Question about Nissan Xterra
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Try spraying penetrating lubricant or graphite into it, wiggle and try. Spray inside and press the button and spray between the button and the housing. If this dosen't work you can try looking into the seat belt with a flash light and see if you can see anything moving compare with a belt that works properly. If not successful you will have to replace the seat belt assembly as they cannot be taken apart as they are a safety item and are replaced as an assembly.
Posted on Apr 02, 2009
I recommend 60-90K Cost depends on the dealerships labor but usually when your doing a timing belt, radiator hoses and fan belts are removed and should be replaced while your in there. Its about 3hrs, more if other things need to be replaced while in there. So you looking at $300+ for labor only
Posted on Apr 27, 2009
first of all you don't have to loosen the pulley,this will no solve the problem,well you already loosen the adjuster,good,bot thing you have not done i will tell you now,on the power steering pump where the belt pass there is also a bolt that hold it ,you must loosen that also,then after you will see the pump moving on the two position that means you will see the belt loosen on 1 position an d the position it will tight the belt,try that man.............
Posted on Aug 23, 2009
SOURCE: adjusting headlights
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
Posted on Nov 04, 2009
Tips for a great answer:
Dec 03, 2015 | Nissan Cars & Trucks
Mar 05, 2011 | 2003 Nissan Xterra
Nov 21, 2010 | 2000 Nissan Xterra
Nov 14, 2010 | 2000 Nissan Xterra
Aug 03, 2010 | 2001 Nissan Xterra
May 17, 2010 | 2002 Nissan Xterra
Nov 24, 2009 | 2000 Nissan Xterra
Apr 08, 2009 | 2003 Nissan Xterra
Mar 24, 2009 | 2002 Nissan Xterra
106 people viewed this question
Usually answered in minutes!