Question about 2003 Chevrolet Silverado 2500HD

1 Answer

My 2003 chevy silveraco wont start dash lights flicker and says truck is 2 gear is it the neutral safety switch

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 12,650 Answers

Look under truck at transmission selector cable if it disconnected [because of rust ] or damaged --the lever may be in park but the selector at transmission is in gear wont start big problem with gm trucks burbs replaced may friends 05 silverado and had to do same for my 08 yukon

Posted on Dec 10, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Tech jk
  • 102 Answers

SOURCE: need to locate the neutral safety switch on a 2005 chevy equinox

The park / neutral switch is on top of the transmission. It has a 2 wire connector. the wire colors are pink and orange/black. Tech jk

Posted on Dec 06, 2008

  • 180 Answers

SOURCE: Chevy Tahoe stuck in neutral

Transfer case

Posted on Jan 07, 2009

c17hydro
  • 2984 Answers

SOURCE: replace the neutral safety switch on my 1999 Chevy Silverado

If it looks like this:





It is mounted on the side of the tranny. It also says a special to remove it.991cb34.jpg

Posted on Apr 01, 2009

  • 7 Answers

SOURCE: How to replace a neutral safety switch

The switch should be on the drivers side of the tranny where the shift linkage attaches to it. You will need a 13mm socket and a 15 mm socket . You will also need a heat gun , the electrical plug is glued into the connectors and must be warmed up to be removed . these rarly go bad but they do get out of adjustment / or when removing pan techs are ad to bend the shift cable bracket and get them out of adjustment . Loosen the two 13mm bolts and move it slightly in both directions and see if this fixs you problem before you change it out.

Posted on Apr 01, 2009

wracefans24
  • 1985 Answers

SOURCE: ocasionally engine (2004 malibu classic)wont turn

have you checked or replaced the starter relay?

Posted on Dec 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is this a neutral safety switch problem?


A bad neutral safety switch would not allow you to start the car at all. This sounds like a shift linkage problem . good luck

May 22, 2014 | 2003 Suzuki Grand Vitara

1 Answer

2001 jgc limited has good battery power turn key to start and dash lights all go out engine wont start headlights dont even dim had the yellow fuse cradle out it had 2 10 amp fuses in it after that this...


A mechanic would check for power at the starter and trace back to the key switch. There is a neutral safety switch to keep you from starting the engine in gear that could have failed.

Dec 11, 2012 | 2001 Jeep Grand Cherokee

1 Answer

97 chevy s10 wont start


Then the problem is likely the ignition switch, or the neutral safety switch. Try jamming it into park a couple of times to see if it helps. If it does, you will need to change the neutral safety. If it doesnt, probably going to need an ignition switch. Those trucks, jimmys, and blazers are famous for ignition switch problems.

Feb 06, 2012 | Cars & Trucks

1 Answer

Ingnition problems for 1999 chevy silverado wont start wont crack over when you turn the key on but you have dash lights when your trying this


maybe not strong enough battery or try shifter moving while you try to start.. may be neutral safety switch so try jiggling the shifter in park and neutral. also the key may need to be cleaned the fobs get dirty where it wont read it, got a spare try it....

Dec 10, 2010 | 1999 Chevrolet K1500

1 Answer

Starting


Sounds like the safety neutral switch may be defective. If it gets out of adjustment or fails completely, the car will not start. Sorry, I would have to look at it to know, but some are located on the transmission and some are at the gear shift. Have the switch checked to insure the right voltage is getting to it. If the switch thinks it's in a gear other than park or neutral it will not start or turn over.

Jan 27, 2010 | 2003 Jeep Grand Cherokee

1 Answer

I just rebuilt my transmission on my 2003 chevy impala 3.4L, after reinstalling the motor and trans it will not start and the dashboard indication for the gears do not match the shifter position!?!?!


Sounds like you got the transmission linkage hooked up incorrectly. If you didn't get it right, the neutral safety switch(the one that lets you start the car when in neutral or park only) will prevent the car from starting.

Oct 16, 2009 | 2003 Chevrolet Impala

2 Answers

My 1997 monte carlo wont start


Most likely a bad starter.
Less likely a wiring problem.

Apr 26, 2009 | 1997 Chevrolet Monte Carlo

1 Answer

My car wont move out of park and the braks lights arent working.


my ford taurus did this to me too.... your car wont move out of park because it might be the neutral safety switch because your brake light connector piece might have come undone...
now first off the brakes (my switch was above my brake pedal) and just make sure its clipped in and then your neutral safety switch should go of and you can put it into gear.
if you cant find the brake thing to see if its unplugged just turn your key slightly on before all your dash lights come on and put the car into neutral and then start your car and you can put it into gear.

Mar 19, 2009 | 1995 Ford Taurus

4 Answers

1997 chevy blazer wont start


same just happend 2 me,was told it was the neutral safety switch -but didnt start in neutral-took 2 shop 400 later it was the ignition switch runs great again hope i helped

Jan 06, 2009 | 1997 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

297 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...