking exhaust valves. Have you performed a compression test on this engine?

If the computer is "getting the wrong reading of the air/fuel mixture", then you should be getting oxygen sensor and/or fuel trim codes.

The coolant temp sensor does not cause the computer to get the wrong reading of the air/fuel mixture, it causes the computer to get the wrong reading of the engine coolant temperature. Although this will affect how much fuel the computer gives the engine, it does not cause it to get wrong readings of the mixture.

Just so you know, "diagnostics" consist of a WHOLE LOT more than hooking up a code reader and pulling codes from the engine computer.
People think that an automotive repair technician simply plugs in the "magic box" and replaces all the parts the "computer" tells him to replace...I WISH it were that simple!

Mar 18, 2012 | Volkswagen Golf Cars & Trucks

1 Answer

I have a 2001 Kia Sophia. This car has a manual transmission. Just recently I had a couple things done to the car (the cv joints in the front were recently replaced and the KIA dealership in my town put in...

Cars are made to last about 10 years, yours is at that age so things will be going wrong more frequently with it. The recent repairs you mentioned to me have nothing to do with the current complaints, which seem like a fuel supply or injector issue. So take it to someone who is familiar with Kia repairs.

Jun 22, 2011 | 2000 Kia Sephia

1 Answer

My radio in my 1994 540i bmw is off beacuse i didn't put the code in soon enough, what do i do?

Is the problem that you did not put in the code soon enough, or that you tried three wrong codes and locked it out? I don't think there is a time limit, but all of us have punched in wrong codes and locked out our radios before. If the display says WAIT, you tried three wrong codes.
If it is locked out, you have to drive for an hour with the radio turned on before it will let you try again. If you disconnect the battery during that hour, you just reset the 1-hour timer back to zero so you have to wait longer.

Jul 25, 2010 | 1994 BMW 3 Series

1 Answer

Recently had a computer put in and programmed at dealership.nOW THE AC OR HEATER WANT WORK can short compressor out it come infomation on this

aye they programed the bcm wrong with the wrong codes, its a one time Charley program ROM chip.
take it back to the dealer and &^%#@%$^&

Oct 22, 2009 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Mitsubishi Galant Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides