Question about Toyota Pickup

Open Question

What bucket seats will fix and bolt right up for my 1985 toyota standard pickup ?

What other models of truck seats or SUV seats will fix and bolt right-up to my 1985 Toyota standard pickup truck 2wd ?

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 72 Answers

SOURCE: gas problem 1989 toyota pickup

check fuse and relay for fuel pump

Posted on Apr 16, 2009

duane_wong
  • 6826 Answers

SOURCE: The 1984 Toyota 4x4 pickup truck will not idle

On a 1984 Toyota I would look for a screw to set the low speed idle on the carburetor, if so equipped. Turn the screw until the RPMs are reasonable.

If you can maintain a smooth idle by adjusting the screw your home free.

If not, then there could be other problems with your vehicle's emission, ignition, comprression, or fuel.

Posted on Jul 07, 2010

syncrswim
  • 21 Answers

SOURCE: 1992 22re standard transmission toyota pickup

It sounds like the cluster is gone bad if everything is not working. Usually, if just the speedometer isn't working then it's the speed sensor on the transmission that has gone bad. But I think you have a cluster that has just died. Check on EBAY for a used cluster and ask them to roll the mileage to what is on your vehicle now.

Posted on Nov 25, 2010

Testimonial: "WELL, I'LL CHECK IT OUT. THANKS FOR THE INFO, IT MAY HAVE SAVED MONEY I DON'T HAVE"

  • 140 Answers

SOURCE: 1994 standard transmission Toyota pickup truck

There is a cable that runs from the back of the transmission to back of dash.Undo cable at trans end.Spin the inner wire with cordless drill,speedo should move,if not replace speedo cable.Some cables u can pull inside wire from trans end,so don't have to mess with dash

Posted on Jan 24, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fix air conditioner in 1985 toyota hiace


My 1986 would leak. The HP and LP hose coonections to the compressor where lose. Tightened up and stopped most leaking. I added leak detector and found the LP fill connection Schrader valve seat was bad. Put in a new Schrader valve (bought off ebay for cheap- but a couple of extras) and all leaks stopped. Night not be compressor itself. Have a pro check the system for leaks.

Jan 29, 2014 | 1985 Toyota Pickup

1 Answer

How to remove rails from Scion bucket seat? Looks like all rivets? Are there bolts somewhere?


Keep the rails and fab new mounting holes , and install risers if needed.

Jan 04, 2014 | Scion Cars & Trucks

2 Answers

How can I convert drivers seat in my car to a bench seat


I'm having the same problem after a week in this car! I'm going back to the dealer to see if they have any suggestions. My other thought was to go to an upholstery shop to see if they can fabricate a cushion to make more of a "flat" seat to eliminate the bucket.

Mar 30, 2012 | 2012 Chevrolet Equinox LS 4dr SUV 2.4L...

1 Answer

97 Nissan pickup standard cab XE, I am looking to convert from bench seat to bucket seats. Does anyone know of an exact fit, bolt hole match up, no drilling? Will seats from other Nissans fit ie a...


The bucket seats from the 1995 Nissan Pathfinder should be an exact fit. The bolt holes and bolts should be the exact same and have the exact same hole locations.

Aug 22, 2011 | 1997 Nissan Pickup

1 Answer

After a rebuild to this 1985 toyota 4x4, and after fixing all the air leaks,etc., the truck has absolutly no power....please help


the 1985 toyota pickup that has no power after the engine was rebuilt sounds like the timing is ******** was the distributor installed correctly

Jul 11, 2011 | 1985 Toyota Pickup

1 Answer

I have a 1985 toyota pickup standard cab, 22r, i have no idea how to wire up the radio, and ive tried, and now the horn or emergency lights wont work i wanna wire up the radio, and fix those two other...


Real Simple

You already have no ideas

That is because you have no guide

Get a wiring diagrams, of just the circuits you need

A local repair shop can print that from ALLDATA
Mitchell,Motor etc

Jun 12, 2011 | 1985 Toyota Pickup

1 Answer

I have a 1985 toyota pickup 2wd. the passenger rear end brakes locked or freezed and dont know how to fix it


Rear wheel cylinder by that are often bind up from corrosion.
But by turning the adjusters down, through the port in the back of the backing plate, you should be able to get the drum off. Then you loose then brake line, remove the shoes, take the cylinder retaining bolt out, and the cylinder should come right out.
When you install the new one, fill it with brake fluid first, and there will be less air to bleed out.
If you want to be cheap, you can probably leave the old cylinder in, take it apart where it sits, hone it out, and put in new rubber seals, use a lot of brake grease, and you can do it for about $10.

May 06, 2011 | 1985 Toyota Pickup

1 Answer

I need to repair the driver's bucket seat. It has


you need to take the seat cover off i had that happen to me in my van and all i had to do was replace the broken bolt give this website a try you should be able to find one at a good salvage yard www.junkyarddog.com also give these websites a try for help www.alldatadiy.com and www.autozone.comalso like to give you this information if you every have any hard to find GM-parts its Schram auto & truck parts 1-800-292-1032 and they website is www.schramauto.com wish you the best of luck Michigan Man.

Mar 05, 2010 | 1985 GMC Suburban

5 Answers

Need to change engines


If you have a 22r carbed then all 22r carbed engines from 1981-1995 will interchange. You may need to use sensor out of your old engine however. The 20r,22r,22re,22ret all have the same mounts and tranny bolt patterns. how ever there are lot of differences. you can swap from a 22r to a 22re but you must also swap the entire vehical wiring harness to do it right. if you have a 3.0L i would keep the same engine. some people have swap to the tacoma 3.6L but that is a expensive swap not exsactly bolt on so to say. If you have a 22re then stay with the 1986-1987 22re because the newer 22re use different computers, electronics ,sensors and more.. Same story with the 22ret. I hoped this helped.

Mar 26, 2009 | 1987 Toyota Pickup

1 Answer

Power steering in 85 toyota pickup


it is not very hard long as u buy a kit from the wreckers of the same model car and engine it will all bolt up make sure u ask for all the bolts as well make sure u have plenty of time up yor sleve

good luck

Dec 21, 2008 | 1985 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...