Question about Nissan Altima

Open Question

Location of number 1 cylinder nissan altima 2.5l

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 2003 Nissan Altima?

Where is the sensor placed on the car?

Posted on Oct 07, 2008

jschoon77
  • 55 Answers

SOURCE: Location of oil filter on Nissan Altima 2005

The oil filter is located behind the right (passenger) inner fender cover. It is right next to the crankshaft pulley at the bottom of the front of the engine facing toward the right front wheel. I do not have a picture at this time.

Hope this is helpful!


Nissan Scope Technician- 10+ years experience in Nissan dealership.

Posted on Nov 04, 2008

  • 15 Answers

SOURCE: 1995 Nissan Altima Heater contorl valve location

HELLO THE HEATER CONTROL VALVE IS LOCATED AT THE REAR CENTER OF THE ENGINE COMPARTMENT BY THE FIREWALL

Posted on Mar 02, 2009

  • 383 Answers

SOURCE: replacement of a head gasket on 2.5 liter nissan altima 2002

frajogag: First off, be aware that these bolts are "torque to yield" bolts (streach bolts). What this means is that instead of torqueing the head bolts to a specific torque specification, they are torqued down to a set spec and then tightened by rotating the bolts a certain angle, like 90 degrees. and all of them are turned the same amount.
This means that the shanks of the bolts must be checked to make sure they are not too thin (or the bolt has already stretched beyond limits and is prone to snap if used)
Here is how you check the bolts. Measure the bolt using a micrometer, at the base, or within the first 13mm from the end where it threads in. Then go to about 10mm before the threads end heading toward the top of the bolt. There should not be more than a 0.23mm (.0091 inch) or less difference or the bolt should be discarded.
Torque the bolts down to 98.1Nm ( 72.ft lb)
Looking at the head from the side, so you are looking at the full length from side to side, I will number the head bolts in this fashion.
#1 & 2 are directly in front of you and in the center of the cylinder head crossing it width wise.
#3&4 are to the left of #1&2, / #5&6 are to the right of #1&2
#7&8 are to the left of #3&4 / #9$10 are to the right of #5&6
Now, you have the sequence.
After the initial pull, back off all the bolts in the same sequence and then retorque them to 36 Nm ( 28 ft lb)
Using a torque angle wrench or having the ability to accurately judge turning angles. Rotate (clockwise) to a 75 degree angle. do this to all the bolts using the sequence I had provided.
Rotate the bolts (clockwise) 75 degrees again on all bolts in the same sequence. The proceedure is complete!

Posted on Apr 23, 2009

  • 1596 Answers

SOURCE: 1997 Nissan Altima Cylinder 1 misfire detected.

This Sounds Like a COIL PACK Problem

Posted on Aug 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is my fuel filter located 2002 Nissan Altima 3.5se.. I looked in the tank and didn't find an inline filter either.


2002 Nissan/Datsun Altima 3.5L SFI DOHC 6cyl

The Fuel Filter is located: Under hood, driver side, rear engine area, passenger side of master cylinder, mounted in fuel line

Dec 07, 2015 | 2002 Nissan Altima 3.5 SE

1 Answer

Where is the #4 cylinder located on a 2007 nissan altima 4 cylinder


Cylinder number 4, on a 4 cylinder engine, is the cylinder farthest away from the crankshaft and drive pulleys,running the alternator,AC, and power steering.

Jul 07, 2014 | 2003 Nissan Altima

1 Answer

2005 Nissan Altima 2.5L - where is the heated oxygen sensor number 2 located


Oxygen sensors are mounted either side of the catalytic converter. Number 1 is mounted before the cat in the down pipe and the Number 2 is in the exhaust pipe just after the cat, think the number 2 is the downstream.

Jan 05, 2014 | 2005 Nissan Altima

1 Answer

Problem with 2006 Nissan Altima 2006 nissan


Coil packs are located on top of spark plugs, one for each cylinder.

Aug 25, 2013 | 2006 Nissan Altima

1 Answer

P0725 2005 Nissan Altima 4 cylinder engine speed input circuit reading. Please show the location of the part for self servicing. Thank you


how long does a recall last. Ive only had this car for 1 1/2 years due to my other car was totaled. Can it still be considered in the recall?

Apr 29, 2012 | 2005 Nissan Altima

2 Answers

Where is fuel filter located in Nissan altima 2002, how can i replace it.


the fuel filter is located in the tank and is non servicable you have to replace the entire fuel assembly in tank its 214.99 at autozone that is the price for 4 cylinder model the 6 cylinder model is not servicable either but may cost a diffrect amout

May 05, 2011 | 2002 Nissan Altima

1 Answer

Wereplaced head gasket on a 2002 nissan altima and now a have a poo11 code . i have rechecked timing and cleaned v v t


TROUBLESHOOTING P0011
The pcm has determined that the voltage signal from camshaft "A" position sensor in bank 1 indicates inadequate perforemce or a timing over advanced condition. (Bank 1 identifies the location of cylinder #1, while bank 2 identifies the cylinders on the opposite bank)

hopefully this helps a little

Dec 02, 2010 | 2003 Nissan Altima

1 Answer

Did not change my spark plug wires one at a time need a diagram plz :( ......for a nissan altima ,93


For the 1993 Nissan Altima 2.4L DOHC in-Line 4-Cylinder:

Firing Order:
1 - 3 - 4 - 2
Cylinders:
_____back______
|...1....2....3....4...|
_____front_______

Distributor:
3.........1
......o.....
4.........2

Aug 12, 2010 | Nissan Altima Cars & Trucks

1 Answer

Need firing order on a 2001 nissan altima gxe


For the 2001 Nissan Altima GXE 2.4L DOHC In-Line 4-Cylinder:

Firing Order:
1-3-4-2

Cylinders:
........(back)
1......2.......3.......4
........(front)

Distributor:
.(back)
3.......1
....O....
4.......2
(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!



Apr 02, 2010 | 2001 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

271 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...